Search results for "Diffraction"
showing 10 items of 1584 documents
Testing the shape-similarity hypothesis between partide-size distribution and water retention for sicilian soils
2012
Application of the Arya and Paris (AP) model to estimate the soil water retention curve requires a detailed description of the particlesize distribution (PSD) but limited experimental PSD data are generally determined by the conventional sieve-hydrometer (SH) method. Detailed PSDs can be obtained by fitting a continuous model to SH data or performing measurements by the laser diffraction (LD) method. The AP model was applied to 40 Sicilian soils for which the PSD was measured by both the SH and LD methods. The scale factor was set equal to 1.38 (procedure AP1) or estimated by a logistical model with parameters gathered from literature (procedure AP2). For both SH and LD data, procedure AP2 …
Structural properties of the quaternary Heusler alloy Co2Cr1−xFexAl
2007
The quarternary substitutional series Co2Cr1?xFexAl was investigated by means of surface and bulk sensitive techniques in order to exploit its structural and compositional properties. Both bulk and powder samples of the alloy series were investigated to obtain specific information about this material.The long range order was determined by means of x-ray diffraction and neutron diffraction, while the site specific (short range) order was proved by extended x-ray absorption fine structure spectroscopy. The magnetic structure was investigated by M?ssbauer spectroscopy in transmission and scattering modes in order to compare and separate powder and bulk properties. The chemical composition was …
Reactivity of H2S and H2S/H2 Mixture With Molybdenum Oxide Thin Films Epitaxied on CoO (100) : Characterization by Rheed and Auger Spectroscopy
2010
Molybdenum-Cobalt composite oxide films were prepared by the evaporation of molybdenum trioxide on a fresh cleaved CoO (100) surface (Thickness = 10 A). The MoO3-CoO interface has been characterized simultaneously by reflexion high electron diffraction (RHEED) and Auger Electron Spectroscopy (AES). The thin film structure and composition depend on the annealing temperature. After a 300°C treatment, metallic cobalt islands nucleate at the interface thin film - CoO (100) and crystallize with the cubic FCC symmetry. After a 700°C treatment cobalt molybdate (a CoMoO4) islands grow. The metastable crystallites are epitaxied on CoO (100). After a 900°C treatment, the thin film consists of flat tw…
Effect of the surface stoichiometry on the interaction of Mo with TiO2 (110)
2000
Abstract Molydenum has been deposited at room temperature on (110) TiO2 surfaces with different stoichiometries, roughnesses and crystallinities. Whatever the substrate preparation is, in-situ Auger electron spectroscopy (AES) and X-ray photoelectron spectroscopy (XPS) studies as well as ex-situ atomic force microscopy (AFM) and reflexion high-energy electron diffraction (RHEED) studies reveal a Stranski–Krastanov growth mode: the completion of three monolayers followed by islands growth is observed in every case. The three monolayers are always composed of amorphous molybdenum oxide with an oxidation state of molybdenum less than IV. The oxidation of the molybdenum layers generates Ti3+ an…
Influence of the grain orientation spread on the pitting corrosion resistance of duplex stainless steels using electron backscatter diffraction and c…
2013
Abstract The corrosion behavior of UNS S32202 duplex stainless steel was studied by combining electron backscatter diffraction (EBSD) measurements and critical pitting temperature tests at the microscale. The grain orientation spread (GOS) value was determined in grains of both phases from EBSD data. It was shown that austenitic sites containing extremely small ferrite grains having a GOS value greater than 1.3° were precursor sites for pitting in 4 M NaCl. The critical pitting temperature range was 45–90 °C. All the other sites of both phases remained passive up to 100 °C.
Passive properties of lean duplex stainless steels after long-term ageing in air studied using EBSD, AES, XPS and local electrochemical impedance spe…
2013
Abstract Passivity of duplex stainless steel was studied after long-term ageing in air using local electrochemical impedance spectroscopy, AES, XPS and EBSD. After mechanical polishing, the passive film was homogeneous and had a capacitive behaviour described by the CPE. After long-term ageing, a small thickening was detected and O2−/OH− was significantly higher in the austenite than in the ferrite. Austenite behaved as a blocking electrode whereas two capacitive loops were observed in the ferrite (low value of O2−/OH). The loop at high frequencies was related with the oxygen reduction and the loop at low frequencies was connected with the passive film.
Influence of friction on the local mechanical and electrochemical behaviour of duplex stainless steels.
2006
International audience; The electrochemical behaviour of ferritic and austenitic phases in duplex stainless steel (UNS S32304) and the modifications induced by straining during sliding were studied by potentiodynamic polarisation curves determined at the microscale in a 1MNaCl (pH 3) solution, using an electrochemical microcell. The mechanical properties and stress state of each phase were determined by microhardness and X-ray microdiffraction measurements, before and after straining. The results show that sliding generates elastic straining of the ferrite and plastic deformation of the austenite. The electrochemical behaviour of these phases is dramatically altered, inducing a reduction of…
MZ-35, a new layered pentasil borosilicate synthesized in the presence of large alkali cations
2013
Abstract A new layered borosilicate has been synthesized in the presence of cesium and sodium cations and its structure has been solved by a combination of automated diffraction tomography (ADT) and X-ray powder diffraction (XRPD). MZ-35 has a composition NaCs 2 [BSi 7 O 16 (OH) 2 ](OH) 2 ·4H 2 O and features space group P-4m2. The unusually small unit cell ( a 7.3081 A, c 10.7520 A) is shared by two random-stacked configurations of the structure: a network of connected pentasil units related to the layer of RUB-18 and a bidimensional checkerboard of intersecting ladders of 4-membered rings. The two configurations are related by the simple face-sharing inversion of a hydroxyl-bearing tetrah…
4-hydroxy-ONN-azoxybenzene
2000
The oxidation of 4-hydroxyazobenzene provided a mixture of two azoxy compounds, which were separated by column chromatography. The isomer with the higher melting point appeared to belong to the α (ONN) series, as determined by X-ray diffraction. The molecule, C12H10N2O2, is almost planar. The benzene rings are twisted by 11.7 (2) (substituted) and 4.1 (1)° (unsubstituted) with respect to the ONN plane. The molecules are connected to one another by strong O—H⋯O hydrogen bonds forming chains extended along [001], which are bound by much weaker C—H⋯O hydrogen bonds forming layers in the bc plane.
Orthorhombic polymorphs of twotrans-4-aminoazoxybenzenes
2002
The two isomeric compounds 4-amino-ONN-azoxybenzene [or 1-(4-aminophenyl)-2-phenyldiazene 2-oxide], i.e. the alpha isomer, and 4-amino-NNO-azoxybenzene [or 2-(4-aminophenyl)-1-phenyldiazene 2-oxide], i.e. the beta isomer, both C(12)H(11)N(3)O, crystallized from a polar solvent in orthorhombic space groups, and their crystal and molecular structures have been determined using X-ray diffraction. There are no significant differences in the bond lengths and valence angles in the two isomers, in comparison with their monoclinic polymorphs. However, the conformations of the molecules are different due to rotation along the Ar-N bonds. In the alpha isomer, the benzene rings are twisted by 31.5 (2)…