Search results for " vol"
showing 10 items of 3179 documents
Lidar detection of carbon dioxide in volcanic plumes
2015
Volcanic gases give information on magmatic processes. In particular, anomalous releases of carbon dioxide precede volcanic eruptions. Up to now, this gas has been measured in volcanic plumes with conventional measurements that imply the severe risks of local sampling and can last many hours. For these reasons and for the great advantages of laser sensing, the thorough development of volcanic lidar has been undertaken at the Diagnostics and Metrology Laboratory (UTAPRAD-DIM) of the Italian National Agency for New Technologies, Energy and Sustainable Economic Development (ENEA). In fact, lidar profiling allows one to scan remotely volcanic plumes in a fast and continuous way, and with high s…
Emission of Bromine and Iodine from Mt. Etna volcano
2005
Constraining fluxes of volcanic bromine and iodine to the atmosphere is important given the significant role these species play in ozone depletion. However, very few such measurements have been made hitherto, such that global volcanic fluxes are poorly constrained. Here we extend the data set of volcanic Br and I degassing by reporting the first measurements of bromine and iodine emissions from Mount Etna. These data were obtained using filter packs and contemporaneous ultraviolet spectroscopic SO2 flux measurements, resulting in time-averaged emission rates of 0.7 kt yr(-1) and 0.01 kt yr(-1) for Br and I, respectively, from April to October 2004, from which we estimate global Br and I flu…
Volcanic Plume CO2 Flux Measurements at Mount Etna by Mobile Differential Absorption Lidar
2017
Volcanic eruptions are often preceded by precursory increases in the volcanic carbon dioxide (CO2) flux. Unfortunately, the traditional techniques used to measure volcanic CO2 require near-vent, in situ plume measurements that are potentially hazardous for operators and expose instruments to extreme conditions. To overcome these limitations, the project BRIDGE (BRIDging the gap between Gas Emissions and geophysical observations at active volcanoes) received funding from the European Research Council, with the objective to develop a new generation of volcanic gas sensing instruments, including a novel DIAL-Lidar (Differential Absorption Light Detection and Ranging) for remote (e.g., distal) …
Ultraviolet imaging of volcanic plumes: A new paradigm in volcanology
2017
Ultraviolet imaging has been applied in volcanology over the last ten years or so. This provides considerably higher temporal and spatial resolution volcanic gas emission rate data than available previously, enabling the volcanology community to investigate a range of far faster plume degassing processes than achievable hitherto. To date, this has covered rapid oscillations in passive degassing through conduits and lava lakes, as well as puffing and explosions, facilitating exciting connections to be made for the first time between previously rather separate sub-disciplines of volcanology. Firstly, there has been corroboration between geophysical and degassing datasets at â1 Hz, expeditin…
Experimental Validation of Maximum Constant Boost Control and Switching Frequency Optimal for three-phase Quasi-Z-Source Converters
2020
This paper presents a modified modulation scheme for quasi-Z-Source converters, based on the Maximum Constant Boost Control (MCBC) concept and Switching Frequency Optimal (SFO) as reference signal. The effectiveness of the proposed technique is validated by comparing the obtained results (in terms of AC harmonic content and voltage stress) with those carried out from traditional modulation schemes. For this reason, a test bench has been assembled and the benefits of the SFO MCBC modulation scheme have been valuated.
Decoupled control scheme of grid-connected split-source inverters
2017
Grid-connected power conversion systems for renewable energy sources must fulfill several requirements, e.g., the high efficiency, the reduced cost and complexity, and, quite often, the boost capabilities that is usually achieved using a front-end dc–dc boost converter before the inversion stage, leading to a two-stage architecture. Meanwhile, single-stage power conversion systems, which perform the boosting operation within the inversion one, offer some potential advantages, in terms of reducing the complexity and the volume of the whole system. Among several proposed options, the split-source inverter (SSI) has been recently proposed by Abdelhakim et al. as an alternative option with some…
Formaldehyde and total aldehydes in indoor air of public environments by voltammetry
2014
The proposed method involves active sampling, where a sampling pump is used to pull air through a solution and voltammetric analysis of the obtained solutions. No interferences have been observed. In addition, very little sample preparation is required. Analyses were performed in 19 indoor stations and one in outdoor. Measurements were carried out on University environments: Museum of Chemistry, Zoological Museum, libraries, laboratories, corridors, meeting rooms, photocopying room, machine shop and terrace. Formaldehyde concentrations in analyzed samples ranged from 2.6 to 85 μg m-3 (median = 32 μg m-3), while the sum of others aldehydes ranged from 2 to 25 μg m-3 (median =2.4 μg m-3). In …
Micro-determination of dithiocarbamates in pesticide formulations using voltammetry
2013
Abstract The purpose of this work was to develop a reliable method for the micro-determination of dithiocarbamates (mancozeb, maneb, propineb, nabam, Na(CH3)2DTC, zineb, ziram, ferbam and thiram) in pesticide formulations for agriculture using adsorptive stripping voltammetry (AdSV). The accuracy of analytical method was valued by analyzing simulate formulation samples prepared by us with known amounts of active ingredients. In addition, the applicability of the AdSV procedure for the analysis of DTCs and EBDTCs in micro-samples was evaluated by estimating its recoveries from spiked commercial formulate samples. The accuracy, valuated as recovery percentage ranged between 85% and 97%. The p…
Quantification of Platinum in Edible Mushrooms Using Voltammetric Techniques
2021
Edible mushrooms are a food source with interesting nutritional values. The chief objective of this research was to develop a consistent method for the quantitative ultra-trace analysis of Pt in mushrooms, which is complex because it cannot be readily quantified by common analytical procedures. This research is one of the first analytical methods to establish Pt amount in these vegetables. In this research, 28 different edible mushroom samples from Italy were investigated. Determination of Pt in mushrooms was completed using Differential Pulse Voltammetry (DPV). In this study, we applied the standard addition method because there are no certified reference mushrooms containing platinum grou…