Search results for "Bioengineering"
showing 10 items of 1963 documents
Effective saccharification of lignocellulosic barley straw by mechanocatalytical pretreatment using potassium pyrosulfate as a catalyst
2017
The catalytic conversion of lignocellulosic biomass is attractive due to the feasible generation of valuable products such as reducing sugars which constitute the basic substrates for chemical and transportation fuel production, as well as the production of renewable hydrogen. This study shows the efficient conversion of lignocellulose, especially hemicellulose, into reducing sugars such as xylose and galactose, by mechanocatalysis using potassium pyrosulfate, K2S2O7, as an effective salt catalyst. Ball milling was performed, introducing a mechanical force which, combined with chemical pretreatment, leads to reducing sugar yields (40%) almost as high as when commonly used sulfuric acid was …
Free surface oxygen transfer in large aspect ratio unbaffled bio-reactors, with or without draft-tube
2015
Abstract It is widely accepted that animal cell damage in aerated bioreactors is mainly related to the bursting of bubbles at the air–liquid interface. A viable alternative to sparged bioreactors may be represented by uncovered unbaffled stirred tanks, which have been recently found to be able to provide sufficient mass transfer through the deep free surface vortex which takes place under agitation conditions. As a matter of fact, if the vortex is not allowed to reach impeller blades, no bubble formation and subsequent bursting at the free-surface, along with relevant cells damage, occurs. In this work oxygen transfer performance of large aspect ratio unbaffled stirred bioreactors, either e…
Mesophilic co-digestion of dairy manure and lipid rich solid slaughterhouse wastes: process efficiency, limitations and floating granules formation.
2014
Lipid and protein rich solid slaughterhouse wastes are attractive co-substrates to increase volumetric biogas production in co-digestion with dairy manure. Addition of decanter sludge (DS), containing 42.2% of lipids and 35.8% of proteins (total solids basis), up to 5% of feed mixture resulted in a stable process without any indication of long chain fatty acids (LCFA) or free ammonia (NH3) inhibition and in 3.5-fold increase of volumetric biogas production. Contrary, only lipids addition as technical fat (TF) at over 2% of feed mixture resulted in formation of floating granules (FG) and process efficiency decrease. Formed FG had low biodegradability and its organic part was composed of lipi…
BIOALGA reactor: preliminary studies for heavy metals removal
2002
Abstract Microalgae have a high affinity for polyvalent metals, for that reason they could be used to reduce the concentration of heavy metals present in water and wastewater. In the present work an evaluation of a rotary biofilm reactor for algae immobilization (BIOALGA) with the subject of heavy metal removal was investigated. The BIOALGA reactor consisted of a pilot scale model that was operated with synthetic wastewater with an initial concentration of 3000 μg/l of cobalt ion. Scenedesmus obliquus was immobilized in the reactor, which was operated in batch mode for a period of 20 days. The rotary velocity used, 2 rpm, was constant during the experiment. A maximum removal of cobalt ion o…
PURIFICATION OF HARDWOOD-DERIVED AUTOHYDROLYSATES
2012
Carbohydrate-containing hydrolysates (1.1 to 14.9% of wood dry matter) obtained from autohydrolysis (at 130 to 150°C for 30 to 120 minutes) of birch (Betula pendula) chips prior to pulping were purified with respect to non-carbohydrate materials, without carbohydrate losses, either by ethyl acetate extraction or XAD-4 resin treatment. In the former case, about 50% of lignin and practically all the furanoic compounds (2-furaldehyde and 5-(hydroxymethyl)furfural) could be removed, whereas in the latter case, the corresponding amounts were about 30% and 50 to 90%, respectively. A partial recovery of various unsaturated impurities is of importance, because they may act as inhibitors when bioche…
Influence of volatile solids and pH for the production of volatile fatty acids: batch fermentation tests using sewage sludge
2021
The aim of this work was to study the effect of volatile suspended solid (VSS) and pH on volatile fatty acids (VFA) production from waste activated sludge (WAS) fermentation by means of batch tests. The final goal was to gain insights to enhance VFA stream quality, with the novelty of using WAS with high sludge retention time. Results revealed that the optimum conditions to maximize VFAs and minimize nutrients and non-VFA sCOD are a VSS concentration of 5.9 g/L and initial pH adjustment to pH 10. The WAS bacterial community structures were analysed according to Next Generation Sequencing (NGS) of 16S rDNA amplicons. The results revealed changes of bacterial phyla abundance in comparison wit…
Water reuse from wastewater treatment: The transition towards circular economy in the water sector
2022
Water is crucial for economic development since it interacts with the agricultural, production, and energy sec-tors. However, the increasing demand and climate change put pressure on water sources. This paper argued the necessity of using reclaimed water for irrigation within the scope of a circular economy. The barriers (i.e., technological and economic, institutional/regulatory, and social) to water reuse practices were revealed. Lessons on how to overcome the barriers were learned from good practices. The roadmaps adopted in the European Union for the transition towards the circular economy were reviewed. It has been observed that these roadmaps are generally on the circularity of solid …
Nitrous oxide from integrated fixed-film activated sludge membrane bioreactor: Assessing the influence of operational variables
2017
The influence of the main operational variables on N2O emissions from an Integrated Fixed Film Activated Sludge University of Cape Town membrane Bioreactor pilot plant was studied. Nine operational cycles (total duration: 340 days) were investigated by varying the value of the mixed liquor sludge retention time (SRT) (Cycles 1â3), the feeding ratio between carbon and nitrogen (C/N) (Cycles 4â6) and simultaneously the hydraulic retention time (HRT) and the SRT (Cycles 7â9). Results show a huge variability of the N2O concentration in liquid and off-gas samples (ranged from 10â1μg N2O-N Lâ1to 103μg N2O-N Lâ1). The maximum N2O concentration (1228 μg N2O-N Lâ1) in the off-gas sa…
Greenhouse gases from sequential batch membrane bioreactors: A pilot plant case study
2016
Abstract The paper reports the results of nitrous oxide (N 2 O) emissions from aerobic and anoxic tank of a Sequential Batch Membrane Bioreactor (SB-MBR) pilot plant. The influence of salinity variation on N 2 O emission was analyzed by gradually increasing the inlet salt concentration from 0 to 10 g NaCl L −1 . The observed results showed that the N 2 O concentration of the gaseous samples was strongly influenced by the salt concentration. This result was likely related to a worsening of the nitrification activity due to the effect of salinity on autotrophic bacteria. Dissolved oxygen concentration and salinity were found to be the key factors affecting N 2 O concentration in the gaseous s…
Mathematical and numerical modeling of an airlift perfusion bioreactor for tissue engineering applications
2022
The Tissue Engineering (TE) strategy is widely focused on the development of perfusion bioreactors to promote the production of three-dimensional (3D) functional tissues. To optimize tissue production, it is worth investigating the engineering parameters of a bioreactor system for identifying a beneficial range of operation variables. Mathematical and numerical modeling of a perfusion bioreactor is capable to provide relevant insights into the fluid flow and nutrients transport while predicting experimental data and exploring the impact of changing operating parameters, such as fluid velocities. In this work, the hydrodynamic parameters and oxygen transport were investigated using mathemati…