Search results for "Drying"

showing 10 items of 172 documents

On the hydro-mechanical behaviour of a lime-treated embankment during wetting and drying cycles

2018

Abstract The paper presents some experimental results obtained on samples extracted from a full-scale embankment obtained by compacting a lime-treated clayey soil. A comprehensive test programme was carried out in order to highlight the improvement of mechanical behaviour induced by lime treatment as well as to assess the durability of the improved material, which may be affected by severe seasonal wetting and drying cycles. Direct shear tests, triaxial compression tests, swelling potential measurement and oedometric tests were performed on samples cured in controlled environmental conditions for at least 18 months. Wetting and drying cycles were applied in a very wide range of suction valu…

Materials scienceWeathering0211 other engineering and technologies020101 civil engineering02 engineering and technologyLime-treated clay0201 civil engineeringmedicineGeotechnical engineeringComputers in Earth SciencesSafety Risk Reliability and QualitySoftening021101 geological & geomatics engineeringShrinkageMicrostructural characterizationGeotechnical Engineering and Engineering GeologyOedometric testDurabilityShear strengthPozzolanic reactionDirect shear testWettingSwellingmedicine.symptomWetting and drying cycleSaturation (chemistry)Geomechanics for Energy and the Environment
researchProduct

Optimization of Spray-Drying Process of Jerusalem artichoke Extract for Inulin Production

2019

Jerusalem artichoke is an important natural matrix for inulin production. In this experiment, response surface methodology (RSM) was employed to optimize the spray-drying parameters in order to determine the maximal inulin yield. For this study, three independent variables (heating temperature (T&ordf

Materials scienceYield (engineering)<i>Jerusalem artichoke</i>030309 nutrition & dieteticsInulinPharmaceutical ScienceAnalytical Chemistryresponse surface methodologylcsh:QD241-44103 medical and health scienceschemistry.chemical_compound0404 agricultural biotechnologylcsh:Organic chemistryDrug DiscoveryResponse surface methodologyFood sciencespray-dryingPhysical and Theoretical ChemistryWater content0303 health sciencesinulinOrganic Chemistry04 agricultural and veterinary sciences040401 food scienceCreepchemistryChemistry (miscellaneous)Spray dryingMolecular MedicineParticle sizeJerusalem artichokeMolecules
researchProduct

Foam mat drying of yacon juice: Experimental analysis and computer simulation

2015

Abstract The foam mat drying of yacon juice (YJ) and concentrate yacon juice (CYJ) was conducted under various conditions of thickness of product (0.5, 1.0 and 1.5 cm) and air temperature (50, 60 and 70 °C). After drying the resulted dry powder was removed from the metallic tray and pulverized. Layer thickness and air temperature influenced statistically ( p  > 0.5) drying time, moisture content and water activity (Aw) of the product. The shortest drying time to reach the desired Aw (0.1–0.3) corresponds to the condition of 0.5 cm and 70 °C for both juices – 59 and 65 min for the YJ and CYJ, respectively. The process was modeled in terms of heat and mass transfer and then simulated by a fin…

Materials sciencebiologyWater activityFoam mat dryingModelingYacónbiology.organism_classificationYaconTrayDrying timeMass transferAir temperatureHeat transferHeat transferMass transferFood scienceComposite materialWater contentSimulationFood ScienceJournal of Food Engineering
researchProduct

Porous gelatin cryogels as cell delivery tool in tissue engineering.

2007

Materials sciencefood.ingredientTissue EngineeringPharmaceutical ScienceBiocompatible MaterialsHydrogelsCell deliveryGelatinfoodFreeze DryingTissue engineeringGelatinHumansBiochemical engineeringPorosityBiomedical engineeringHeLa CellsJournal of controlled release : official journal of the Controlled Release Society
researchProduct

A non-hydrostatic pressure distribution solver for the nonlinear shallow water equations over irregular topography

2016

Abstract We extend a recently proposed 2D depth-integrated Finite Volume solver for the nonlinear shallow water equations with non-hydrostatic pressure distribution. The proposed model is aimed at simulating both nonlinear and dispersive shallow water processes. We split the total pressure into its hydrostatic and dynamic components and solve a hydrostatic problem and a non-hydrostatic problem sequentially, in the framework of a fractional time step procedure. The dispersive properties are achieved by incorporating the non-hydrostatic pressure component in the governing equations. The governing equations are the depth-integrated continuity equation and the depth-integrated momentum equation…

Mathematical optimizationFinite volume method010504 meteorology & atmospheric sciencesDiscretization0208 environmental biotechnology02 engineering and technologyMechanicsSolver01 natural sciencesSettore ICAR/01 - Idraulica020801 environmental engineeringUnstructured gridlaw.inventionNonlinear systemContinuity equationlawDynamic pressure Shallow waters Dispersive process Finite volume Wetting and drying Unstructured gridHydrostatic equilibriumShallow water equationsPhysics::Atmospheric and Oceanic Physics0105 earth and related environmental sciencesWater Science and TechnologyMathematicsAdvances in Water Resources
researchProduct

