Search results for " couple"
showing 10 items of 374 documents
MTA HP Repair stimulates in vitro an homogeneous calcium phosphate phase coating deposition
2019
Background To study the mineralization capacity in vitro of the bioceramic endodontic material MTA HP Repair. Material and methods Bioactivity evaluation in vitro was carried out, by soaking processed cement disk in simulated body fluid (SBF) during 168 h. The cement surface was studied by Fourier transform infrared spectroscopy (FT-IR), field emission gun scanning electron microscopy (FEG-SEM) and energy dispersive X-ray analysis (EDX). Release to the SBF media of ionic degradation products was monitored using inductively coupled plasma atomic emission spectroscopy (ICP-AES). Results FT-IR showed increasing formation of phosphate phase bands at 1097, 960, 607 and 570 cm-1 with prolonged SB…
Validated fast procedure for trace element determination in basil powder
2011
Abstract An inductively coupled plasma optical emission spectroscopic (ICP-OES) method has been developed and fully validated for trace element determination in basil samples. The method involves the previous sample digestion, under pressure, with a mixture of HNO 3 , HCl and H 2 O 2 inside a microwave oven, 42 elements were studied and 33 elements (Al, As, Ba, Ca, Cr, Co, Cu, Fe, Pb, Li, Mg, Mn, Mo, Ni, K, Se, Na, Sr, Tl, Ti, V, Zn, Sc, Y, La, Ce, Nd, Tb, Ho, Er, Tm, Yb, Lu) were determined quantitatively in basil leaves obtained from Morocco and Spain. The method provided recovery percentages from 89% to 113% for spiked concentrations at mg kg −1 and μg kg −1 . Accurate results were found…
Determination of mineral and trace element concentrations in pine needles by ICP-OES: evaluation of different sample pre-treatment methods
2008
In the present study, the determination of mineral and trace elements (Al, B, Ca, Cu, Fe, K, Mg, Mn, Na, P and Zn) from pine needles using three sample pre-treatment methods followed by inductively coupled plasma optical emission spectrometry, was examined. Sample pre-treatment methods tested were microwave digestion, ultrasound-assisted digestion and dry ashing. The new ultrasound-assisted digestion method was optimised by the analysis of the standard reference material (SRM) 1575a (pine needles) sample. The speed of dry ashing method was significantly increased by ultrasound dissolution after ashing. All the ICP-OES measurements were performed in robust plasma conditions which were tested…
Direct determination of minerals in human diets by infrared spectroscopy and X-ray fluorescence
2014
The use of near and mid infrared spectroscopy and X-ray fluorescence (XRF) to determine the concentration of mineral elements in Spanish human diets was investigated. Thirty-five commercial baby foods, 6 children fast food menus and 13 university canteen menu samples were analysed by infrared and XRF spectroscopy and spectra evaluated by using reference data obtained by inductively coupled plasma optical emission spectroscopy (ICP-OES). Models for calcium, potassium, iron, magnesium, sodium and zinc determination were built and validated. Spectra were pre-treated by using different pre-processing algorithms (multiplicative scatter correction, standard normal variation, first derivate, ortho…
Aggregation versus Biological Activity in Gold(I) Complexes. An Unexplored Concept
2021
The aggregation process of a series of mono- and dinuclear gold(I) complexes containing a 4-ethynylaniline ligand and a phosphane at the second coordination position (PR3-Au-C≡CC6H4-NH2, complexes 1-5, and (diphos)(Au-C≡CC6H4-NH2)2, complexes 6-8), whose biological activity was previously studied by us, has been carefully analyzed through absorption, emission, and NMR spectroscopy, together with dynamic light scattering and small-angle X-ray scattering. These experiments allow us to retrieve information about how the compounds enter the cells. It was observed that all compounds present aggregation in fresh solutions, before biological treatment, and thus they must be entering the cells as a…
Effect of operation conditions of the drop-on-demand aerosol generator on aerosol characteristics: Pseudo-cinematographic and plasma mass spectrometr…
2014
Abstract The recently presented drop-on-demand (DOD) aerosol generator overcomes some of the drawbacks of pneumatic nebulization, as its aerosol is no longer generated by gas–liquid interaction. In the current study, an advanced imaging technique is presented, based on a CCD camera equipped with magnifying telecentric optics to allow for fast, automated and precise aerosol characterization as well as fundamental studies on the droplet generation processes by means of pseudo-cinematography. The DOD aerosol generator is thoroughly characterized regarding its droplet size distribution, which shows few distinct populations rather than a continuous distribution. Other important figures, such as …
The importance of incorporating a waste detoxification step in analytical methodologies
2015
The introduction of a waste detoxification step in the analytical process was highlighted using, as example, the determination of copper in pesticide formulations using electrogravimetry, flame atomic absorption spectroscopy and inductively coupled plasma optical emission spectroscopy. This quantitative study showed the improvement of the previously mentioned analytical methods, from a green perspective, after addition of electrodeposition or neutralization steps to the analytical process. Based on this, the application of the eco-scale and the Green Certificate to the evaluation of these methodologies allows the method to be moved from the B and C classes to the A class.
Recent advances in on-line solid-phase pre-concentration for inductively-coupled plasma techniques for determination of mineral elements
2012
Abstract We provide a critical survey on recent progress in on-line solid-phase pre-concentration for inductively-coupled plasma (ICP)-based techniques for trace-level determination of metals. We highlight some of the useful solid-phase materials suitable for on-line separation and enrichment prior to ICP determination. We discuss different applications of the methods developed along with their analytical figures of merit. Finally, we sketch out future prospects in this field.
Determination of trace elements in gluten-free food for celiac people by ICP-MS
2014
Abstract This paper is the first analytical approach to the study of twenty heavy metals in the gluten-free foods for celiac people. Only the ICP-MS technique was used. One of the advantages about the use of ICP-MS for this characterization is the high sensitivity that improved the limits of quantification levels for some elements that are present at low quantities in some samples. The concentration values of As, Ba, Cd, Co, Cr, Cu, Fe, Hg, Mn, Mo, Ni, Pb, Sb, Se, Sn, V and Zn in seventeen gluten-free food samples are reported. The highest arsenic and molybdenum levels were measured in Rice noodle from China (0.088 and 0.47 mg kg − 1 , respectively). The highest concentrations of some metal…
"Sweet Chemistry": a Green Way for Obtaining Selenium Nanoparticles Active against Cancer Cells
2017
We present an environment friendly synthesis of selenium nanoparticles and the study of their cytotoxic activity against uterine sarcoma cancer and fibroblasts cells. Amorphous selenium (a-SeNPs) and trigonal selenium (t-SeNPs) were synthesized using D-fructose as the reducing agent and characterized by high-resolution transmission electron microscopy (HRTEM), energy-dispersive X-ray spectroscopy (EDX), powder X-ray diffraction analysis (XRD), inductively coupled plasma optical emission spectrometry (ICP OES), dynamic light scattering (DLS) to obtain zeta potential values and cyclic voltammetry (CV). Particularly, a-SeNPs presented high toxicity toward the resistant cancer cell line MES-SA/…