Search results for "Brillouin"
showing 10 items of 96 documents
Hybrid DFT calculations of the atomic and electronic structure for ABO3 perovskite (001) surfaces
2005
Abstract We present the results of first-principles calculations on two possible terminations of the (0 0 1) surfaces of SrTiO3, BaTiO3, and PbTiO3 perovskite crystals. Atomic structure and the electronic configurations were calculated for different 2D slabs, both stoichiometric and non-stoichiometric, using hybrid (B3PW) exchange-correlation technique and re-optimized basis sets of atomic (Gaussian) orbitals. Results are compared with previous calculations and available experimental data. The electronic density distribution near the surface and covalency effects are discussed in details for all three perovskites. Both SrTiO3 and BaTiO3 (0 0 1) surfaces demonstrate reduction of the optical …
Direction-dependent elastic properties and phononic behavior of PMMA/BaTiO 3 nanocomposite thin films
2017
Determination of the anisotropic mechanical properties of nanostructured hybrid films is of great importance to improve fabrication and to enable reliable utility. Here, we employ spontaneous Brillouin light spectroscopy to record the phononic dispersion relation along the two symmetry directions in a supported PMMA (poly(methylmethacrylate))-BaTiO3 hybrid superlattice (SL) with a lattice constant of about 140 nm. Several dispersive elastic modes are resolved for in-plane wave propagation, whereas along the periodicity direction the SL opens a wide propagation stop band for hypersonic phonons and near UV photons both centered at about 280 nm. A thorough theoretical analysis based on the fin…
Self-phase modulation-based 2R regenerator including pulse compression and offset filtering for 42.6 Gbit/s RZ-33% transmission systems
2009
International audience; We report on the experimental and theoretical study of a self-phase-modulation-based regenerator at 42.6 Gbit/s with a return-to-zero 33% format. We point out some detrimental effects such as intrachannel interactions and Brillouin scattering. An efficient solution, relying on a self-phase-modulation-based pulse compressor in combination with the regenerator, is proposed to overcome these detrimental phenomena. The experimental demonstration shows the effectiveness of a wavelength-transparent regenerator at 42.6 Gbit/s with a sensitivity-improvement of more than 5 dB and an eye-opening improvement of 2.3 dB in a back-to-back configuration, as well as a 10 times maxim…
Transform-limited pulses generated by an actively Q-switched distributed fiber laser.
2008
A single-mode, transform-limited, actively Q-switched distributed-feedback fiber laser is presented, based on a new in-line acoustic pulse generator. Our technique permits a continuous adjustment of the repetition rate that modulates the Q factor of the cavity. Optical pulses of 800 mW peak power, 32 ns temporal width, and up to 20 kHz repetition rates were obtained. The measured linewidth demonstrates that these pulses are transform limited: 6 MHz for a train of pulses of 10 kHz repetition rate, 80 ns temporal width, and 60 mW peak power. Efficient excitation of spontaneous Brillouin scattering is demonstrated.
Experimental evidence of Brillouin-induced polarization wheeling in highly birefringent optical fibers
2009
International audience; We study the influence of Stimulated Brillouin Scattering on the polarization stabilization of a light beam propagating in a highly-birefringent optical fiber. In particular, due to a saturation effect, we find that the output polarization lies on a ring when the polarization is represented onto the Poincaré sphere.
Demonstration of polarization pulling using a fiber-optic parametric amplifier
2012
International audience; We report the observation of all-optical polarization pulling of an initially polarization-scrambled signal using parametric amplification in a highly nonlinear optical fiber. Broadband polarization pulling has been achieved both for the signal and idler waves with up to 25 dB gain using the strong polarization sensitivity of parametric amplifiers. We further derive the probability distribution function for the final polarization state, assuming a randomly polarized initial state, and we show that it agrees well with the experiments.
Peregrine soliton generation and breakup in standard telecommunications fiber
2011
International audience; We present experimental and numerical results showing the generation and breakup of the Peregrine soliton in standard telecommunications fiber. The impact of non-ideal initial conditions is studied through direct cut back measurements of the longitudinal evolution of the emerging soliton dynamics, and is shown to be associated with the splitting of the Peregrine soliton into two subpulses, with each subpulse itself exhibiting Peregrine soliton characteristics. Experimental results are in good agreement with simulations.
Steady state γ-ray radiation effects on Brillouin fiber sensors
2015
International audience; Brillouin optical time-domain analysis (BOTDA) sensors offer remarkable advantages for the surveillance of the planned French deep geological radioactive wastes repository, called Cigéo1,2. In this work we study the performances of Brillouin distributed sensors in harsh environment. We evaluate the radiation tolerance of different sensor classes and their responses evolution during γ-ray exposition with 1kGy/h dose rate (to reach ~0.2MGy) and after 1, 3, 6 and 10 MGy accumulated doses. Measurements on strained Ge-doped SMF are reported to highlight the variation on Brillouin scattering proprieties, both intrinsic frequency position of Brillouin shift and its dependen…
CARACTÉRISATION ET MODÉLISATION DE PEIGNES DE FRÉQUENCES KERR DANS DES CAVITÉS LASER BRILLOUIN À FIBRE
2022
Nous étudions une cavité en anneau non réciproque simple et reconfigurable pour générer des peignes de fréquences optiques accordables. Nous démontrons que des peignes cohérents peuvent être obtenus en exploitant finement la rétrodiffusion Brillouin stimulée et le mélange à quatre ondes en cascade dans la cavité à fibre non-linéaire.
Self-sustained coherent phonon generation in optomechanical cavities
2016
Optical forces can set tiny objects in states of mechanical self-sustained oscillation, spontaneously generating periodic signals by extracting power from steady sources. Miniaturized self-sustained coherent phonon sources are interesting for applications such as mass-force sensing, intra-chip metrology and intra-chip time-keeping among others. In this paper, we review several mechanisms and techniques that can drive a mechanical mode into the lasing regime by exploiting the radiation pressure force in optomechanical cavities, namely stimulated emission, dynamical back-action, forward stimulated Brillouin scattering and self-pulsing.