Search results for "CIRCUIT"
showing 10 items of 936 documents
CNT-based RFID passive gas sensor
2011
Summary form only given, as follows. Single-wall carbon nanotube (CNT) is examined for the design of a passive and maintenance-free wireless RFID sensor. CNT buckypaper is characterized from a dielectric and a sensitivity point of view, using an indirect way, by using antenna measurement and simulations in a controlled medium. A CNT-based prototype RFID tag is then described as the featured maintenance free sensor and experimentally verified for its applicability and sensitivity towards NH3.
Investigation of recovery mechanisms in dye sensitized solar cells
2016
Abstract We study the spontaneous recovery phenomenon displayed by solar cells sensitized with a ruthenium complex-based dye N719, which manifests with the increase over the time (from several minutes up to some days) of the short circuit current density J sc and the open circuit voltage V oc , during cell illumination. Under dark conditions the current decreases over time after the application of forward bias voltages. We investigate the effects of temperature and electrolyte composition by means of current–voltage measurements and electrochemical impedance spectroscopy, both under dark and illumination conditions. The main result is that the recovery of the performances depends on the cha…
Hybrid Tribo-Piezo-Electric Nanogenerator with Unprecedented Performance Based on Ferroelectric Composite Contacting Layers
2019
This research was supported by the European Regional Development Fund within the project ‘‘Hybrid energy harvesting systems’’ 1.1.1.1./16/A/013.
A subthreshold, low-power, RHBD reference circuit, for earth observation and communication satellites
2015
A low-power, wide temperature range, radiation tolerant CMOS voltage reference is presented. The proposed reference circuit exhibits a voltage deviation of 0.8mV for 3-MeV protons total ionization dose of 2Mrad and a voltage deviation of 3.8mV for 10-keV X-rays total ionization dose of 4Mrad while being biased at the nominal supply voltage of 0.75V during X-ray irradiation. In addition, the circuit consumes only 4μW and exhibits a measured Temperature Drift of 15ppm/°C for a temperature range of 190°C (−60°C to 130°C) at the supply voltage of 0.75V. It utilizes only CMOS transistors, operating in the subthreshold regime, and poly-silicon resistors without using any diodes or external compon…
A General Methodology for Short-circuit Calculations in Hybrid AC/DC Microgrids
2023
In this paper, the issues related to short-circuit calculations in hybrid AC/DC microgrids are discussed. The reference standard for short-current calculations in DC systems is the IEC 61660, which provides a mathematical formulation of the problem. The standard only includes radial DC grids and does not consider a more complex system, such as meshed DC systems or a hybrid AC/DC microgrid. This paper proposes a generalized approach that can be used independently of the characteristics of the hybrid system. The proposed approach is applied to four test microgrids with different distributed sources and number of nodes and the results are compared with those obtained simulating the same grids …
Modelling, Simulation and Characterization of a Supercapacitor in Automotive Applications
2022
In the energy storage field, supercapacitors (SCs) are gaining more and more attention thanks to features such as high-power density, high life cycles and lack of maintenance. In this article, an improved SC three-branches model which considers the residual charge phenomenon is presented. The procedure to estimate the model parameters and the related experimental set-up are presented. The parameter estimation procedure is repeated for several SCs of the same type. The average parameters are then obtained and used as initial guesses for a recursive least square optimization algorithm, to increase the accuracy of the model. The model of a single SC is then extended to SC banks, testing differ…
A fast heuristic for solving the D1EC coloring problem
2010
In this paper we propose an efficient heuristic for solving the Distance-1 Edge Coloring problem (D1EC) for the on-the-fly assignment of orthogonal wireless channels in wireless as soon as a topology change occurs. The coloring algorithm exploits the simulated annealing paradigm, i.e., a generalization of Monte Carlo methods for solving combinatorial problems. We show that the simulated annealing-based coloring converges fast to a sub optimal coloring scheme even for the case of dynamic channel allocation. However, a stateful implementation of the D1EC scheme is needed in order to speed-up the network coloring upon topology changes. In fact, a stateful D1EC reduces the algorithm’s convergen…
A New ESO-Based Method to Find the Optimal Topology of Structures Subject to Multiple Load Conditions
2014
In the field of topology optimization problems, the Evolutionary Structural Optimization (ESO) method is one of the most popular and easy to use. When dealing with problems of reasonable difficulty, the ESO method is able to give very good results in reduced times and with a limited request of computational resources. Generally, main applications of this method are addressed to the definition of the optimal topology of a component subjected to a single load condition. In this work, a new methodology, based on the ESO approach, is introduced for the study of the optimal topology of a component subjected to multiple load conditions. The new procedure, entirely developed in the APDL programmin…
GRASP with path relinking heuristics for the antibandwidth problem
2010
This article proposes a linear integer programming formulation and several heuristics based on GRASP and path relinking for the antibandwidth problem. In the antibandwidth problem, one is given an undirected graph with n nodes and must label the nodes in a way that each node receives a unique label from the set {1, 2,…,n}, such that, among all adjacent node pairs, the minimum difference between the node labels is maximized. Computational results show that only small instances of this problem can be solved exactly (to optimality) with a commercial integer programming solver and that the heuristics find high-quality solutions in much less time than the commercial solver. © 2010 Wiley Periodic…
Influence of losses partition criteria on power flow tracing
2012
The paper proposes a methodology for tracing active power flow which also considers power losses partition. It requires the partition of the active power losses in each line over different flow components. Then, the differences arising from the selection of different criteria for the allocation of the mutual terms (deriving from the non-linearity of losses) are investigated. Power flows tracing and losses allocation at each generator (or load) must be carried out simultaneously; therefore, a suitable order is required for the analysis of nodes and lines in a network. A procedure for the direct evaluation of all the components of the power flows and of the losses in the lines assigned to the…