Search results for "Climate Action"
showing 10 items of 2410 documents
Comparative assessment of a foam-based method for ISCO of coal tar contaminated unsaturated soils
2019
Abstract In situ delivery of liquid reagents in vadose zone is limited by gravity and soil anisotropy. A new foam-based delivery method of persulfate (PS) solutions in unsaturated soils was previously shown to overcome these limitations. The goal of this paper is to demonstrate the efficiency of this method regarding contaminant removal. Hence, the comparative oxidation of 200 mg.kg−1 coal tar artificially contaminated soils with thermally activated PS was carried out after PS-delivery using foam, surfactant solution and pure water. The foam-based method was compared in unfavorable conditions to the reference methods. Especially, in the latter, soil and oxidant solutions were thoroughly mix…
Corrosion in alkanolamine used for acid gas removal: From natural gas processing to CO2 capture
2010
The aim of this paper is to review some of the parameters influencing the corrosivity of alkanolamine solvents used for natural gas purification or for CO2 capture. In the light of literature data and of new experimental results, the influences of temperature and of acid gas loading are discussed. These two parameters appear to have a strong impact on corrosion rates of carbon steel, with extrapolated corrosion rates of several tens of mm/year for the highest temperature and acid gas loading condition.
Long-term performance and life cycle assessment of energy piles in three different climatic conditions
2020
Abstract The main purpose behind the use of energy piles is to enable the exploitation of geothermal energy for meeting the heating/cooling demands of buildings in an efficient and environment-friendly manner. However, the long-term performance of energy piles in different climatic conditions, along with their actual environmental impacts, has not been fully assessed. In this paper, the results of a finite element model taking into consideration the heating and cooling demands of a reference building, and the intermittent operation of a ground source heat pump, are revealed to examine the long-term performance of energy piles. Furthermore, a life cycle assessment model is implemented to com…
The adoption of green energy technologies: The role of policies in Austria, Germany, and Switzerland
2017
We contribute to the existing research about policy-induced technology adoption in several ways. First, we suggest a new survey design to measure the energy-related policy environment. Second, we simultaneously estimate the policy effects for the adoption propensity and the adoption intensity simultaneously and, third, we compare the policy effects in the three countries, Austria, Germany, and Switzerland. Based on a representative sample of firms for all three countries we find that policies essentially promote the adoption of technologies and they are practically ineffective for the intensity, which poses a great challenge to future policy designs. Voluntary agreements or demand-related f…
Applying Biomimicry to Cities: The Forest as Model for Urban Planning and Design
2021
International audience; The idea of applying biomimicry to cities is attracting increasing attention as a way of achieving sustainability. Undoubtedly the most frequently evoked natural model in this context is the forest, though it has not yet been investigated with any great scientific rigour. To overcome this lacuna, we provide: first, a justification of the model of the forest via what we call the arguments from “fittingness”, “scale”, and “complexity”; second, an exploration of various key innovations made possible by this model in the fields of urban planning, urban water systems, urban energy and transport systems, and urban food and nutrient systems.
Sewage sludge as cheap alternative to microalgae as feedstock of catalytic hydrothermal liquefaction processes
2019
Abstract Production of biocrude through hydrothermal liquefaction (HTL) of sewage sludge (SS) and Chlorella vulgaris was investigated. NiMo/Al2O3 (KF 851), CoMo/Al2O3 (KF 1022) and activated carbon felt, tested as catalysts at 598 K for 30 min, did not change the biocrude yield but significantly improved its quality. Quantitative sulfur removal and lower oxygen content were found in biocrude when KF 851 and KF 1022 were used with C. vulgaris. The same catalysts decreased O/C and S/C ratio of the biocrude from SS. The highest HHV (38.19 MJ/kg) and H/C ratio (1.65) and the lowest O/C (0.11) of the biocrude from SS were obtained with the cheaper activated carbon felt. A new product phase, prob…
Specifications for carbonate content quantification in recent marine sediments using Rock-Eval pyrolysis
2019
11 pages; International audience; The amount of CaCO3 in sediments and/or sedimentary rocks is usually measured by calcimetry while the nature of the carbonates is determined by X-ray diffraction. Recently, a carbonate recognition method based on the results of Rock-Eval pyrolysis was proposed in 2014 by Pillot et al. [1]. Rock-Eval pyrolysis is also widely used for the characterization of recent sediments. However, later in 2015 Baudin et al. [2] noticed that some of the characteristics of recent sediments tended to produce different results from those of more classical Rock-Eval analyses, causing bias in interpretations.In this study, the thermal stability of fossil and recent marine carb…
District heating networks: enhancement of the efficiency
2019
International audience; During the decades the district heating's (DH) advantages (more cost-efficient heat generation and reduced air pollution) overcompensated the additional costs of transmission and distribution of the centrally produced thermal energy to consumers. Rapid increase in the efficiency of low-power heaters, development of separated low heat density areas in cities reduce the competitiveness of the large centralized DH systems in comparison with the distributed cluster-size networks and even local heating. Reduction of transmission costs, enhancement of the network efficiency by optimization of the design of the DH networks become a critical issue. The methodology for determ…
Interdisciplinary design methodology for systems of mechatronic systems focus on highly dynamic environmental applications
2017
This paper discusses a series of research challenges in the design of systems of mechatronic systems. A focus is given to environmental mechatronic applications within the chain “Renewable energy production — Smart grids — Electric vehicles”. For the considered mechatronic systems, the main design targets are formulated, the relations to state and parameter estimation, disturbance observation and rejection as well as control algorithms are highlighted. Finally, the study introduces an interdisciplinary design approach based on the intersectoral transfer of knowledge and collaborative experimental activities.
Nonlinear statistical retrieval of surface emissivity from IASI data
2017
Emissivity is one of the most important parameters to improve the determination of the troposphere properties (thermodynamic properties, aerosols and trace gases concentration) and it is essential to estimate the radiative budget. With the second generation of infrared sounders, we can estimate emissivity spectra at high spectral resolution, which gives us a global view and long-term monitoring of continental surfaces. Statistically, this is an ill-posed retrieval problem, with as many output variables as inputs. We here propose nonlinear multi-output statistical regression based on kernel methods to estimate spectral emissivity given the radiances. Kernel methods can cope with high-dimensi…