Search results for "2020"

Identification and Experimental Validation of an Induction Motor Thermal Model for Improved Drivetrain Design

2017

The ability of an electric powertrain to perform according to mechanical specifications is equally important as assessing its thermal protection limits, which are affected by its electrical and thermal properties. Although rated parameters (such as power, torque, etc.) are easily accessible in catalogs of equipment producers, more specific properties like mass/length of copper winding, heat dissipation factor, etc., are not available to customers. Therefore, an effective selection of drivetrain components is limited due to the lack of sufficient data and the need to consult critical design decisions with suppliers. To overcome this limitation, we propose a method to estimate the temperature…

Supplementary frequency regulation in non-synchronous AC system connected via MTDC

2019

Abstract In smart grid power system operation, frequency regulation is one of the most critical tasks towards power balance in the grid. This paper presents the schemes for improvement in operation of secondary loop of turbine-generator unit for frequency regulation in non-synchronous AC areas connected via multi-terminal direct current (MTDC) network. Two schemes have been discussed; (i) voltage droop based lead/lag compensator and (ii) DC power modulation at converter terminal depending upon frequency deviation from each AC area. In the first scheme, droop design based on lead/lag compensator using DC voltage deviation is introduced as supplementary signal at turbine-generator unit in eac…

A set of indices to assess the real performance of daylight-linked control systems

2017

Abstract The installation of Building Automation Control Systems (BACs) in general is an effective action to achieve relevant energy savings. Commercial BACs, installed in residential or small offices, often include functions of lighting control, acting as Daylight-Linked Control Systems (DLCSs). Nevertheless, because system performance is strictly dependent on different parameters, BAC’s hardware and software configuration and as well as an inaccurate commissioning do not always allow a perfect execution of the desired tasks; therefore, the system could not work as expected. Moreover, it is well known that energy saving potential is specifically related to the variability of the light envi…

Wireless ECG and cardiac monitoring systems: State of the art, available commercial devices and useful electronic components

2021

Abstract Wireless ElectroCardioGram (ECG) systems are employed in manifold application fields: tele-monitoring, sport applications, support to ageing people at home, fetal ECG, wearable devices and ambulatory monitoring. The presence of cables often hinders user’s free movements, alongside clinicians’ routine operations. Therefore, wireless ECG systems are desirable. This paper aims at reviewing the solutions described in the literature, besides commercially available devices and electronic components useful to setup laboratory prototypes. Several systems have been developed, different in terms of the adopted technology; when approaching the development of a wireless ECG system, some import…

Spatial noise-aware temperature retrieval from infrared sounder data

2020

In this paper we present a combined strategy for the retrieval of atmospheric profiles from infrared sounders. The approach considers the spatial information and a noise-dependent dimensionality reduction approach. The extracted features are fed into a canonical linear regression. We compare Principal Component Analysis (PCA) and Minimum Noise Fraction (MNF) for dimensionality reduction, and study the compactness and information content of the extracted features. Assessment of the results is done on a big dataset covering many spatial and temporal situations. PCA is widely used for these purposes but our analysis shows that one can gain significant improvements of the error rates when using…

An over-the-distance wireless battery charger based on RF energy harvesting

2017

An RF powered receiver silicon IC (integrated circuit) for RF energy harvesting is presented as wireless battery charger. This includes an RF-to-DC energy converter specifically designed with a sensitivity of -18.8 dBm and an energy conversion efficiency of ∼45% at 900 MHz with a transmitting power of 0.5 W in free space. Experimental results concerned with remotely battery charging using a complete prototype working in realistic scenarios will be shown.

Optimization of net power density in Reverse Electrodialysis

2019

Abstract Reverse Electrodialysis (RED) extracts electrical energy from the salinity difference between two solutions using selective ion exchange membranes. In RED, conditions yielding a large net power density (NPD) are generally desired, due to the still large cost of the membranes. NPD depends on a large number of physical and geometric parameters. Some of these, for example the inlet concentrations of concentrate and diluate, can be regarded as “scenario” variables, imposed by external constraints (e.g., availability) or chosen by different criteria than NPD maximization. Others, namely the thicknesses HCONC, HDIL and the velocities UCONC, UDIL in the concentrate and diluate channels, c…

Localization from inertial data and sporadic position measurements

2020

International audience; A novel estimation strategy for inertial navigation in indoor/outdoor environments is proposed with a specific attention to the sporadic nature of the non-periodic measurements. After introducing the inertial navigation model, we introduce an observer providing an asymptotic estimate of the plant state. We use a hybrid dynamical systems representation for our results, in order to provide an effective, and elegant theoretical framework. The estimation error dynamics with the proposed observer shows a peculiar cascaded interconnection of three subsystems (allowing for intuitive gain tuning), with perturbations occurring either on the jump or on the flow dynamics (depen…

A Fuzzy Chance-constraint Programming Model for a Home Health Care Routing Problem with Fuzzy Demand

2017

Crossing Borders: An Online Interdisciplinary Course in Health Informatics for Students From Two Countries.

2017

A cross-countries and interprofessional novel approach for delivering an international interdisciplinary graduate health informatics course online is presented. Included in this discussion are the challenges, lessons learned, and pedagogical recommendations from the experiences of teaching the course. Four professors from three different fields and from three universities collaborated in offering an international health informatics course for an interdisciplinary group of 18 US and seven Norwegian students. Highly motivated students and professors, an online technology infrastructure that supported asynchronously communication and course delivery, the ability to adapt the curriculum to meet…