Search results for "Diode"

Diode-pumped bulk Er:Yb:Glass 1.54μm pulsed laser with 1.2J output and 25% optical efficiency

2002

We report a pulsed transversely diode-pumped compact Er:Yb:Glass laser of uncomplicated design, delivering output energy of approx. 1.2J in free-running operation and 25% optical slope efficiency.

Multi-spectral photoplethysmography biosensor

2011

A photoplethysmography (PPG) signal can provide very useful information about a subject's hemodynamic status in a hospital or home environment. A newly developed portable multi-spectral photoplethysmography device has been used for studies of 11 healthy subjects. The developed optical fiber biosensor comprises one multi-wavelength laser diode (405nm, 660nm and 780nm) and a single photodiode with multi-channel signal output processing and built in Li-ion accumulator; special software was created for visualization and measuring of the MS-PPG signals. ARM7TDMI-S LPC2148, NXP (founded by Philips) 32 bit processor with clock frequency of 60 MHz performs measurement and analysis of the signal.

Photoprotection and photoreception of intraocular lenses under xenon and white LED illumination.

2016

Objective. To analyze the photoprotection and phototransmission that various intraocular lenses (10Ls) provide under the illumination of a xenon (Xe) lamp and white LEDs (light emitting diode). Methods. The spectral transmission curves of six representative 10Ls were measured using a Perkin-Elmer Lambda 35 UV/VIS spectrometer. Various filtering simulations were performed using a Xe lamp and white LEDs. The spectral emissions of these lamps were measured with an ILT-950 spectroradiometer. Results. The 10Ls analyzed primarily show transmission of nearly 100% in the visible spectrum. In the ultraviolet (UV) region, the filters incorporated in the various 10Ls did not filter equally, and some o…

DC lifetime of encapsulated organic light emitting diodes

2016

Organic light emitting diodes (OLEDs) are ideal sources for chemical and biological optical sensors, due to their simplicity, low cost (disposable applications) and possibility to be integrated on chip and fabricated in the form of large 2D arrays (microarray fluorescence) even on flexible plastic substrates. OLEDs with lifetimes of a few hundreds of hours at initial luminance values in the range (500÷1000) cd/m 2 are suitable for the above applications, but these lifetimes can be achieved only by a proper encapsulation. Fast, simple and inexpensive encapsulation methods are highly desirable to keep the low cost profile and for this reasonwe report two different encapsulation structures and…

A comparative study of encapsulation structures for OLEDs

2007

Encapsulation is the final and most important step in the fabrication of organic light emitting diodes (OLEDs). An OLED operated in air can have a lifetime, defined as the time it takes for the luminance to decrease to half of its initial value, up to a few hours or less [1] due to degradation mechanisms induced by water vapour and oxygen. For emerging niche applications, such as OLED fluorescence biosensors [2] for routine laboratory analysis, the OLED is operated for a short period of time and then it must be disposed of. In this case OLEDs lifetimes of the order of a few hundreds of hours at initial luminance values in the range (500 1000) cd/m2 can be considered acceptable. To keep th…

Humidity Insensitive Conductometric Sensors for Ammonia Sensing

2014

Interest in molecular materials has been driven in large part by their various and prosperous applications, especially in the domain of organic electronics, where they offer many advantages as well as alternative approaches compared to their inorganic counterparts. Most of conductometric transducers are resistors[[ and transistors[[[, but rarely diodes[6]. In our laboratory, we designed and characterized new molecular material based devices. Molecular Semiconductor Doped Insulator (MSDI) heterojunctions were built around a heterojunction between a Molecular Semiconductor (MS) and a Doped Insulator (DI)[7][8]. This new device exhibits interesting electronic properties that allow ammonia sens…

Phosphorescent hybrid organic-inorganic light-emitting diodes.

2010

Determination of charge carrier mobility of hole transporting polytriarylamine-based diodes

2010

Hole transport properties of three different side chain poly(triarylamines) have been determined by means of the analysis of steady-state current-voltage characteristics using co-planar diode structures. The interpretation is based on space-charge limited models with field-dependent mobility. Mobilities between ~ 10- 8 and 10- 6 cm2 V- 1 s- 1 are obtained. The highest mobility is achieved for poly(tetraphenylbenzidine) devices and the lowest for poly(triphenylamine) devices. Electron-rich methoxy substituents increase the mobility of poly(triphenylamine)s. A comparison of the mobility values with those obtained using organic field-effect transistors is also given. © 2009 Elsevier B.V. All r…

Efficiency enhancement of organic light emitting diodes by NaOH surface treatment of the ITO anode

2009

Abstract Organic light emitting diodes (OLEDs) based on tris-(8-idroxyquinoline)aluminum (Alq 3 ) with enhanced efficiency are reported here. This is obtained by improving the charge carrier balance, through a preliminary NaOH surface treatment of the indium tin oxide (ITO) anode, in order to decrease its work function and, consequently, reduce the hole injection. The obtained devices exhibit a 1.36% external quantum efficiency and a 1.2 lm/W power efficiency at a current density of 60 mA/cm 2 . These values are more than double as compared with those of identical reference devices fabricated without the preliminary NaOH surface treatment.

LED organici con emissione nel blu

2007

We report the development of blue organic light emitting diodes (OLEDs) based on molecular materials. Electrical characteristics and quantum efficiency of single layer devices and triple layer devices comprising further a hole blocking layer and an electron injection layer are compared and prospects for applications to passive matrix displays and fluorescence integrated biosensors are also discussed.