Search results for " solar cell"
showing 10 items of 309 documents
Sensitizer exchange dynamics in air and solvent filled semiconductor nanocavities
2010
Multiple dye binding sites and their exchange in equilibrium in air and solvent filled sensitized titanium oxide nanocavities were identified by 2DIR spectroscopy. Binding geometry and flexibility may influence electron injection efficiency of solar cells.
PV effect of fullerene/poly(3-hexylthiophene) blend sensitized by phthalocyanine having infrared absorption CT band
2008
An attempt was made to extend the photosensitivity spectral range of fullerene/poly(3-hexylthiophene) blend to NIR region by adding extra electron donor — hydroxygallium phthalocyanine (GaOHPc) with a strong and wide intermolecular charge transfer (CT) band around 830 nm. Multilayer cells of ITO/PEDOT: PSS/6 GaOHPc/P3HT: C61(CO2Et)2 have been prepared by spin coating with vacuum evaporated Al or In top electrodes. Significant photosensitivity of the cells was in 370–900 nm spectral range. However charge carrier photogeneration efficiency was 3 times higher for illumination in P3HT absorption band as compared with the GaOHPc CT band at 830 nm. But when GaOHPc was mixed in the blend forming P…
Consistent device simulation model describing perovskite solar cells in steady-state, transient, and frequency domain
2019
This document is the Accepted Manuscript version of a Published Work that appeared in final form in ACS Applied Materials & Interfaces, copyright © American Chemical Society after peer review and technical editing by the publisher. To access the final edited and published work see https://pubs.acs.org/doi/10.1021/acsami.9b04991
3D photonic crystal intermediate reflector for micromorph thin-film tandem solar cell
2008
The concept of 3D photonic intermediate reflectors for micromorph silicon tandem solar cells has been investigated. In thin-film silicon tandem solar cells consisting of amorphous and microcrystalline silicon with two junctions of a-Si/μc-Si, efficiency enhancements can be achieved by increasing the current density in the a-Si top cell. It is one goal to provide an optimized current matching at high current densities. For an ideal photon-management between top and bottom cell, a spectrally selective intermediate reflective layer (IRL) is necessary, which is less dependent of the angle of incidence than state-of-the-art thickness dependent massive interlayers. The design, preparation and cha…
Fabrication of CZTSe/CIGS Nanowire Arrays by One-Step Electrodeposition for Solar-Cell Application
2021
The paper reports some preliminary results concerning the manufacturing process of CuZnSnSe (CZTSe) and CuInGaSe (CIGS) nanowire arrays obtained by one-step electrodeposition for p-n junction fabrication. CZTSe nanowires were obtained through electrodeposition in a polycarbonate membrane by applying a rectangular pulsed current, while their morphology was optimized by appropriately setting the potential and the electrolyte composition. The electrochemical parameters, including pH and composition of the solution, were optimized to obtain a mechanically stable array of nanowires. The samples were characterized by scanning electron microscopy, Raman spectroscopy, and energy-dispersion spectros…
Shedding Light on Graphene Quantum Dots: Key Synthetic Strategies, Characterization Tools, and Cutting-Edge Applications
2021
During the last 20 years, the scientific community has shown growing interest towards carbonaceous nanomaterials due to their appealing mechanical, thermal, and optical features, depending on the specific nanoforms. Among these, graphene quantum dots (GQDs) recently emerged as one of the most promising nanomaterials due to their outstanding electrical properties, chemical stability, and intense and tunable photoluminescence, as it is witnessed by a booming number of reported applications, ranging from the biological field to the photovoltaic market. To date, a plethora of synthetic protocols have been investigated to modulate the portfolio of features that GQDs possess and to facilitate the…
On the Variability of the Temperature Coefficients of mc-Si Solar Cells with Irradiance
2016
Abstract The temperature sensitivity of silicon solar cells is in general assumed to be constant with irradiance in PV forecasting models, although it has been demonstrated experimentally that this is not true. In this study a theoretical model is established that describes the variation of the temperature coefficients of a silicon solar cell as a function of the irradiance. It is shown that the temperature sensitivity of the solar cell efficiency is decreasing with the irradiance and that the main reason for this behavior comes from the increase of the open-circuit voltage with light intensity. Moreover, a dependency of the cell's ideality factor on the irradiance has to be assumed to rece…
Integrazione di celle fotovoltaiche ibride nel vetromattone
2012
L’invenzione riguarda l’integrazione del vetromattone con celle solari ibride (organiche/inorganiche), conosciute come Dye-sensitized Solar Cell (DSC). La combinazione del vetromattone con le DSC consente di migliorare le prestazioni del prodotto originario rendendolo in grado di produrre energia pulita. Le caratteristiche di trasparenza e isolamento termo-acustico del prodotto possono essere regolate agendo sulla configurazione delle DSC. Il prodotto può essere assemblato a formare pannelli fotovoltaici per la realizzazione di facciate traslucide energeticamente “attive” in varie condizioni luminose (condizioni di luce diffusa o artificiale) e indipendentemente dall’angolo di radiazione so…
Influence of spectral composition on the temperature coefficients of solar cells from Elkem Solar
2014
The temperature coefficients of solar cells from two different feedstocks — a compensated silicon, the Elkem Solar Silicon (ESS®), and polysilicon - under full and selective parts of the light spectrum are presented based on results obtained using a AAA sun simulator. These results are of particular interest in understanding the possible causes behind the better temperature coefficients usually observed for ESS® compared to polysilicon solar cells when measured with a full AM1.5 spectrum. The optical filtered lights from four different regions of the spectrum have been used to examine the influence of temperature coefficients on the spectral composition. ESS® solar cells showed considerable…
Impact of transparent conductive oxide on the admittance of thin film solar cells
2010
Abstract The impact of transparent electrically conducting oxide (TCO) on the admittance measurements of thin film p–i–n a-Si:H solar cells was investigated. Admittance measurements on solar cell devices, with different area and geometry, in a wide range of frequencies and biases were performed. The admittance measurements of the investigated solar cells, which use the TCO as an electrical contact, showed that the high frequency admittance per area unit depends on the area. This effect increases both with the probe frequency and the size of the solar cells. Transmission line model valid for strip geometry which explains how the resistivity of the TCO layer impacts the measured admittance of…