ANALYSIS OF OPEN SUN DRYING EXPERIMENTS

1993

ABSTRACT Open sun drying has lost its previous importance due to the fact that different factors affect its reliability and the quality of the products obtained. One of the set–backs for the analysis of solar drying exoeriments is their deoendence on a non–controlled source of energy, i.e. solar radiation depends on climatic conditions and experiments are difficult to compare. It is thus necessary to investigate the advantages of a particular set up as well as the climatic influences. Open sun drying could constitute the natural reference, allowing the comparison of different drying strategies. A new way of standardizing drying times, based on solar radiation inout, is proposed, to allow be…

MeteorologyChemistrybusiness.industryGeneral Chemical EngineeringPhysical and Theoretical ChemistrySolar dryingSolar energybusinessDrying Technology
researchProduct

Industrial production of dried yeast: plasma membrane as a survival indicator of air drying process

2011

International audience; Preservation of microorganisms by desiccationis a major industrial interest.However, study of cell survival mechanismsthat occur during desiccation is complex. In this work, the impact of the magnitude and the kinetics of dehydration on yeastsurvival wereevaluatedin either hyperosmotic liquid medium or a gaseous environment. Asame lethal magnitude of dehydration and a same lethal kinetic effect were found. As previously shown for osmotic stress, this work demonstrate that yeast survival after drying was also related to plasma membrane disorganization, suggesting a similar passive rearrangement of the membrane components.Hyperosmotic treatment in liquid medium represe…

Microscopy[SPI.GPROC] Engineering Sciences [physics]/Chemical and Process EngineeringOsmotic dehydrationAir-drying[SPI.GPROC]Engineering Sciences [physics]/Chemical and Process EngineeringYeastPlasma membrane
researchProduct

Drying kinetics of thyme

2012

Los objetivos del trabajo fueran estudiar la cinética del secado de tomillo con posterior ajuste de diferentes modelos matemáticos a los datos experimentales y determinar los valores de la difusividad efectiva y energía de activación. Para el desarrollo del experimento de secado fueran utilizadas las temperaturas 30, 40, 50, 60 y 70 oC. El diseño experimental fue de bloques completamente aleatorizados, con tres repeticiones. Para el ajuste de los modelos matemáticos a los datos experimentales fue realizado el análisis de regresión no lineal, por el método Simplex-Quasi-Newton. Los resultados mostraron que el modelo matemático de Page obtuve un mejor ajuste a los datos experimentales, los va…

Modelos matemáticosEnvironmental EngineeringMathematical modelSecadoThymus vulgaris L.Agronomy and Crop ScienceDrying
researchProduct

Evaluation of drug-polymer solubility curves through formal statistical analysis: comparison of preparation techniques.

2014

ABSTRACT: In this study, the influence of the preparation technique (ball milling, spray drying, and film casting) of a supersaturated amorphous dispersion on the quality of solubility determinations of indomethacin in polyvinylpyrrolidone was investigated by means of statistical analysis. After annealing of the amorphous dispersions above the crystallization temperature for 2 h, the solubility curve was derived from the glass transition temperature of the demixed material using the Gordon–Taylor relationship and fitting with the Flory–Huggins model. The study showed that the predicted solubility from the ball-milled mixtures was not consistent with those from spray drying and film casting,…

Models MolecularMaterials scienceHot TemperatureChemistry PharmaceuticalDrug CompoundingIndomethacinAnalytical chemistryPharmaceutical SciencemedicinePharmaceutic AidsSolubilitySupersaturationReproducibilityPolyvinylpyrrolidoneCalorimetry Differential ScanningAnti-Inflammatory Agents Non-SteroidalPovidoneReproducibility of ResultsCastingAmorphous solidChemical engineeringSolubilitySpray dryingEmulsionsGlass transitionPowder Diffractionmedicine.drugJournal of pharmaceutical sciences
researchProduct

The dynamics of (57)Fe nuclei in Fe(III)-DNA condensates.

2001

Abstract The dynamics of iron nuclei in the condensates obtained by interaction of Fe III with DNA, Fe III (DNA monomer) 2 , have been investigated by variable temperature 57 Fe Mossbauer spectroscopy. Studies were effected on gel and freeze-dried samples, obtaining nearly coincident values of the parameters isomer shift and nuclear quadrupole splitting in T ranges 20–260 K. Functions ln( A T / A 77.3 ) vs. T , here employed to investigate the dynamics of Fe nuclei, showed linear trends in the T ranges 20–150 and 150–260 K, respectively, the latter with larger slopes. Data coincided for gelled and freeze-dried specimens. No variation of δ or Δ E parameters occurred at the two T intervals, w…

Molecular StructureDynamics (mechanics)TemperatureQuadrupole splittingDNABiochemistryIron IsotopesInorganic Chemistrychemistry.chemical_compoundCrystallographySpectroscopy MossbauerMonomerFreeze DryingchemistryMössbauer spectroscopyAnimalsGelsDNAJournal of inorganic biochemistry
researchProduct