Search results for " paper."
showing 10 items of 1490 documents
Removal of acetone from air emissions by biotrickling filters: providing solutions from laboratory to full-scale
2018
A full-scale biotrickling filter (BTF) treating acetone air emissions of wood-coating activities showed difficulties to achieve outlet concentrations lower than 125 mg C m-3, especially for high inlet concentrations and oscillating emissions. To solve this problem, a laboratory investigation on acetone removal was carried out simulating typical industrial conditions: discontinuous and variable inlet concentrations and intermittent spraying. The results were evaluated in terms of removal efficiency and outlet gas emission pattern. Industrial emissions and operational protocols were simulated: inlet load up to 70 g C m-3 h-1 during 2 cycles of 4 h per day and intermittent trickling of 15 min …
Anaerobic membrane bioreactor (AnMBR) scale-up from laboratory to pilot-scale for microalgae and primary sludge co-digestion: Biological and filtrati…
2020
This research work proposes the scale-up evaluation in terms of biological and filtration performance from laboratory to pilot-scale of an anaerobic membrane bioreactor (AnMBR) co-digesting raw microalgae and primary sludge. Best operating conditions for this scale-up were energetically and economically assessed based on laboratory results. Economic balance showed 3% higher annual costs when operating a reactor at 100 d solids retention time (SRT) compared to 70 d SRT. Energetic balance showed a 5.5-fold increase in heat demand working at thermophilic temperature comparing to mesophilic. The AnMBR operating conditions were set at 70 d SRT and 35 °C. The pilot-scale and lab-scale co-digester…
Enhanced high-quality biomethane production from anaerobic digestion of primary sludge by corn stover biochar
2020
Abstract This study conducted batch and continuous tests to reveal the feasibility of corn stover biochar on improving anaerobic digestion of primary sludge (PS). Dosing biochar (1.82, 2.55 and 3.06 g/g Total Solids (TS)) in digester improved methane content increasing from 67.5% to 81.3–87.3% and enhanced methane production by 8.6–17.8%. Model analysis indicated that biochar accelerated PS hydrolysis and enhanced methane potential of PS. The mechanistic studies showed that biochar enhanced process stability provided by strong buffering capacity and alleviated NH3 inhibition. In continuous test over 116 days, the volatile solids (VS) destruction in the biochar-dosed digester increased by 14…
Co-digestion of harvested microalgae and primary sludge in a mesophilic anaerobic membrane bioreactor (AnMBR): Methane potential and microbial divers…
2020
Abstract Anaerobic co-digestion of primary sludge and raw microalgae (Scenedesmus and Chlorella) was performed in a lab-scale semi-continuous anaerobic membrane bioreactor to assess the biological performance and identify the microbial community involved in the co-digestion process. The reactor was operated at 35 °C for 440 days, working at a solids retention time of 100 days. The system achieved 73% biodegradability and showed high stability in terms of pH and volatile fatty acids. An enriched microbial community was observed. Of the several phyla, Chloroflexi and Proteobacteria were the most abundant. Cellulose-degraders phyla (Bacteroidetes, Chloroflexi and Thermotogae) were detected. Sy…
Anaerobic membrane bioreactors (AnMBR) treating urban wastewater in mild climates
2020
[EN] Feasibility of an AnMBR demonstration plant treating urban wastewater (UWW) at temperatures around 25-30 degrees C was assessed during a 350-day experimental period. The plant was fed with the effluent from the pretreatment of a full-scale municipal WWTP, characterized by high COD and sulfate concentrations. Biodegradability of the UWW reached values up to 87%, although a portion of the biodegradable COD was consumed by sulfate reducing organisms. Effluent COD remained below effluent discharge limits, achieving COD removals above 90%. System operation resulted in a reduction of sludge production of 36-58% compared to theoretical aerobic sludge productions. The membranes were operated a…
Achievement of partial nitrification under different carbon-to-nitrogen ratio and ammonia loading rate for the co-treatment of landfill leachate with…
2019
Abstract Partial nitrification (PN) is a technically and economically effective solution for the treatment of wastewater featuring low C/N ratio, allowing to achieve approximately 25% energy saving and 40% carbon source for denitrification. This study investigated the effect of different carbon to nitrogen ratio (C/N) and ammonia loading rate (ALR) on PN performances in a sequencing batch reactor (SBR) treating landfill leachate with municipal wastewater. The aim was to find an optimum range for C/N and ALR to maximize PN performances. Results demonstrated that a proper balancing between ALR and C/N is crucial to achieve high PN efficiency. The results highlighted the existence of an optimu…
Combination of the OSA process with thermal treatment at moderate temperature for excess sludge minimization
2019
Abstract This study investigated the chance to couple the conventional Oxic Settling Anaerobic (OSA) process with a thermic treatment at moderate temperature (35 °C). The maximum excess sludge reduction rate (80%) was achieved when the plant was operated under 3 h of hydraulic retention time (HRT). Compared with the conventional OSA system, the thermic treatment enabled a further improvement in excess sludge minimization of 35%. The observed yield coefficient decreased from 0.25 gTSS gCOD−1 to 0.10 gTSS gCOD−1 when the temperature in the anaerobic reactor was increased to 35 °C, despite the lower HRT (3 h vs 6 h). Moreover, the thermic treatment enabled the decrease of filamentous bacteria,…
Assessment and characterization of the bacterial community structure in advanced activated sludge systems
2019
Abstract The present study is aimed to assess and characterize the structure of bacterial community in advanced activated sludge systems. In particular, activated sludge samples were collected from an Integrated Fixed-film Activated Sludge – Membrane Bioreactor pilot plant under a University of Cape Town configuration with in-series anaerobic (Noair)/anoxic (Anox)/aerobic (Oxy) reactors – and further analyzed. The achieved results – based on Next Generation Sequencing (NGS) of 16S rDNA amplicons – revealed that the bacterial biofilm (bf) communities on plastic carriers of Oxy and Anox reactors had a greater diversity compared to suspended (sp) bacterial flocs of Oxy, Anox and Noair. Indeed,…
Study on the effects of several operational variables on the enzymatic batch saccharification of orange solid waste
2017
In this work, batch enzyme-aided extraction and enzymatic saccharification of blade-milled orange waste was studied. The operation variables for this process were thoroughly analysed. It was determined that batch runs with initial pH values of 5.0 and 5.2 controlled during the first hour, 50°C and 300-500r.p.m. agitation resulted in the best yields, with a limited total and partial first-order enzyme deactivation (for cellulases and polygalacturonidase, respectively). Orange peel waste (OPW) at 6.7% w/w dry solid, 0.22 filter paper units (FPU)/g DS and proportional activities of other enzymes led to over 40g/L free monosaccharides and global yields to glucose over 80%. When using 10.1% w/w …
Bioplastic recovery from wastewater: A new protocol for polyhydroxyalkanoates (PHA) extraction from mixed microbial cultures
2019
Abstract A new protocol for polyhydroxyalkanoates (PHA) extraction from mixed microbial cultures (MMCs) is proposed. PHA-accumulating capacity of the MMC was selected in a sequencing batch reactor (SBR) fed with a synthetic effluent emulating a fermented oil mill wastewater (OMW). The highest recovery yield and purity (74 ± 8% and 100 ± 5%, respectively) was obtained when using NH4-Laurate for which operating conditions of the extraction process such as temperature, concentration and contact time were optimized. Best conditions for PHA extraction from MMC turned to be: i) a pre-treatment with NaClO at 85 °C with 1 h of contact time, followed by ii) a treatment with lauric acid in a ratio ac…