Search results for " graph"
showing 10 items of 1277 documents
Phase Transitions in Spin-Crossover Thin Films Probed by Graphene Transport Measurements
2016
Future multi-functional hybrid devices might combine switchable molecules and 2D material-based devices. Spin-crossover compounds are of particular interest in this context since they exhibit bistability and memory effects at room temperature while responding to numerous external stimuli. Atomically-thin 2D materials such as graphene attract a lot of attention for their fascinating electrical, optical, and mechanical properties, but also for their reliability for room-temperature operations. Here, we demonstrate that thermally-induced spin-state switching of spin-crossover nanoparticle thin films can be monitored through the electrical transport properties of graphene lying underneath the f…
Bottom-up realization and electrical characterization of a graphene-based device.
2016
We propose a bottom-up procedure to fabricate an easy-to-engineer graphene-based device, consisting of a microstrip-like circuit where few-layer graphene nanoplatelets are used to contact two copper electrodes. The graphene nanoplatelets are obtained by the microwave irradiation of intercalated graphite, i.e., an environmentally friendly, fast and low-cost procedure. The contact is created by a bottom-up process, driven by the application of a DC electrical field in the gap between the electrodes, yielding the formation of a graphene carpet. The electrical resistance of the device has been measured as a function of the gap length and device temperature. The possible use of this device as a …
A green method to prepare nanosilica modified graphene oxide to inhibit nanoparticles re-aggregation during melt processing
2017
Abstract A graphene oxide-silica nanohybrid (GOS), self-assembled into a lasagna -like structure, was prepared in water and used as a filler for the melt preparation of polyamide 6 (PA6)-based nanocomposites. For sake of comparison, PA6-based materials were prepared under the same processing conditions by adding GO only or a physical mixture of GO and silica (GO+S). All the materials were characterized from a morphological, spectroscopic, thermal, dynamic-mechanical (DMA) and mechanical point of view. For all the nanocomposites, the interphase was studied either by analyzing loss factor plots coming from DMA measurements and by implementing a novel approach, i.e. combining solvent extractio…
Polystyrene as Graphene Film and 3D Graphene Sponge Precursor
2019
[EN] Polystyrene as a thin film on arbitrary substrates or pellets form defective graphene/graphitic films or powders that can be dispersed in water and organic solvents. The materials were characterized by visible absorption, Raman and X-ray photoelectron spectroscopy, electron and atomic force microscopy, and electrochemistry. Raman spectra of these materials showed the presence of the expected 2D, G, and D peaks at 2750, 1590, and 1350 cm(-1), respectively. The relative intensity of the G versus the D peak was taken as a quantitative indicator of the density of defects in the G layer.
Numerical investigation of the mechanical properties of a novel hybrid polymer composite reinforced with graphene and MXene nanosheets
2020
Abstract This paper presents a numerical investigation of the elastic properties of a novel hybrid polymer composite reinforced with graphene and MXene nanosheets. A finite element computational model was developed to analyze the mechanical properties of a new polymer hybrid composite reinforced with MXene and graphene taking into account the properties of the 2D nanosheets, different aspect ratios, placement options and volume fractions of nanoreinforcements, as well as the interaction effects between the nanofillers and the surrounding polymer matrix. Using the developed numerical model, the influences of the interface layer properties, MXene and graphene aspect ratio, alignment and volum…
Investigation of electron transfer between single plasmon and graphene by dark field spectroscopy
2020
Abstract We investigated the electron transfer time between single plasmonic gold nanoparticles and graphene with our home-build spectral imaging dark-field microscope. The process of electron transfer is supposed to be shuttling of hot electrons on the nanoparticle-graphene interface, resulting in a slight broadening of the scattering spectrum. For detecting the minor spectrum broadening, we firstly characterized our setup systematically and then calibrated its intrinsic error. We found the mechanism of a common but normally neglected setup error, scattering spectrum broadening, which is caused by the bandwidth of the incident light and could exist in most fast dark-field microscopy setups…
Functionalized Calix[8]arenes, Synthesis and Self-assembly on Graphite
2005
With the intention of building hollow tubular structures by self-assembly, we have designed and successfully synthesized a series of calix[8]arene derivatives. Their phenolic units were functionalized in p-position by various groups which are able to interact via hydrogen bonding or π−π stacking. Ethynyl, amide, urea, or imide links were chosen for the covalent attachment of these functional groups, to ensure the adjustment of an optimal distance for their interaction. Two different kinds of nanostructures self-assembled on a highly oriented pyrolytic graphite (HOPG) surface were found by scanning force microscopy: parallel aligned nanorods in which the calixarene molecules are adsorbed ed…
Single-Element Reflective Digital Holographic Microscopy
2021
Digital holographic microscopy (DHM) is a well-known microscopy technique using an interferometric architecture for quantitative phase imaging (QPI) and it has been already implemented utilizing a large number of interferometers. Among them, single-element interferometers are of particular interest due to its simplicity, stability, and low cost. Here, we present an extremely simple common-path interferometric layout based on the use of a single one-dimensional diffraction grating for both illuminating the sample in reflection and generating the digital holograms. The technique, named single-element reflective digital holographic microscopy (SER-DHM), enables QPI and topography analysis of r…
Multifunctional properties of nanocomposites made by 1D and 2D graphene based fillers
2015
High aspect ratio graphene based fillers with different dimensionalities showed the ability to greatly modify rheological, mechanical, thermal and electrical properties of polymers at very low content. In this work, the effect of filler dimensionality on the multifunctional properties of an epoxy matrix reinforced by both carbon nanotubes (1D) and graphite nanoplatelets (2D) have been investigated across the percolation region. Keywords-- Carbon nanotube, Graphite nanoplatelet, nanocomposites, mechanical properties, ...
Aluminum oxide nucleation in the early stages of atomic layer deposition on epitaxial graphene
2020
In this work, the nucleation and growth mechanism of aluminum oxide (Al2O3) in the early stages of the direct atomic layer deposition (ALD) on monolayer epitaxial graphene (EG) on silicon carbide (4H-SiC) has been investigated by atomic force microscopy (AFM) and Raman spectroscopy. Contrary to what is typically observed for other types of graphene, a large and uniform density of nucleation sites was observed in the case of EG and ascribed to the presence of the buffer layer at EG/SiC interface. The deposition process was characterized by Al2O3 island growth in the very early stages, followed by the formation of a continuous Al2O3 film (2.4 nm thick) after only 40 ALD cycles due to the isla…