Search results for "Calcination"
showing 10 items of 112 documents
In situ carbon and oxygen isotopes measurements in carbonates by fiber coupled laser diode-induced calcination: A step towards field isotopic charact…
2021
International audience; Natural stable isotopes ratios (δ13Ccarb and δ18Ocarb) of carbonates archived in the geological record are routinely used to reconstruct local and global paleo temperatures and the secular evolution of the biogeochemical carbon cycle. The state-of-the-art technique, employed since the mid 20th century, to measure these isotopic ratios starts with field sampling followed by several steps of physical and chemical laboratory preparation including: (i) microdrilling and/or sawing and crushing, (ii) CO2 release by wet acid digestion, (iii) gas equilibration, purification and transfer, before (iv) gas phase IRMS measurements. While these steps are time and resource consumi…
Mo–V–Nb mixed oxides as catalysts in the selective oxidation of ethane
2003
Abstract Mo–V–Nb–O mixed metal oxides, obtained by heat-treatment in N 2 at 425 °C, have been studied as catalysts in the oxidative dehydrogenation of ethane. They present higher catalytic activity, while maintaining the same selectivity to ethylene, than the corresponding metal oxides calcined under air. Both amorphous and crystalline phases are present on active and selective catalysts. The implications of the presence of these phases as well as their physicochemical characteristics on the nature of active and selective sites are discussed.
Photoactivity of Nanostructured TiO2 Catalysts in Aqueous System and their Surface Acid-Base, Bulk and Textural Properties
2007
This work reports on the characterisation and determintion of the photocatalytic activity of some TiO2 catalysts prepared using TiCl4 as precursor. The samples, consisting of suspensions, dispersions or powders of nanonstructured anatase or rutile phases, were obtained in very mild conditions, i.e., by boiling the solution obtained after hydrolysis of TiCl4 at atmospheric pressure: it is worth noting that no calcination was necessary to obtain photoactive phases. The samples were characterised by X-ray diffraction (XRD), determination of the BET specific surface area (SSA), scanning electron microscopy (SEM) observations and diffuse reflectance spectroscopy (DRS). FT-IR spectroscopy was use…
Photoactivity of shape-controlled TiO2 in gas-solid regime under solar irradiation
2019
Abstract Differently shape-controlled anatase TiO2 materials were tested as photocatalysts under both simulated and natural solar irradiation. Their photocatalytic activity in 2-propanol and propene partial oxidation and in the complete mineralization of acetaldehyde appears to increase with decreasing the shape control of the TiO2 material. This insight seems to be related to the residual presence of the templating species (fluoride anions) employed during the preparation of the shape-controlled TiO2 materials. In fact, the calcination of the powders, leading to levelling of the fluoride ions content, but also to a remarkable surface area decrease, gave rise to an increase of photocatalyti…
Preparation, Characterization, and Photoactivity of Polycrystalline Nanostructured TiO2 Catalysts.
2004
Various preparations of nanostructured TiO2 starting from Ti(iso-OC3H7)4 or TiCl4 are reported. The samples were characterized by X-ray diffractometry, specific surface area and porosity determinations, scanning and transmission electron microscopy, and diffuse reflectance spectroscopy. 4-Nitrophenol photodegradation in aqueous medium was employed as a probe reaction to test the photoactivity of the catalysts. The photoactivity of some samples derived from Ti(iso-OC3H7)4 was found comparable with that of commercial powders. Calcination after the hydrolysis process was necessary to achieve crystallization of the particles before using them as photocatalysts for the reaction studied. The samp…
Partial photoelectrocatalytic oxidation of 3-pyridinemethanol by Pt, Au and Pd loaded TiO2 nanotubes on Ti plate
2021
Abstract The photoelectrocatalytic (PEC) oxidation of 3-pyridinemethanol to 3-pyridinemethanal and vitamin B3 was investigated by using Pt, Au and Pd loaded (as single or bimetallic) nanotube structured TiO2 on Ti plate in water under UVA irradiation. Nanotube structured TiO2 on Ti plate samples were prepared as anode by anodic oxidation method in ethylene glycol solution in different times, and then they were calcined at 500 °C to be obtained in crystalline form. The anodes were loaded with noble metals by electrochemical reduction method and characterized by XRD, XPS, SEM, and photocurrent techniques. The TiO2 on the plates was in the anatase phase. The loaded metals were in metallic form…
Novel porous carbon packings in reversed-phase high-performance liquid chromatography
1980
Abstract Porous carbon packings of particle size 5–20 μm were prepared by calcination of purified active carbons and cokes having narrow size ranges. Highly efficient columns packed with 10-μm particles were obtained by means of the high-viscosity slurry technique, and exhibited about 3000 theoretical plates at 100 mm length and optimal eluent flow-rate. The loading of columns, θ0.1, was determined to be 25–50 μg of solute per gram of packing. Eluotropic series of solvents were found to be similar to those on pyrocarbon-modified carbons and silicas. The log k′ values for homologous compounds increased linearly with the hydrocarbonaceous surface area at constant eluent composition. Studies w…
Preparation, characterization and catalytic properties of vanadium oxides supported on calcined Mg/Al-hydrotalcite
1995
Abstract Vanadium oxide supported on calcined hydrotalcite has been investigated for the oxidehydrogenation of n-butane in the 500–550°C temperature interval. Hydrotalcite (Mg/Al atomic ratio of 2.77), consisting of a single phase only, has been employed as a support precursor. The vanadium catalysts (0–50, referred as wt.-% V 2 O 5 ) were prepared by impregnation of calcined hydrotalcite (450°C) with ammonium metavanadate (in an aqueous solution) or vanadyl acetylacetonate (in a methanolic solution), and then calcined at 600°C for 4 h. During the impregnation step, the support is transformed into hydrotalcite if aqueous solutions are used. However, it is not modified if methanolic solution…
Tailored syntheses of nanostructured silicas: Control of particle morphology, particle size and pore size
1998
Ordered mesoporous silicas with spherical morphology and average particle size in the range between 100 nm and 2 μm were synthesised according to two novel routes. Both synthesis routes used tetraethoxysilane, water, alcohol and aqueous ammonia for producing spherical silica beads. The porosity was created by adding two different kinds of pore structure directing agents to the starting solution: one was an n-alkyltrialkoxysilane which was covalently bonded to the silica framework, the other was an n-alkylamine which acted as a nonionic template. After calcination and post treatment the resulting particles showed a specific surface area up to 1000 m2 g-1, a specific pore volume of up to 0.8 …
Synthesis of yttrium aluminum garnet nanoparticles in confined environment, and their characterization
2016
Abstract Nanopowders of yttrium aluminum garnet (YAG, Y3Al5O12) have been prepared by thermal treatment of hydroxides obtained by synthesis in a confined environment constituted by water/Cetyltrimethylammonium bromide (CTAB)/1-butanol/n-heptane. The phase behavior of the above system has been investigated on varying the water/CTAB molar ratio (R) at constant 1-butanol/CTAB and heptane/CTAB molar ratio. The dispersed aqueous phases were constituted by solutions of ammonia and of yttrium and aluminum nitrates, respectively. Measures of Kinematic Viscosity, Electrical Conductivity and Small Angle X-ray Scattering have been carried out. It was found that, on increasing the ammonia solution cont…