Search results for "CTR"
showing 10 items of 51210 documents
High-Power Multicarrier Generation for RF Breakdown Testing
2017
Testing of satellite components for high RF power breakdown effects, such as multipactor and corona or passive-intermodulation, is a topic of growing interest in the aerospaceindustry. Switching fromthe classical single carrier approach to the more realisticmulticarrier scenario is very challenging from the experimental point of view. Themulticarrier signals, amplifiedby several RF power amplifiers, need to have controlled phase, amplitude, and frequency in each carrier. Fine tuning of the signal generator phases is required in order to compensate the phase drift occurring in the active elements of the test bed. This paper presents an efficient and low-cost technique to generate multicarrie…
A fully-digital realtime SoC FPGA based phase noise analyzer with cross-correlation
2017
We report on a fully-digital and realtime operation of a phase noise analyzer using modern digital techniques with cross-correlation. With the advent of system on chip field-programmable gate arrays (SoC FPGAs) embedding hard core central processing unit, coprocessor and FPGA onto a single integrated circuit, the building of sensitive analysis devices for Time & Frequency research is made accessible at virtually no cost and benefits from reconfigurability. Used with high-speed digitizers we have successfully implemented a four-channel system whose preliminary results at 10 MHz shows a residual white noise floor < −185 dBrad2/Hz up to 5 MHz off the carrier, and flicker < −127 dBrad2/Hz using…
Identification of induction motor thermal model for improved drivetrain design
2016
Selection of components of electric drivetrains is not only based on evaluating their ability to perform according to mechanical specifications, but — what is equally important — on assessing their thermal protection limits. These are typically affected by electrical and thermal properties of motors and drives. Although rated parameters (such as power, torque, speed, etc.) are easily accessible in catalogs of equipment producers, more specific properties like mass / length of copper winding, heat dissipation factor, rotor / stator dimensions etc. are not available to customers. Therefore, effective selection of drivetrain components is limited due to the lack of sufficient data and the need…
A Magnetohydrodynamic Auxiliary Propulsion system for docking assistance of autonomous vehicle
2016
In this article we present an approach to the description of Magnetohydrodynamic Auxiliary Propulsion system for docking assistance of autonomous vehicle. Preliminarily, an analytical model which includes an electromagnetic model and a thermal model is presented. Successively, in order to move beyond the analytical model, a 3-D MHD modeling tool and a Runge Kutta method based solver are presented and they are used to investigate an alternative MHD solutions. Some numerical analysis are given
Sensorless control of induction motors using an extended Kalman filter and linear quadratic tracking
2017
Induction motors are the most commonly used prime-movers in industrial applications. Many induction motors supplied by frequency converters are coupled with a physical angular rotor position/velocity sensor which makes the drive complex and require maintenance. This paper presents a sensorless control structure to avoid using a physical angular rotor position/velocity sensor. The proposed method estimates and control the angular rotor velocity using optimal control theory. The optimal controller used in this paper is based on linear quadratic tracking and the states of the machine are estimated using an extended Kalman filter. Both the controller and the estimator utilize the same internal …
The role of structural disorder on luminescence of Eu-doped Na0.5Bi0.5TiO3
2020
A detailed analysis of photoluminescence of Eu-doped Na0.5Bi0.5TiO3 (NBT) is performed using it as a tool for describing the local structure of NBT. The obtained results reveal the low symmetry of the Eu3+ local environment in NBT, as indicated by the observed maximal number of sublevels of the 5D0→7F1 and the 5D0→7F2 luminescence transitions, clearly observed at low temperatures. Approximation of the luminescence spectra by Gaussian peaks provides valuable information about the shift of the involved levels upon change of the excitation wavelength. Variation in the strength of the crystal field in Eu-doped NBT is evaluated. Temperature dependence of the luminescence above room temperature i…
Modeling self-sustaining waves of exothermic dissolution in nanometric Ni-Al multilayers
2016
Abstract The self-sustained propagating reaction occurring in nanometric metallic multilayers was studied by means of molecular dynamics (MD) and numerical modeling. We focused on the phenomenon of the exothermic dissolution of one metallic reactant into the less refractory one, such as Ni into liquid Al. The exothermic character is directly related to a negative enthalpy of mixing. An analytical model based on the diffusion-limited dissolution [1] coupled with heat transfer was derived to account for the main aspects of the process. Together, several microscopic simulations were carried out. The first series were set up to obtain all the parameters governing the process, including the heat…
Resistive communications based on neuristors
2017
Memristors are passive elements that allow us to store information using a single element per bit. However, this is not the only utility of the memristor. Considering the physical chemical structure of the element used, the memristor can function at the same time as memory and as a communication unit. This paper presents a new approach to the use of the memristor and develops the concept of resistive communication.
High‐Quality Si‐Doped β‐Ga 2 O 3 Films on Sapphire Fabricated by Pulsed Laser Deposition
2020
The EU Horizon 2020 project CAMART2 is acknowledged for partly supporting the project, and the Ion Technology Centre, ITC, in Sweden is acknowledged for ion beam analysis (ERDA).
Polarization and acoustic properties of barium-modified lead-free potassium–sodium niobate ceramics
2017
The publication costs of this article were covered by the Estonian Academy of Sciences and the University of Tartu.