Search results for " plastic"

Nanoparticle dispersion in liquid metals by electromagnetically induced acoustic cavitation

2016

Abstract Aim of this study is to investigate experimentally the effect of magnetically induced cavitation applied for the purpose of nanoparticle dispersion in liquid metals. The oscillating magnetic force due to the azimuthal induction currents and the axial magnetic field excites power ultrasound in the sample. If the fields are sufficiently high then it is possible to achieve the acoustic cavitation threshold in liquid metals. Cavitation bubble collapses are known to create microscale jets with a potential to break nanoparticle agglomerates and disperse them. The samples are solidified under the contactless ultrasonic treatment and later analyzed by electron microscopy and energy-dispers…

Two-phase dielectric polar structures in 0.1NBT-0.6ST-0.3PT solid solutions

2018

Abstract In this work we address the peculiarities of the macroscopic responses in ternary 0.1Na0·5Bi0·5TiO3-0.6SrTiO3-0.3PbTiO3 (0.1NBT-0.6ST-0.3PT) solid solutions. These solid solutions exhibit a spontaneous first order relaxor to normal ferroelectric phase transition. The phase transition is accompanied by a broad dielectric relaxation which expands over 10 orders of magnitude in frequency just above the phase transition temperature. The temperature dependence of polarization shows that non-zero net polarization persists above the phase transition temperature. Below the phase transition temperature, it is not possible to describe the temperature dependence of polarization with a power l…

Study of the thermochromic phase transition in CuMo1−xWxO4 solid solutions at the W L3-edge by resonant X-ray emission spectroscopy

2021

Abstract Polycrystalline CuMo 1 − x W x O 4 solid solutions were studied by resonant X-ray emission spectroscopy (RXES) at the W L 3 -edge to follow a variation of the tungsten local atomic and electronic structures across thermochromic phase transition as a function of sample composition and temperature. The experimental results were interpreted using ab initio calculations. The crystal-field splitting parameter Δ for the 5d(W)-states was obtained from the analysis of the RXES plane and was used to evaluate the coordination of tungsten atoms. Temperature-dependent RXES measurements were successfully employed to determine the hysteretic behaviour of the structural phase transition between t…

Interface evolution during magnetic pulse welding under extremely high strain rate collision: mechanisms, thermomechanical kinetics and consequences

2020

Abstract Magnetic pulse welding enables to produce perplexing interfacial morphologies due to the complex material response during the high strain rate collision. Thus, a thermomechanical model is used in this study to investigate the formation mechanism of the wake, vortex, swirling and mesoscale cavities with the increase of the impact intensity at the interface. The formation of these interfacial features are difficult to characterize by insitu methods, thus the origin of phenomena still remain a subject of open discussion. Our studies identify the governing mechanisms and the associated thermomechanical kinetics, which are responsible for the formation mechanism of interfacial features.…

Synergistic effect of fiber content and length on mechanical and water absorption behaviors of Phoenix sp. fiber-reinforced epoxy composites

2016

Phoenix sp. fiber-reinforced epoxy composites have been manufactured using compression molding technique. The effect of reinforcement volume content (0%, 10%, 20%, 30%, 40%, and 50%) and size (300 µm particles, 10 mm, 20 mm, and 30 mm fibers) on quasi-static and dynamic mechanical properties was investigated. Moreover, the water absorption properties of composites were analyzed at different environmental conditions (10℃, 30℃, and 60℃). For each reinforcement size, composites loaded with 40% in volume show highest tensile and flexural properties. Furthermore, composites with 300 µm particles present the best impact properties and the lowest water absorption, regardless of the environmental …

Effect of AlR3 (R = Me, Et, iBu) addition on the composition and microstructure of ethylene/1-olefin copolymers made with post-metallocene complexes …

2018

The effect of trialkylaluminum compound (AlR3, where R = Me, Et, iBu) addition on the performance of the [LigZrCl]2(μ-O)/AliBu3/Ph3CB(C6F5)4 and LigTiCl2/AliBu3/Ph3CB(C6F5)4 (Lig = Me2N(CH2)2N(CH2-2-O-3,5-tBu2-C6H2)2) catalysts in ethylene/1-olefin copolymerization was investigated. The presence of AlMe3 in the feed during the copolymerization process catalyzed by the diamine-bis(phenolate) zirconium catalyst greatly increases the amount of incorporated comonomer and leads to microstructural changes, e.g., the formation of blocky and alternating sequences of 1-olefin units. Moreover, the use of AlMe3 limits the reaction yield and decreases the molecular weight of the produced copolymers. Th…

The complementary structural studies of the double metal cyanide type catalysts for the ring opening polymerization of the oxiranes

2016

What is in our seas? Assessing anthropogenic litter on the seafloor of the central Mediterranean Sea

2020

Abstract Abundance, composition, and distribution of macro-litter found on the seafloor of the Strait of Sicily between 10 and 800 m depth has been studied using data collected by bottom trawl surveys MEDITS from 2015 to 2019. Three waste categories based on the items use were considered: single-use, fishing-related and generic-use. Over 600 sampling sites, just 14% of these were litter-free. The five-years average density of seafloor litter was 79.6 items/km2 and ranged between 46.8 in 2019 and 118.1 items/km2 in 2015. The predominant waste type was plastic (58% of all items). Regardless of material type, single-use items were a dominant (60% of items) and widespread (79% of hauls) fractio…

Quantitative genetics of temperature performance curves of Neurospora crassa

2020

AbstractEarth’s temperature is increasing due to anthropogenic CO2emissions; and organisms need either to adapt to higher temperatures, migrate into colder areas, or face extinction. Temperature affects nearly all aspects of an organism’s physiology via its influence on metabolic rate and protein structure, therefore genetic adaptation to increased temperature may be much harder to achieve compared to other abiotic stresses. There is still much to be learned about the evolutionary potential for adaptation to higher temperatures, therefore we studied the quantitative genetics of growth rates in different temperatures that make up the thermal performance curve of the fungal model systemNeuros…

Ecological plant epigenetics: Evidence from model and non-model species, and the way forward

2017

Growing evidence shows that epigenetic mechanisms contribute to complex traits, with implications across many fields of biology. In plant ecology, recent studies have attempted to merge ecological experiments with epigenetic analyses to elucidate the contribution of epigenetics to plant phenotypes, stress responses, adaptation to habitat, and range distributions. While there has been some progress in revealing the role of epigenetics in ecological processes, studies with non-model species have so far been limited to describing broad patterns based on anonymous markers of DNA methylation. In contrast, studies with model species have benefited from powerful genomic resources, which contribute…