Search results for "CAPI"
showing 10 items of 2622 documents
Quantitative analysis of broad molecular weight distributions obtained by matrix-assisted laser desorption ionisation-time-of-flight mass spectrometry
1996
In order to quantify the error of matrix-assisted laser desorption ionisation (MALDI) time-of-flight (TOF) mass spectrometry in the determination of broad molecular weight distributions, different mixtures by weight of two poly(methyl methacrylate) standards were prepared. These mixtures, with well-defined bimodal molecular weight distributions were analysed by MALDI-TOF mass spectrometry using different matrices (2,4,6-trihydroxyacetophenone and 2,5-dihydroxybenzoic acid) and different cations (Li+, Na+, K+, Rb+ and Cs+) for doping the analyte. From the MALDI-TOF mass spectrometric data, the weight fractions of the two polymers of all mixtures were determined and compared to the values mea…
Temperature-Responsive Surface Coatings Based on Poly(methylsilsesquioxane)-hybrid Polymers
2007
The present paper presents a new method to build up temperature-responsive surfaces. First a poly(silsesquioxane)-block-poly(N-isopropyl-acrylamide) (PMSSQ-b-PNIPAM) was successfully synthesized using RAFT polymerization. Spin-coating or dip-coating of PMSSQ-b-PNIPAM onto glass surfaces resulted in temperature-responsive surfaces. Surface ATR FT-IR measurements proofed the successful surface modification using PMSSQ-b-PNIPAM. IR fine structures of PNIPAM and PMSSQ could be assigned, respectively. In capillary rise experiments a change of the meniscus height measured at temperatures below or above LCST was observed, indicating a different wetting behavior. Thus, a simple spin- or dip-coating…
Determining sulfur-containing amino acids by capillary electrophoresis: A fast novel method for total homocyst(e)ine human plasma
1999
A high-performance capillary electrophoresis (HPCE) method based on laser-induced fluorescence detection is presented here. It enables the determination of sulfur-containing amino acids within 15 min. Fluorescence of sulfur-containing amino acids in plasma is linear over a range of 50-150 micromol/L for L-methionine, 5-100 micromol/L for L-homocysteine, and 50-200 micromol/L for L-cysteine. For homocysteine, we were able to detect 1 fmol injected, equivalent to a plasma concentration of 10 nmol/L. A similar sensitivity is present for cysteine, an even lower one being found for methionine. The intra- and interassay relative standard deviations are < 1%. High-performance liquid chromatography…
Novel acrylamido monomers with higher hydrophilicity and improved hydrolytic stability: III. DNA separations by capillary electrophoresis in poly(N-a…
1996
Separation of DNA fragments in a novel polymer network, consisting of N-acryloylaminopropanol (AAP) is reported. The performance of this novel monomer, as a sieving liquid polymer in capillary zone electrophoresis, was evaluated. In 50 microns ID capillaries, an 8% solution of poly (AAP) can afford apex-resolution of the 123/124 bp adjacent pair of DNA fragments in marker V, typically unresolved in any poly (acrylamide) formulation. It is proposed that the distal-OH group in the AAP molecule can form transient H-bonds with the DNA double helix. Molecular modeling shows a meandering structure for poly (AAP), lacing the walls of half a cylinder, with kinks protruding at regular intervals, pot…
Capillary Rise in Nanotubes Coated with Polymer Brushes
2009
The spontaneous rise of a fluid in a brush-coated nanocapillary is studied by molecular dynamics simulation of a coarse-grained model. The cases of changing wettability of both the capillary walls and the brush were examined. We also investigated the impact of polymer chain length on the transport of fluid along the nanotube. We found that capillary filling takes place in both lyophilic and lyophobic tubes, provided that the polymer brush coating is wetted by the fluid. In all the cases studied, capillary rise proceeds by a time-square law, but the mechanisms behind them (Lucas-Washburn or diffusive propagation) differ, depending on the chain length N. For a wettable wall, the speed of flui…
Capillary electroendoosmotic chromatography of peptides
2000
This review focuses on the current state of peptide separation by capillary electroendoosmotic chromatography (CEC). When carried out under optimised conditions, peptide separation by CEC methods represents an orthogonal and complementary technique to micro-HPLC (micro-HPLC) and high-performance capillary zone electrophoresis (HPCZE). The origin of the selectivity differences that can be achieved with these three separation techniques (CEC, micro-HPLC and HPCZE), respectively are discussed, and the current limits of performance with CEC methods documented. Peptide separations by CEC methods with n-alkyl bonded silicas or mixed-mode phases are also illustrated. The development of different v…
Orientational ordering transitions of semiflexible polymers in thin films: A Monte Carlo simulation
2011
Athermal solutions (from dilute to concentrated) of semiflexible macromolecules confined in a film of thickness D between two hard walls are studied by means of grand-canonical lattice Monte Carlo simulation using the bond fluctuation model. This system exhibits two phase transitions as a function of the thickness of the film and polymer volume fraction. One of them is the bulk isotropic-nematic first-order transition, which ends in a critical point on decreasing the film thickness. The chemical potential at this transition decreases with decreasing film thickness ("capillary nematization"). The other transition is a continuous (or very weakly first-order) transition in the layers adjacent …
Interfaces in immiscible polymer blends: A Monte Carlo simulation approach on the CRAY T3E
1999
Polymeric materials pose a challenge for Monte Carlo simulations because of the widely spread length and time scales involved. Using large scale computer simulations we investigate the interfacial structure in a partially compatible polymer mixture. The problem is studied in the framework of a coarse grained lattice model - the bond fluctuation model on the simple cubic lattice, choosing N = 32 and lattice linear dimensions L × L × D up to 512 × 512 × 64. We employ a two dimensional geometric decomposition scheme to implement this algorithm on the CRAY T3E. The algorithm scales very well with the number of processors. The structure of polymer coils near interfaces between coexisting phases …
Biopartitioning micellar chromatography: An alternative high-throughput method for assessing the ecotoxicity of anilines and phenols
2007
An investigation of the use of the chromatographic retention (log k) as an in vitro approach for modelling the toxicity to Fathead Minnows of anilines and phenols is developed. A data set of 65 compounds with available experimental toxicity data was used. Log k data at three pH values were used for the compounds classification and two groups or 'MODEs' were identified. For one 'MODE' a quantitative retention-activity relationship (QRAR) model was calculated. Finally, it was used to estimate the toxicity to Fathead minnows of anilines and phenols for which experimental data are not available. These estimations were compared to those obtained from another toxicity (to Tetrahymena pyriformis) …
Rapid characterization of alkylpolyphosphonates by CZE with indirect photometric and mass spectrometric detection.
2006
Methods for the rapid characterization of industrial alkylpolyphosphonates (APPs) by infusion MS and CZE with indirect photometric (IPD) and MS detection are described. Technical-grade APPs, including alkylaminepolyphosphonates with 3-5 phosphonate groups and different hydrocarbon skeletons, hydroxyethyl-amino-bis(methylenephosphonic acid), hydroxyethylidene-diphosphonic acid, and 2-phosphonobutane-1,2,4-tricarboxylic acid, were examined. A 10 mM solution of adenosine triphosphate disodium salt at pH 2.2 was used as BGE. The nominal compounds of the industrial APPs and their impurities were well resolved in less than 15 min. The peaks were identified by using extracted ion electropherograms…