Search results for "Conduct"

High-Performance Flexible Magnetic Tunnel Junctions for Smart Miniaturized Instruments

2018

Casting technology for ODS steels – dispersion of nanoparticles in liquid metals

2017

Dispersion of particles to produce metal matrix nanocomposites (MMNC) can be achieved by means of ultrasonic vibration of the melt using ultrasound transducers. However, a direct transfer of this method to produce steel composites is not feasible because of the much higher working temperature. Therefore, an inductive technology for contactless treatment by acoustic cavitation was developed. This report describes the samples produced to assess the feasibility of the proposed method for nano-particle separation in steel. Stainless steel samples with inclusions of TiB2, TiO2, Y2O3, CeO2, Al2O3 and TiN have been created and analyzed. Additional experiments have been performed using light metals…

Development, Characterization, and Testing of a SiC-Based Material for Flow Channel Inserts in High-Temperature DCLL Blankets

2018

This work has been carried out within the framework of the EUROfusion Consortium. The views and opinions expressed herein do not necessarily reflect those of the European Commission.

Ion track template technology for fabrication of CdTe and CdO nanocrystals

2020

Abstract CdTe and CdO nanocrystals were synthesized by chemical deposition into a-SiO2/n-Si ion track template formed by 200 MeV Xe ion irradiation with the fluence of 108 ions/cm2. Depending on the temperature of the solution CdTe + CdO and single-phase CdO with a hexagonal crystal structure were obtained, respectively. The study of the current – voltage characteristics of the obtained structure with the single-phase CdO allows us to estimate the number of grain boundaries and the height of the potential barrier, as well as the n-type conductivity.

Shallow and deep trap levels in X-ray irradiated β-Ga2O3: Mg

2019

Abstract The results of the investigation of thermostimulated luminescence (TSL) and photoconductivity (PC) of the X-ray irradiated undoped and Mg2+ doped β-Ga2O3 single crystals are presented. Three low-temperature peaks at 116 K, 147 K and 165 K are observed on the TSL glow curves of undoped crystals. The high-temperature TSL peaks at 354 K and 385 K are dominant in Mg2+ doped crystals. The correlation between doping with Mg2+ ions and the local energy levels of the intrinsic structural defects of β-Ga2O3, which are responsible for the TSL peaks and PC, is established. The nature of TSL peaks and the appropriate photoconductivity excitation bands are discussed.

Comparison of Single Event Transients Generated at Four Pulsed-Laser Test Facilities-NRL, IMS, EADS, JPL

2012

Four pulsed-laser single-event effects systems, differing in wavelength and pulse width, were used to generate single event transients in a large-area silicon photodiode and an operational amplifier (LM124) to determine how transient amplitude and charge collection varied among the different systems. The optical wavelength and the focused spot size are the primary factors influencing the resultant charge density profile. In the large-area photodiode the transients can be distorted by high charge-injection densities that occur for tightly focused, higher energy optical pulses. When the incident laser-pulse energies are corrected for reflection losses and photon efficiency, with collection de…

Single crystal-like thin films of blue bronze

2021

Abstract Pulsed laser deposition technique was employed to grow thin films of K 0.3 M o O 3 on A l 2 O 3 (1-102) and S r T i O 3 (510) substrates. Structural and imaging characterization revealed good quality films with well oriented grains of few microns in length. Both non-selective (transport) and order-selective (femtosecond pump-probe spectroscopy) probes revealed charge density wave properties that are very close to those of the single crystals. The films exhibit metal-semiconductor phase transition in resistivity, pump-probe data show phase transition at the same temperature as the single crystal and the threshold for the photo-induced phase transition is approximately the same as in…

Correlation between in situ structural and optical characterization of the semiconductor-to-metal phase transition of VO2 thin films on sapphire

2020

A detailed structural investigation of the semiconductor-to-metal transition (SMT) in vanadium dioxide thin films deposited on sapphire substrates by pulsed laser deposition was performed by in situ temperature-dependent X-ray diffraction (XRD) measurements. The structural results are correlated with those of infrared radiometry measurements in the SWIR (2.5-5 μm) and LWIR (8-10.6 μm) spectral ranges. The main results indicate a good agreement between XRD and optical analysis, therefore demonstrating that the structural transition from monoclinic to tetragonal phases is the dominating mechanism for controlling the global properties of the SMT transition. The picture that emerges is a SMT tr…

Luminescence dynamics of hybrid ZnO nanowire/CdSe quantum dot structures

2016

Colloidal CdSe quantum dots (QDs) functionalized with different organic linker molecules are attached to ZnO nanowires (NWs) to investigate the electron transfer dynamics between dots and wires. After linking the quantum dots to the nanowires, the photo-induced electron transfer (PET) from the QDs into the NWs becomes visible in the PL transients by a decrease of dot luminescence decay time. The different recombination paths inside the QDs and the PET process are discussed in the framework of a rate equation model. Photoconductivity studies confirm the electron transfer by demonstrating a strong enhancement of the wire photocurrent under light irradiation into the dot transition. (© 2016 WI…

Radiation hardness studies of CdTe and for the SIXS particle detector on-board the BepiColombo spacecraft

2009

Abstract We report of the radiation hardness measurements that were performed in the developing work of a particle detector on-board ESA's forthcoming BepiColombo spacecraft. Two different high- Z semiconductor compounds, cadmium telluride (CdTe) and mercuric iodide (HgI 2 ), were irradiated with 22 MeV protons in four steps to attain the estimated total dose of 10 12 p / cm 2 for the mission time. The performance of the detectors was studied before and after every irradiation with radioactive 55 Fe source Mn K α 5.9 keV emission line. We studied the impact of the proton beam exposure on detector leakage current, energy resolution and charge collection efficiency (CCE). Also the reconstruct…