Search results for "Calibration"

A novel method for obtaining continuous stopping power curves

2001

Abstract A new method has been developed for obtaining continuous stopping power curves in transmission geometry. In the method both the incident energy of the particle and its energy after passing through the sample foil are extracted directly from the semiconductor detector. Full range of energies is measured simultaneously eliminating step-by-step measurements and providing continuous data. A time-of-flight (TOF) spectrometer provides unambiguous matching of relevant particle groups from the run with and without absorber. Suitable energy distribution of incident particles was achieved by choosing the right thickness and tilting angle of a scattering foil. The method is very fast and reli…

A coded mask for γ-ray astronomy. Design and calibration

2003

Abstract The high-resolution γ-ray spectrometer (SPI) is one of the two main instruments on board the ESA INTEGRAL satellite successfully launched in October 2002. SPI uses coded aperture mask technique in order to have imaging capabilities at the energy band (20 keV–8 MeV) it will study celestial sources. The SPI imaging performance depends critically on the quality of the coded mask response and also on the precise knowledge of such response function. In this paper we present a general description of the SPI Coded Mask design together with its main features. Scientific impact of INTEGRAL SPI Coded Mask design on the instrument capabilities is also discussed. Results obtained for Mask cali…

High resolution Time of Flight determination based on reconfigurable logic devices for future PET/MR systems

2013

Abstract This contribution shows how to perform Time of Flight (TOF) measurements in PET systems using low-cost Field Programmable Gate Array (FPGA) devices with a resolution better of 100 ps. This is achieved with a proper management of the FPGA internal resources and with an extremely careful device calibration process including both temperature and voltage compensation. Preliminary results are reported.

The optical/UV filters for the EPIC experiment

1998

EPIC, the European Photon Imaging Cameras is an experiment based on cooled CCDs on board the ESA X-ray Multi Mirrors satellite due to be launched in 1999. Since CCD's are sensitive to radiation other than X-rays, namely Optical and UV light, filters are necessary to prevent this radiation from reaching the detector sensitive area. Three types of filters were developed, to be used alternatively depending on target source. Here we report on the medium and thin filters developed by MOXTEK Inc. in Orem, Utah, while the thick ones, developed at the Max-Planck-Institut fur Extraterrestrische Physik (MPE, Germany) have been described elsewhere. The two filters, described here, have a 1600 /spl Ari…

Study and simulation of the read-out electronics design for a high-resolution plastic scintillating fiber based hodoscope

2015

Abstract This work presents the study and simulation of a high-resolution charged particle detection device for beam positioning, monitoring and calibration, together with its read-out proposal. To provide the precise positional information of the beam, the detection system has been based on Plastic Scintillating Fibers (PSF), while the read-out on a Silicon-PhotoDiode (Si-PD) array. To carry out the study, a PSF prototype with one detection plane has been experimentally tested with a β particle source. Besides, Monte Carlo simulations of the complete system have also been conducted. Both simulations and experimental tests give consistency to the results obtained. The work presented in this…

Calibration of a neutron time-of-flight multidetector system for an intensity interferometry experiment

2004

We present the details of an experiment on light particle interferometry. In particular, we focus on a time-of-flight technique which uses a cyclotron RF signal as a start and a liquid scintillator time signal as a stop, to measure neutron energy in the range of En approximate to 1.8-150 MeV. This dynamic range (up to 300 ns) is much larger than the beam bunch separation (54 ns) of the AGOR cyclotron (KVI). However, the problem of a short burst period is overcome by using the time information obtained from a fast projectile fragment phoswich detector. The complete analysis procedure to extract the final neutron kinetic energy spectra, is discussed. (C) 2003 Elsevier B.V. All rights reserved.

Efficiency calibration of a Ge(Li) detector by absolute counting of fallout nuclides by means of the 4πβ-γ coincidence method

1975

Abstract The 4 π β - γ coincidence method proves to be very suitable for absolute counting of fallout nuclides. Using such nuclides, absolute calibration of a Ge(Li) detector was carried out for different geometry positions.

Energy calibration and monitoring of the KATRIN experiment

2011

A new high precision voltage divider has been built for monitoring the analysing potential of the KATRIN main spectrometer. In addition a condensed 83mKr calibration source has been set up at the modified 1 eV resolving Mainz spectrometer, our measurements show that energy calibration and monitoring for KATRIN is feasible at the few ppm level.

Nanobeacon and laser beacon: KM3NeT time calibration devices

2015

In-Situ Calibration of UFFO/Lomonosov for Observation of GRBs

2017

The UFFO/Lomonosov has been successfully launched into Sun synchronous orbit and is operational through tests and calibrations since its launch on Apr. 28, 2016. As a pathfinder of UFFO, it will be the first space instrument to use a fast slewing mirror which reduce the trigger latency of optical telescope, less than a second, to explore early time domain of GRB evolution. In this article, we will report in detail the first mission, UFFO/Lomonosov, for the rapid response to observe early photons from GRBs in orbit.