Search results for "Cyclodextrin"

An Alginate/Cyclodextrin Spray Drying Matrix to Improve Shelf Life and Antioxidant Efficiency of a Blood Orange By-Product Extract Rich in Polyphenol…

2017

Alginate and β-cyclodextrin were used to produce easily dosable and spray-dried microsystems of a dried blood orange extract with antidysmetabolic properties, obtained from a by-product fluid extract. The spray-dried applied conditions were able to obtain a concentrate dried extract without the loss of AOA and with TPC and TMA values of 35–40% higher than that of the starting material. They were also effective in producing microparticles with 80–100% of encapsulation efficiency. The 2% sodium alginate was capable of improving the extract shelf life, while the beta-cyclodextrin (1 : 1 molar ratio with dried extract) prolonged the extract antioxidant efficiency by 6 hours. The good inhibition…

Dual emission of a bis(pyrene)-functionalized, perbenzylated beta-cyclodextrin

2008

A bis(pyrene)-functionalized β-cyclodextrin (1) has been prepared in two steps from perbenzylated β-cyclodextrin. This compound shows dual emission properties, which arise from the pyrenyl chromophores. Upon excitation of 1 at 355 nm, monomer blue fluorescence (386, 407 and 428 nm) is observed in DMSO solution, whereas excimer green fluorescence (477 nm) is seen upon addition of ≥20 vol% water in DMSO. This suggests that modified β-cyclodextrin 1 changes its shape in response to the environment. The sensing properties of 1 towards carboxylic acids and alcohols were investigated in H2O–DMSO (80 : 20 v/v). Monomer fluorescence is restored selectively by medium length normal carboxylic acids, …

On the formation of inclusion complexes at the solid/liquid interface of anchored temperature-responsive PNIPAAM diblock copolymers with γ-cyclodextr…

2017

The thermal responsive behavior of adsorbed layers of diblock copolymers of poly(N-isopropylacrylamide) (PNIPAAM) and poly((3-acrylamidopropyl)trimethylammonium chloride) (PAMPTMA(+)) with γ-cyclodextrin (γ-CD) at the solid/liquid interface has been investigated using three in situ techniques: null ellipsometry, quartz–crystal microbalance with dissipation monitoring, and neutron reflectometry. The measurements provided information about the adsorbed amounts, the layer thickness, hydration and viscoelastic properties, and the interfacial structure and composition. The copolymers adsorb to silica with the cationic PAMPTMA(+) blocks sitting as anchors in a flat conformation and the PNIPAAM ch…

Highly Sensitive Detection of Naphthalene in Solvent Vapor Using a Functionalized PBG Refractive Index Sensor

2012

We report an optical refractive index sensor system based on a planar Bragg grating which is functionalized by substituted γ-cyclodextrin to determine low concentrations of naphthalene in solvent vapor. The sensor system exhibits a quasi-instantaneous shift of the Bragg wavelength and is therefore capable for online detection. The overall shift of the Bragg wavelength reveals a linear relationship to the analyte concentration with a gradient of 12.5 ± 1.5 pm/ppm. Due to the spectral resolution and repeatability of the interrogation system, this corresponds to acquisition steps of 80 ppb. Taking into account the experimentally detected signal noise a minimum detection limit of 0.48 ± 0.05 pp…

Supramolecular Chemical Sensors Based on Pyrene Monomer-Excimer Dual Luminescence

2010

The past ten years have seen a spectacular development of chemical sensors based on the monomer-excimer dual luminescence of aromatic systems, such as pyrene. Either in the form of integrated or multicomponent molecular devices these chemosensors have been attracting a high interest above all because of their unique ratiometric properties. This review will focus on the latter systems, which can be classified into two classes: Firstly, the assembly of receptor-effector conjugates is triggerred by the analyte of interest. As a result, the sensor shows monomer to excimer fluorescence switching upon substrate binding. Secondly, the supramolecular assembly that constitutes the sensor is perturbe…

Comparison of the solid-phase extraction efficiency of a bounded and an included cyclodextrin-silica microporous composite for polycyclic aromatic hy…

2016

Solid-phase extraction is one of the most important techniques for sample purification and concentration. A wide variety of solid phases have been used for sample preparation over time. In this work, the efficiency of a new kind of solid-phase extraction adsorbent, which is a microporous material made from modified cyclodextrin bounded to a silica network, is evaluated through an analytical method which combines solid-phase extraction with high-performance liquid chromatography to determine polycyclic aromatic hydrocarbons in water samples. Several parameters that affected the analytes recovery, such as the amount of solid phase, the nature and volume of the eluent or the sample volume and …

Water Structure Recovery in Chaotropic Anion Recognition: High-Affinity Binding of Dodecaborate Clusters to γ-Cyclodextrin

2015

Dodecaborate anions of the type B12X12(2-) and B12X11Y(2-) (X=H, Cl, Br, I and Y=OH, SH, NH3(+), NR3(+)) form strong (K(a) up to 10(6) L mol(-1), for B12Br12(2-)) inclusion complexes with γ-cyclodextrin (γ-CD). The micromolar affinities reached are the highest known for this native CD. The complexation exhibits highly negative enthalpies (up to -25 kcal mol(-1)) and entropies (TΔS up to -18.4 kcal mol(-1), both for B12I12(2-)), which position these guests at the bottom end of the well-known enthalpy-entropy correlation for CDs. The high driving force can be traced back to a chaotropic effect, according to which chaotropic anions have an intrinsic affinity to hydrophobic cavities in aqueous …

Cyclodextrin-based nano-devices for improved antibiotic activity

2017

Synergistic effect with antibiotics and inhibition of bacterial biofilm formation by polyaminocyclodextrin-silver nanoparticles

2018

Functionalization using biocompatible carboxylated cyclodextrins of iron-based nanoMIL-100

2021

9 pags., 7 figs., 1 tab.