Search results for "Chemical engineering"
showing 10 items of 5892 documents
Comparative study of initial stages of copper immersion deposition on bulk and porous silicon
2013
Initial stages of Cu immersion deposition in the presence of hydrofluoric acid on bulk and porous silicon were studied. Cu was found to deposit both on bulk and porous silicon as a layer of nanoparticles which grew according to the Volmer-Weber mechanism. It was revealed that at the initial stages of immersion deposition, Cu nanoparticles consisted of crystals with a maximum size of 10 nm and inherited the orientation of the original silicon substrate. Deposited Cu nanoparticles were found to be partially oxidized to Cu2O while CuO was not detected for all samples. In contrast to porous silicon, the crystal orientation of the original silicon substrate significantly affected the sizes, dens…
Molybdenum blue: Binding to collagen fibres and microcrystal formation
2005
Collagen fibres have been shown by transmission electron microscopy to progressively bind the polyoxomolybdate ring-complex, termed molybdenum blue. Nucleation of cuboidal molybdenum blue microcrystals occurs on the surface of the collagen fibres, leading eventually to extensive coating of the fibres with microcrystals.
Optical determination and identification of organic shells around nanoparticles: application to silver nanoparticles
2013
We present a simple method to prove the presence of an organic shell around silver nanoparticles. This method is based on the comparison between optical extinction measurements of isolated nanoparticles and Mie calculations predicting the expected wavelength of the Localized Surface Plasmon Resonance of the nanoparticles with and without the presence of an organic layer. This method was applied to silver nanoparticles which seemed to be well protected from oxidation. Further experimental characterization via Surface Enhanced Raman Spectroscopy (SERS) measurements allowed to identify this protective shell as ethylene glycol. Combining LSPR and SERS measurements could thus give proof of both …
Production of Phosphorescent Coatings on 6082 Aluminum Using Sr0.95Eu0.02Dy0.03Al2O4-δ Powder and Plasma Electrolytic Oxidation
2019
In this study, a new approach for producing phosphorescent aluminum coatings was studied. Using the plasma electrolytic oxidation (PEO) process, a porous oxide coating was produced on the Al6082 aluminum alloy substrate. Afterwards, activated strontium aluminate (SrAl2O4: Eu2+, Dy3+) powder was filled into the cavities and pores of the PEO coating, which resulted in a surface that exhibits long-lasting luminescence. The structural and optical properties were studied using XRD, SEM, and photoluminescence measurements. It was found that the treatment time affects the morphology of the coating, which influences the amount of strontium aluminate powder that can be incorporated into the coating …
Covalently modified nanoclays: synthesis, properties and applications
2020
Abstract Clay minerals are phyllosilicates of nanoscale dimensions. According to their ability to entrap and release organic moieties, they have found applications in several fields, such as drug carrier and delivery, support for catalyst, environmental remediation and filler for polymeric matrices. The possibility to modify, by covalent linkage, their surfaces gives the possibility to form new nanomaterials with improved properties respect to the pristine clay minerals. In this chapter, the modifications of the siloxane surfaces of the most representative clay minerals, namely montmorillonite, sepiolites, laponite and halloysite were reviewed and discussed.
Barrier properties of chitosan coated polyethylene
2012
The transfer properties of chitosan coated polyethylene (PE) films were studied. The barrier properties of non coated PE were not affected by relative humidity changes. The presence of the hydrophilic chitosan layer acted as a water reservoir on the polyethylene film surface which significantly promoted its sensitivity to the water vapour. The water vapour permeability increased 1.85 times at a higher RH. Coated PE films showed more than two-order decrease in the oxygen permeability (PO2) and three-order-decrease in the carbon dioxide permeability (PCO2). When the chitosan coated PE surface was exposed to the water vapour, the PO2 and the PCO2 were significantly increased. However, the perm…
Studies of the initial oxidation of cobalt in alkaline solutions using scanning electrochemical microscope
1998
Studies of the initial oxidation of cobalt in alkaline solutions using scanning electrochemical microscope
Identifying Iron-Bearing Nanoparticle Precursor for Thermal Transformation into the Highly Active Hematite Photo-Fenton Catalyst
2020
Funding: This reseach was funded by the European Regional Development Fund within the Activity 1.1.1.2 “Post-doctoral Research Aid” of the Specific Aid Objective 1.1.1 “To increase the research and innovative capacity of scientific institutions of Latvia and the ability to attract external financing, investing in human resources and infrastructure” of the Operational Programme “Growth and Employment” (No. 1.1.1.2/VIAA/1/16/157).
Water Fluxes in Polymeric Membranes for Desalination via Membrane Distillation
2010
Membrane distillation is an emerging technique for seawater desalination. Hydrophobic polymeric membranes are used to separate the solute‐free water vapour from the hot solution. Vapour fluxes of commercial polymeric membranes were measured in various conditions, i.e. natural and forced convection and vacuum. Vapour fluxes were also predicted with models and compared with experimentals. Higher fluxes were recorded in vacuum conditions.
Nature of activating effect of two-step polymerization of propylene
1999
The prepolymerization effect on propylene polymerization in the presence of a TiCl 3 -based catalyst, modified by di-n-buthyl ether, was studied. The influence of prepolymerization on the electron spin resonance spectra and morphology of the catalyst, as well as the properties and the morphology of both prepolymer and regular polymerization products, was investigated. The polymer morphology was evaluated through scanning electron microscopy, polymer bulk density, and particle size distribution. Some evidence of the enhancement effect of prepolymerization on the catalyst activity and stereospecificity was obtained. No influence from prepolymerization was observed on molecular weight and its …