Search results for " fractionation"

Thallium geochemistry in the metamorphic Lengenbach sulfide deposit, Switzerland: Thallium-isotope fractionation in a sulfide melt

2014

The Lengenbach (Switzerland) Pb-As-Tl-Zn deposit was formed from a sulfide melt at about 500 °C during Alpine metamorphism, but details on its formation and especially the source of the metals are still under debate. In this study we present two sample sets to address these questions: 1. MC-ICP-MS analyses of thallium isotopes in sulfides, sulfosalts, and melt inclusions from the Alpine metamorphic Lengenbach deposit in the Binn Valley of Switzerland, the non-metamorphic Wiesloch Mississippi Valley-type deposit in Southern Germany, and the Cu- and As-rich mineralization at Pizzo Cervandone about 2 km SW of the Lengenbach deposit, which has been discussed as potential source of the Lengenbac…

Continuous polymer fractionation of polysaccharides using highly substituted trimethylsilylcellulose

1998

Trimethylsilylcellulose (TMSC) was prepared from commercial cellulose with a mixture of hexamethyldisilazane and chlorotrimethylsilane in the solvent system N,N-dimethylacetamide/lithium chloride. The soluble, highly silylated polymer (degree of substitution, DS 2.9) had a molar mass M, of 500 kg/mol and a molecular non-uniformity U = (M w /M n )- 1 of 2.9. In order to investigate the principal suitability of a continuous polymer fractionation for polysaccharides like cellulose derivatives and to obtain TMSC with different molecular weights and lower non-uniformity TMSC was fractionated by means of CPF (Continuous Polymer Fractionation), well-established in the field of synthetic polymers. …

The Efficiency of Polymer Fractionation at Lower Critical Solution Temperatures

1978

The efficiency of a single fractionation step (i.e. of the partition of a given polymer sample between the coexisting phases which form when its solution demixes) is governed by the variation of the mass ratio of the individual P-mers with chain length. These dependences have been measured for the system dimethoxymethane/diethylether/ polystyrene which exhibits lower critical solution temperatures by means of the Baker-Williams method and by means of g.p.c. Their comparison with the results of previous investigation on systems showing upper critical solution temperatures reveals no thermodynamic differences in the aptitude of upper and lower critical solution temperatures for fractionation …

Chemical speciation of polycyclic aromatic hydrocarbons in sediments: partitioning and extraction of humic substances.

2010

The primary objective of this study was to examine the chemical speciation of polycyclic aromatic hydrocarbons (PAHs) found in sediments endowed with different characteristics. To achieve this purpose and because the nature of the sediments influences the distribution of PAHs, we have analyzed four different types of sediments. To study the role of organic matter in the sequestration of PAHs, we fractionated humic substances into humic acids and humin–mineral fractions. After their separation and purification, the humic components were examined for their sorptive reactivity by extracting them with organic solvents; these extracts were subsequently subjected to GC/MS analysis. Our results sh…

Branched versus linear polyisoprene: Fractionation and phase behavior

2007

Abstract Branched polyisoprene (PI) was prepared from PI-macromonomers. Linear byproducts of the synthesized polymer were removed by means of inverse spin fractionation, using the solvent cyclohexane (CH) and the precipitant acetone (AC). A well-defined fraction (Mw = 17.5 kg/mol, Mw/Mn = 1.8) of the branched polyisoprene obtained in this manner was used to determine different phase diagrams with branched and/or linear PI in the mixed solvent CH/AC at 25 °C. For comparable molar masses of the polymers the two-phase area is smallest for the branched PI and slightly larger for the linear PI; in the case of the unfractionated original sample of the branched polymer one observes a pronounced pe…

Selenium Partitioning and Stable Isotope Ratios in Urban Topsoils

2011

oxides. Th e δ82/76 Se values of total Se in the topsoils were close to the bulk Earth composition with an average δ82/76 Se value of −0.03 ± SD 0.38‰ suggesting that there was no or little Se isotope fractionation in soil. We attribute the small isotope fractionation to the low bioavailability of Se as a consequence of the presence of Fe oxides (adsorbing the dominating Se(IV) forms strongly), organic matter, and SO 4 2− (prevents biouptake of the Se(IV) forms) in the study soils. Small Se isotope fractionations of −0.59 to −0.35‰ in mainly forest soils and of 0.26 to 0.45‰ in mainly alluvial soils were presumably caused by soil/plant-recycling and Se contamination by river water, respecti…

Holothuria tubulosa Gmelin 1791 (Holothuroidea, Echinodermata) enhances organic matter recycling in Posidonia oceanica meadows

2014

Abstract The role of Holothuria tubulosa in organic matter recycling of Posidonia oceanica detritus was estimated in a laboratory feeding experiment. The individual mean ingestion rate of seagrass detritus by holothurians was evaluated and carbon and nitrogen stable isotopes, carbon and nitrogen content and C:N ratio analyzed in H. tubulosa , P. oceanica detritus and surface sediment. Results showed that H. tubulosa is capable of ingesting from 30% to 100% of the detritus produced by P. oceanica meadows, depending on the holothurian density. Stable isotope analysis provided evidence for the assimilation of seagrass detritus by H. tubulosa as their signatures were compatible with 1 trophic l…

2009

Abstract. Understanding the importance of the different oxidation pathways of sulfur dioxide (SO2) to sulfate is crucial for an interpretation of the climate effects of sulfate aerosols. Sulfur isotope analysis of atmospheric aerosol is a well established tool for identifying sources of sulfur in the atmosphere and assessment of anthropogenic influence. The power of this tool is enhanced by a new ion microprobe technique that permits isotope analysis of individual aerosol particles as small as 0.5 μm diameter. With this new single particle technique, different types of primary and secondary sulfates are first identified based on their chemical composition, and then their individual isotopic…

1995

45 g of poly(acrylic acid) (PAA 500) with a trimodal molar mass distribution (Mw = 500 kg/mol, (Mw/Mn) −1 = 2.33) were fractionated by means of CPF (continuous polymer fractionation) in two steps using 1,4-dioxane as solvent. The counter-current extraction was performed in a glass column (length: 190 cm, diameter: 1.5 cm) filled with a network of wires, introducing the feed 75 cm from its upper end. The distribution of the highest molar mass fraction (Mw = 760 kg/mol) is unimodal and comparatively narrow ((Mw/Mn) −1 = 0.66). Indications exits that fractionation is not only taking place with respect to molar mass but also with respect to tacticity. Mit Hilfe der kontinuierlichen Polymerfrakt…

Maturation of a Key Resource – The Germanium-68/Gallium-68 Generator: Development and New Insights

2011

(68)Ge/(68)Ga radionuclide generators have been investigated for almost fifty years, since the cyclotron-independent availability of positron emitting (68)Ga via the (68)Ge/(68)Ga system had always attracted researches working in basic nuclear chemistry as well as radiopharmaceutical chemistry. However, it took decades and generations of research (and researchers) to finally reach a level of (68)Ge/(68)Ga radionuclide generator designs adequate to the modern requirements of radiometal labelling chemistry. Nevertheless, most of the existing commercial generator systems address aspects of (68)Ge breakthrough and safe synthesis of (68)Ga radiopharmaceuticals by adopting eluate post-processing …