Search results for "Algorithm"
showing 10 items of 4887 documents
Design of Wideband MIMO Car-to-Car Channel Models Based on the Geometrical Street Scattering Model
2012
Published version of an article in the journal: Modelling and Simulation in Engineering. Also available from the publisher at: http://dx.doi.org/10.1155/2012/264213 Open access We propose a wideband multiple-input multiple-output (MIMO) car-to-car (C2C) channel model based on the geometrical street scattering model. Starting from the geometrical model, a MIMO reference channel model is derived under the assumption of single-bounce scattering in line-of-sight (LOS) and non-LOS (NLOS) propagation environments. The proposed channel model assumes an infinite number of scatterers, which are uniformly distributed in two rectangular areas located on both sides of the street. Analytical solutions a…
A frequency compensation algorithm of four-wheel coherence random road
2013
Published version of an article in the journal: Mathematical Problems in Engineering. Also available from the publisher at: http://dx.doi.org/10.1155/2013/986584 Open access The road surface roughness is the main source of kinematic excitation of a moving vehicle, which has an important influence on vehicle performance. In recent decades, random road models have been widely studied, and a four-wheel random road time domain model is usually generated based on the correlation of the four-wheel input, in which a coherence function is used to describe the coherence of the road input between the left and right wheels usually. However, during our research, there are some conditions that show that…
A massive lesion detection algorithm in mammography
2004
A new algorithm for massive lesion detection in mammography is presented. The algorithm consists in three main steps : 1) reduction of the dimension of the image to be processed through the identifi cation of regions of interest (rois) as candidates for massive lesions ; 2) characterization of the roi by means of suitable feature extraction ; 3) pattern classifi cation through supervised neural networks. Suspect regions are detected by searching for local maxima of the pixel grey level intensity. A ring of increasing radius, centered on a maximum, is considered until the mean intensity in the ring decreases to a defi ned fraction of the maximum. The rois thus obtained are described by avera…
Towards online bearing fault detection using envelope analysis of vibration signal and decision tree classification algorithm
2017
Online bearing fault detection is an important method for monitoring the health status of bearings in critical machines. This work proposes a classification algorithm, which can be extended towards an online bearing fault detection. The objective is to detect and classify the bearing faults in early stages. The overall design aspects of the online bearing fault detection and classification system are discussed. The proposed method is validated using experimental data, and a high accuracy of the fault classification was observed. Therefore, the proposed method can be applied for an online early fault detection and classification system.
A simplified approach for load flow analysis in MV smart grids based on LV power measurements
2017
This paper presents a simplified approach for load flow analysis in medium voltage (MV) distribution networks. It is a power summation Backward/Forward (B/F) algorithm, based on measurements of active and reactive powers at low voltage (LV) side of MV/LV distribution substations. The proposed solution allows achieving good accuracy, computational efficiency and fast convergence. In order to verify the algorithm performances, simulation studies are carried out in the case of a real test system, i.e. the distribution grid of Favignana Island (Mediterranean Sea, Italy). The compatibility between simulations results and power measurements at the MV bus bars of the generating substation shows th…
Algorithms for skiascopy measurement automatization
2014
Automatic dynamic infrared retinoscope was developed, which allows to run procedure at a much higher rate. Our system uses a USB image sensor with up to 180 Hz refresh rate equipped with a long focus objective and 850 nm infrared light emitting diode as light source. Two servo motors driven by microprocessor control the rotation of semitransparent mirror and motion of retinoscope chassis. Image of eye pupil reflex is captured via software and analyzed along the horizontal plane. Algorithm for automatic accommodative state analysis is developed based on the intensity changes of the fundus reflex.
Multi-objective optimization of nitinol stent design.
2017
Nitinol stents continuously experience loadings due to pulsatile pressure, thus a given stent design should possess an adequate fatigue strength and, at the same time, it should guarantee a sufficient vessel scaffolding. The present study proposes an optimization framework aiming at increasing the fatigue life reducing the maximum strut strain along the structure through a local modification of the strut profile.The adopted computational framework relies on nonlinear structural finite element analysis combined with a Multi Objective Genetic Algorithm, based on Kriging response surfaces. In particular, such an approach is used to investigate the design optimization of planar stent cell.The r…
A standard-compliant prototype for PV module curve detection
2014
In this paper, a prototype for PV module curve detection which features low cost and size and ensures high accuracy is proposed. The proposed architecture is based on a buck-boost converter in open-loop configuration. The proposed architecture is fully compliant with actual standard IEC60904. The duty-cycle control algorithm and its own effects on system performances are accurately investigated. The comparison of different duty-cycle patterns is carried out and performance evaluation is performed. Simulation results are shown to perform a valuable comparison of control algorithms. Preliminary experimental results on a laboratory prototype are presented.
Optimal power flow in islanded microgrids using a simple distributed algorithm
2015
In this paper, the problem of distributed power losses minimization in islanded distribution systems is dealt with. The problem is formulated in a very simple manner and a solution is reached after a few iterations. The considered distribution system, a microgrid, will not need large bandwidth communication channels, since only closeby nodes will exchange information. The correction of generated active powers is possible by means of the active power losses partition concept that attributes a portion of the overall power losses in each branch to each generator. The experimental part shows the first results of the proposed method on an islanded microgrid. Simulation results of the distributed…
Compressive sensing for direct time of flight estimation in ultrasound-based NDT
2017
This paper presents an approach for estimation of ultrasonic time-of-flight (TOF) within a Non Destructive Testing (NDT) and Structural Health Monitoring (SHM) context. The presented method leverages recent advances in the field of Compressive Sensing (CS), which makes use of sparsity in a transform domain of a signal in order to reduce the number of samples required to store it. CS achieves this through a two key ideas: random matrix projections, and l1-penalised linear regression. In this case, sparsity arises from the observation that in a pulse-echo ultrasound test, the number of echoes is relatively small compared to the number of measurement points in a waveform. This sparsity is evid…