Search results for "Conduct"

An Introduction to Soil and Water Infiltration

2016

This chapter provides a short presentation of general characteristics of the soil. Basic concepts concerning soil water content and potential and flow of water in the porous medium are then reported since these concepts are diffusely used throughout this book. The infiltration process is finally illustrated considering different modeling approaches. In particular, development of analytical infiltration models is described with reference to one-dimensional gravity-free water absorption, one-dimensional gravity driven infiltration, one-dimensional gravity and capillary driven infiltration and, finally, three-dimensional gravity and capillary driven infiltration.

Ab Initio Studies of Triplet-State Properties for Organic Semiconductor Molecules

2012

Triplet–triplet annihilation (TTA) leads to a reduced efficiency of organic light-emitting diodes (OLEDs) at high current densities. Spacial confinement of the triplet excitons, which is mainly dependent on triplet energy differences, can reduce the TTA rate. Therefore, a deliberate choice of the organic semiconductor materials with particular attention to their triplet energies can help to considerably increase the device efficiency. Organic solid-state lasers are, on the other hand, efficiently quenched by singlet–triplet annihilation (STA), which is closely related to the triplet–triplet absorption of the organic semiconductors. To establish a useful set of parameters related to the proc…

Present status and first results of the final focus beam line at the KEK Accelerator Test Facility

2011

ATF2 is a final-focus test beam line which aims to focus the low emittance beam from the ATF damping ring to a vertical size of about 37 nm and to demonstrate nanometer level beam stability. Several advanced beam diagnostics and feedback tools are used. In December 2008, construction and installation were completed and beam commissioning started, supported by an international team of Asian, European, and U.S. scientists. The present status and first results are described.

Simulations and measurements of beam loss patterns at the CERN Large Hadron Collider

2014

The CERN Large Hadron Collider (LHC) is designed to collide proton beams of unprecedented energy, in order to extend the frontiers of high-energy particle physics. During the first very successful running period in 2010-2013, the LHC was routinely storing protons at 3.5-4 TeV with a total beam energy of up to 146 MJ, and even higher stored energies are foreseen in the future. This puts extraordinary demands on the control of beam losses. An uncontrolled loss of even a tiny fraction of the beam could cause a superconducting magnet to undergo a transition into a normal-conducting state, or in the worst case cause material damage. Hence a multistage collimation system has been installed in ord…

Calculations of high-power production target and beamdump for the GSI future Super-FRS for a fast extraction scheme at the FAIR Facility

2005

A superconducting fragment separator (Super-FRS) is being designed for the production and separation of radioactive isotopes at the future FAIR (Facility for Antiprotons and Ion Research) facility at Darmstadt. This paper discusses various aspects and requirements for the high-power production target that will be used in the Super-FRS experiments. The production target must survive over an extended period of time as it will be used during the course of many experiments. The specific power deposited by the high intensity beam that will be generated at the future FAIR facility will be high enough to destroy the target in most of the cases as a result of a single shot from the new heavy ion sy…

Thermoelectric properties of CoTiSb based compounds

2009

Several CoTiSb based compounds were synthesized and investigated on their thermoelectric properties. The aim was to improve the thermoelectric properties of CoTiSb by the systematic substitution of atoms or the introduction of additional Co into the vacant sublattice. The solid solutions Co1+xTiSb, Co1?yCuyTiSb and CoTiSb1?zBiz were synthesized. X-ray diffraction was used to investigate the crystal structure. The resistivity, the Seebeck coefficient and the thermal conductivity were determined for all compounds in the temperature range from 2 to 400?K. The highest figure of merit for each solid solution is presented. We were able to improve the figure of merit by a factor of approximately s…

Cast multibilayer films from polymerizable lipids

1987

An experimental method for the determination of the photon flow reflected and absorbed by aqueous dispersions containing polycrystalline solids in he…

1991

An experimental method for the evaluation of the photon flow reflected and absorbed by aqueous dispersions containing polycrystalline solids is proposed. The method is based on actinometric measurements. It is shown that the values obtained are independent of the particle sizes and of the concentration of the solids at least in the experimental conditions and in the range used in the present study (particle size range: 40–500 μm; solids concentration: 0.1–2 g liter−1). The results suggest that the values obtained should be attributed to the interfaces formed between the surface of the solids and the medium. The method is applied to a photocatalytic reaction, namely to the photodegradation o…

Organizational and activational effects of testosterone on risk-taking in economical behavior: A systematic review

2017

Resumen El objetivo de esta revisión sistemática es evaluar la influencia de la testosterona circulante (efectos activacionales) y de la exposición prenatal a ella (efectos organizacionales) sobre la asunción de riesgos en conductas económicas, evaluando los trabajos de investigación existentes hasta la fecha acerca de la temática. La base bibliográfica analizada se obtuvo de distintas bases de datos especializadas en el ámbito de la psicología y las neurociencias. Los resultados obtenidos concluyen en una relación contrastada entre la testosterona circulante y la asunción de riesgo financiero. En lo referente a la exposición prenatal se evidencia un estado inmaduro de la investigación sobr…

Desarrollo y validación del Cuestionario de Personalidad Vocacio-nal Adaptativa: un cuestionario para analizar la conducta vocacional de estudiantes …

2013

This study presents a personality evaluation instrument adapted to the vocational setting: the Adaptive Vocational Personality Questionnaire (AVPQ). The questionnaire was developed and tested in a sample of 2160 university students in the final years of their degree programs. The purpose of the study is to validate the questionnaire, providing evidence about its internal structure and its usefulness for predicting scores on a criterion scale. A confirmatory factor analysis combined with a cross-validation design was used: the exploratory sample (n = 879) helped to identify the model with the factorial structure that best fit the relations among the items. As expected, this model had two rel…