Search results for "COMPOSITE"
showing 10 items of 4584 documents
Bleaching of optical activity induced by UV Laser exposure in natural silica
2004
We report experimental data on two types of natural silica, differing for their OH content, irradiated with UV photons (4.66 eV) from a pulsed Nd:YAG laser. Irradiation induces a reduction of the absorption band at 5.12eV and of the associated emissions at 3.14eV and 4.28eV, ascribed to twofold coordinated Ge (=Ge'') centers pre-existing in our samples. The bleaching is mainly due to the post-irradiation conversion of =Ge'' into the paramagnetic H(II) center via trapping of a H atom. Comparison with literature data points out the peculiarities of silica with a low Ge concentration as regards UV induced transformations.
Spectroscopic parameters related to non bridging oxygen hole centers in amorphous-SiO2
2005
The relationship between the luminescence at 1.9 eV and the absorption bands at 2.0 eV and at 4.8 eV were investigated in a wide variety of synthetic silica samples exposed to different gamma- and beta-ray irradiation doses. We found that the intensities of these optical bands are linearly correlated in agreement with the model in which they are assigned to a single defect. This finding allows to determine spectroscopic parameters related to optical transitions efficiency: the oscillator strength of the 4.8 eV results ~200 times higher than that of the 2.0 eV; the 1.9 eV luminescence quantum yield under 4.8 eV excitation is lower (by a factor ~3) than that under 2.0 eV excitation. These res…
Bending-Induced Delamination of van der Waals Solids
2013
Although sheets of layered van der Waals solids offer great opportunities to custom-design nanomaterial properties, their weak interlayer adhesion challenges structural stability against mechanical deformation. Here, bending-induced delamination of multilayer sheets is investigated by molecular dynamics simulations, using graphene as an archetypal van der Waals solid. Simulations show that delamination of a graphene sheet occurs when its radius of curvature decreases roughly below $R_c=5.3\text{nm}\times (\text{number of layers})^{3/2}$ and that, as a rule, one-third of the layers get delaminated. These clear results are explained by a general and transparent model, a useful future referenc…
High-pressure x-ray diffraction study of SrMoO4 and pressure-induced structural changes
2007
SrMoO4 was studied under compression up to 25 GPa by angle-dispersive x-ray diffraction. A phase transition was observed from the scheelite-structured ambient phase to a monoclinic fergusonite phase at 12.2(9) GPa with cell parameters a = 5.265(9) A, b = 11.191(9) A, c = 5.195 (5) A, and beta = 90.9, Z = 4 at 13.1 GPa. There is no significant volume collapse at the phase transition. No additional phase transitions were observed and on release of pressure the initial phase is recovered, implying that the observed structural modifications are reversible. The reported transition appeared to be a ferroelastic second-order transformation producing a structure that is a monoclinic distortion of t…
Optical properties of Ge-oxygen defect center embedded in silica films
2007
The photo-luminescence features of Ge-oxygen defect centers in a 100nm thick Ge-doped silica film on a pure silica substrate were investigated by looking at the emission spectra and time decay detected under synchrotron radiation excitation in the 10-300 K temperature range. This center exhibits two luminescence bands centered at 4.3eV and 3.2eV associated with its de-excitation from singlet (S1) and triplet (T1) states, respectively, that are linked by an intersystem crossing process. The comparison with results obtained from a bulk Ge-doped silica sample evidences that the efficiency of the intersystem crossing rate depends on the properties of the matrix embedding the Ge-oxygen defect ce…
Effects of pressure on the local atomic structure of CaWO4 and YLiF4: mechanism of the scheelite-to-wolframite and scheelite-to-fergusonite transitio…
2003
The pressure response of the scheelite phase of CaWO4 (YLiF4) and the occurrence of the pressure induced scheelite-to-wolframite (M-fergusonite) transition are reviewed and discussed. It is shown that the change of the axial parameters under compression is related with the different pressure dependence of the W-O (Li-F) and Ca-O (Y-F) interatomic bonds. Phase transition mechanisms for both compounds are proposed. Furthermore, a systematic study of the phase transition in 16 different scheelite ABX4 compounds indicates that the transition pressure increases as the packing ratio of the anionic BX4 units around the A cations increases.
Reptation and constraint release
1991
Abstract The reptation and constraint release models are discussed by considering three recent experimental examples: (1) the diffusion of hydrogenated polybutadiene in matrices of molecular weights raning between 1 ⩽ Mw / Me ⩽ 253; (2) the diffusion of polystyrene (PS) chains in matrices of star branched PS; (3) the diffusion of very long PS chains in chemically cross-linked PS-networks. It is concluded that the reptation and constraint release models are applicable, but ‘constraint release’ should be understood in a wider sense allowing for non-reptative removal of barriers to lateral chain motion. The analysis of the third example proves that lateral modes of motion have a negligible inf…
Direct chill casting of aluminium alloys under electromagnetic interaction by permanent magnet assembly
2018
Direct chill casting is one of the methods used in industry to obtain good microstructure and properties of aluminium alloys. Nevertheless, for some alloys grain structure is not optimal. In this study, we offer the use of electromagnetic interaction to modify melt convection near the solidification interface. Solidification under various electromagnetic interactions has been widely studied, but usually at low solidification velocity and high thermal gradient. This type of interaction may succeed fragmentation of dendrite arms and transport of solidification nuclei thus leading to improved material structure and properties. Realization of experimental small-scale crystallizer and electromag…
Method of quantitative analysis of filler dispersion in composite systems with spherical inclusions
2011
In this work, a quantitative analysis method for the estimation of filler dispersion degree of filler particles in composite systems is presented and described. According to the procedure offered dispersion of filler particles of any form is associated with their area and the dispersion parameter D is defined as the probability to fall in a certain range of the particle area distribution. The method has been applied to both model and real systems characterized by different dispersion levels and various filler content. Final results highlight that for the case of better filler dispersion, the characteristic parameter, D, increases, since the quantity of filler particles having identical area…
Molecular-dynamics study of copper with defects under strain
1998
Mechanical properties of copper with various types of defects have been studied with the molecular-dynamics method and the effective-medium theory potential both at room temperature and near zero temperature. The loading has been introduced as constant rate straining and the dynamics of the process region of fracture is purely Newtonian. With the model three types of defects were studied: point defects, grain boundary, and an initial void serving as a crack seed. Point defects were seen to decrease the system strength in terms of fracture stress, fracture strain, and elastic modulus. Due to random microstructure, highly disordered systems turned out to be isotropic, which on the other hand …