Search results for "COMPOSITE"
showing 10 items of 4584 documents
Ionic transport and heat capacity of glass-forming metalnitrate mixtures
1997
Abstract Ionic transport of the glass-forming metalnitrate mixtures [Ca(NO 3 ) 2 ] 0.44 [KNO 3 ] 0.56 (MKN), and [Mg(NO 3 ) 2 ] 0.44 [NaNO 3 ] 0.56 (MNN) was investigated near the glass transition using broadband spectroscopy of the complex conductivity to 300 MHz. The real part of the conductivity exhibits a transition from frequency independent to power law behavior as found in most ionic conductors. At high frequencies the frequency exponent approaches unity and becomes larger at low temperatures. In the real part of the dielectric constant, a relaxation step could be observed in CRN. A detailed evaluation of the results within the modulus formalism is presented. The imaginary part of t…
Measuring the Contact Angle of Individual Colloidal Particles.
1998
The aim of this study was to measure the contact angles of individual colloidal spheres ( solidus in circle 4.4 µm) and compare it to contact angles obtained on similarly prepared planar surfaces. For this purpose the particles were attached to atomic force microscope cantilevers. Then the force between the particle in aqueous medium and an air bubble was measured versus the distance. From the resulting force curves we obtained contact angles and detachment forces of single particles. Contact angles of gold coated silica particles were adjusted between 20 degrees and 100 degrees by self-assembling monolayers from different mixtures of undecanethiols and omega-hydroxy undecanethiols from sol…
Solvent induced single-crystal to single-crystal structural transformation and concomitant transmetalation in a 3D cationic Zn(II)-framework.
2015
A 3D cationic Zn(II) framework, based on Zn2(CO2)4 paddle-wheel secondary building units (SBUs) and Zn16(CO2)32 polyhedral supramolecular building blocks (SBBs), has been synthesized. At room temperature, the framework undergoes guest solvent triggered reversible structural transformation and concomitant Zn(II) to Cu(II) transmetalation in a single-crystal to single-crystal fashion.
Effect of the Al/Si atomic ratio on surface and structural properties of sol-gel prepared aluminosilicates
2003
Abstract A series of aluminosilicates with an Al/Si ratio ranging from 0 to ∞ (0 for pure silica and ∞ for pure alumina) was prepared by sol–gel process and characterized by surface and structure techniques. Aluminum tri sec butoxide and tetramethylorthosilicate were used as precursors for the sol–gel synthesis. The acidic properties of the oxides were studied by determination of the zero point charges, through mass titration method, and, for selected samples, by FT-IR spectroscopy of adsorbed pyridine used as a probe for both Bronsted and Lewis acidity. A dependence of the acidity on the Al/Si atomic ratio was found. According to the X-ray diffraction patterns, all the oxides have an amorp…
Associations Between Built Environment Characteristics and Walking in Older Adults in a High-Density City: A Study From a Chinese Megacity
2020
The built environment is an important factor affecting physical activity, especially walkability. Walkability is used to characterize the user friendliness of outdoor physical activity. However, studies on walkability and physical activity are mainly concentrated on low-density Western cities. Study on the walkability of high-density cities in Asia, especially with the elderly, is seriously lacking. And walkability is often used as a composite indicator. This study mainly re-examines the relationship between the common indicators of walkability (population density, street connectivity, land-use mix, and retail density), transport-related walking, and leisure-time walking with older adults i…
Triplet exciplexes as energy transfer photosensitisers
2006
Experimental evidence is provided for the occurrence of triplet–triplet energy transfer from benzoylthiophene–indole exciplexes to naphthalenes with a remarkable stereodifferentiation; chiral recognition is also observed in the decay of the generated naphthalene triplets. Perez Prieto, Julia, Julia.Perez@uv.es ; Galian, Raquel Eugenia, Raquel.Galian@uv.es ; Morant Miñana, Maria Carmen, Maica.Morant@uv.es
Influence of synthesis conditions on the performance of chitosan–Heteropolyacid complexes as membranes for low temperature H2–O2 fuel cell
2015
Flat, free-standing chitosan/phosphotungstic acid (PTA) polyelectrolyte membranes were prepared by in-situ ionotropic gelation process at room temperature on porous alumina support firstly impregnated by H3PW12O40. Scanning electron microscopy revealed the formation of compact and homogeneous membranes, whose thickness resulted to be dependent on chitosan concentration and reticulation time. X-ray diffraction and Fourier transform infrared spectroscopy (FTIR) evidenced the formation of almost amorphous membrane without appreciable concentration of not protonated NH2 groups and PTA3- ions with preserved Keggin structure. Membranes were tested as proton conductor in low temperature H2-O2 fuel…
Chitosan-phosphotungstic acid complex as membranes for low temperature H2-O2 fuel cell
2015
Abstract Free-standing Chitosan/phosphotungstic acid polyelectrolyte membranes were prepared by an easy and fast in-situ ionotropic gelation process performed at room temperature. Scanning electron microscopy was employed to study their morphological features and their thickness as a function of the chitosan concentration. The membrane was tested as proton conductor in low temperature H 2 –O 2 fuel cell allowing to get peak power densities up to 350 mW cm −2 . Electrochemical impedance measurements allowed to estimate a polyelectrolyte conductivity of 18 mS cm −1 .
Layered composite based on halloysite and natural polymers: a carrier for the pH controlled release of drugs
2019
We have prepared new biohybrid materials based on halloysite nanotubes and natural polymers (alginate and chitosan) for the controlled and sustained release of bioactive species. A functional nanoarchitecture has been designed allowing us to generate a layered tablet with a chitosan/halloysite nanocomposite film sandwiched between two alginate layers. The assembly of the raw components and the final structure of the hybrid tablet have been highlighted by the morphological and wettability properties of the prepared materials. Since the biohybrid has been designed as a smart carrier, halloysite nanotubes have been first loaded with a model drug (sodium diclofenac). The effect of the tablet th…
Lipid Nanocarriers-Loaded Nanocomposite as a Suitable Platform to Release Antibacterial and Antioxidant Agents for Immediate Dental Implant Placement…
2021
Immediate implant placement is a single-stage restorative approach for missing teeth widely used to overcome the ridge remodeling process occurring after dental extractions. The success of this procedure relies on opportune osseointegration in the surrounding tissues. To support this process, a multifunctional nanocomposite, to be applied in the fresh post-extraction socket, was here designed, prepared, and characterized. This formulation consists of quercetin (QRC)-loaded nanostructured lipid carriers (NLCs) entrapped in a chitosan-based solid matrix containing ciprofloxacin (CPX). QRC-NLCs were prepared by homogenization followed by high-frequency sonication, and thereafter this dispersio…