Search results for "Electron microscope"
showing 10 items of 784 documents
Imaging connected porosity of crystalline rock by contrast agent-aided X-ray microtomography and scanning electron microscopy
2017
We set out to study connected porosity of crystalline rock using X-ray microtomography and scanning electron microscopy with energy dispersive X-ray spectroscopy (SEM-EDS) with caesium chloride as a contrast agent. Caesium is an important radionuclide regarding the final deposition of nuclear waste and also forms dense phases that can be readily distinguished by X-ray microtomography and SEM-EDS. Six samples from two sites, Olkiluoto (Finland) and Grimsel (Switzerland), where transport properties of crystalline rock are being studied in situ, were investigated using X-ray microtomography and SEM-EDS. The samples were imaged with X-ray microtomography, immersed in a saturated caesium chlorid…
Osteogenesis imperfecta and hyperplastic callus formation: light- and electron-microscopic findings.
1993
In rare cases of osteogenesis imperfecta, an "overshoot" growth of new bone may occur, which, clinically gives the impression of a tumour. This condition is known as hyperplastic callus formation. Morphology showed an excessive mixed desmal-chondral osteoneogenesis. Atypical collagen fibrils in non-callus tissue represent an indicator for this callus formation in individual patients.
Elasticity and yield strength of pentagonal silver nanowires: In situ bending tests
2014
This paper reports in situ mechanical characterization of silver nanowires (Ag NWs) inside a scanning electron microscope using a cantilevered beam bending technique. Measurements consisted in controlled bending of a cantilevered NW by the tip of an atomic force microscope glued to the force sensor. Relatively high degree of elasticity followed by either plastic deformation or fracture was observed in bending experiments. Experimental data were numerically fitted into the model based on the elastic beam theory and values of Young modulus and yield strength were extracted. Measurements were performed on twenty Ag NWs with diameters from 76 nm to 211 nm. Average Young modulus and yield streng…
Incorporation of membrane proteins into lipid surface monolayers: Characterization by fluorescence and electron microscopies
2007
The preparation of oriented protein samples is an attractive goal, e.g., to gain more detailed information from spectroscopic experiments. Our approach towards this aim was to prepare monolayers of phospholipids at the air-water interface and to incorporate the proteins into these ordered structures. Subsequently, we used the Langmuir-Boldgett (LB) transfer technique to obtain samples of oriented proteins on solid supports. — Incorporation was achieved by spreading the proteins from a detergent solution onto a prespread lipid monolayer on the water surface. We characterized successful incorporation by in situ fluoresence microscopy and by electron microscopy, and investigated the topology o…
In situ structural analysis of SARS-CoV-2 spike reveals flexibility mediated by three hinges
2020
Flexible spikes The severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) spike protein enables viral entry into host cells by binding to the angiotensin-converting enzyme 2 (ACE2) receptor and is a major target for neutralizing antibodies. About 20 to 40 spikes decorate the surface of virions. Turoňová et al. now show that the spike is flexibly connected to the viral surface by three hinges that are well protected by glycosylation sites. The flexibility imparted by these hinges may explain how multiple spikes act in concert to engage onto the flat surface of a host cell. Science, this issue p. 203
In situ study of the sintering of a lead phosphovanadate in an Environmental Scanning Electron Microscope
2011
cited By 3; International audience; The in situ sintering of a powder of Pb3(VO4) 1.6(PO4)0.4 composition was performed in an Environmental Scanning Electron Microscope. The electric current induced by the electron beam was found to reduce the effective temperature of sintering as well as to accelerate the kinetics of shrinkage of a cluster composed of sub-micrometric grains of material. The presence of the residual current flow in the cluster during observation for in situ experiments helps to reduce the apparent sintering temperatures from 50 to 150 °C compared to conventional heating conditions without current. © 2011 Elsevier B.V. All rights reserved.
Tribological Aspects of In Situ Manipulation of Nanostructures Inside Scanning Electron Microscope
2014
This chapter is dedicated to manipulation of nanostructures inside a scanning electron (SEM) microscope employed for real-time tribological measurements. Different approaches to force registration and calculation of static and kinetic friction are described. Application of the considered methodology to Au and Ag nanoparticles, as well as ZnO and CuO nanowires, is demonstrated. Advantages and limitations of the methodology in comparison to traditional AFM-based manipulation techniques are discussed.
In-situ electron irradiation studies of metal-carbon nanostructures
2008
The properties and the behaviour of nanoparticles are subjects of highest current importance. Experiments on individual clusters are generally difficult but can be carried out by the techniques of modern in-situ electron microscopy. The electron beam can be used as a tool to induce structural changes on an almost atomic scale [1].
An AC-assisted single-nanowire electromechanical switch
2013
A unique two-source controlled nanoelectromechanical switch has been assembled from individual, single-clamped Ge nanowires. The switching behaviour was achieved by superimposing the control signals of specific frequencies to the electrostatic potential of the output terminals, eliminating the need for an additional gate electrode. Using an in situ manipulation technique inside a scanning electron microscope, we demonstrate that the pull-out force required to overcome adhesion at the contact can be significantly reduced by exciting mechanical resonant modes within the nanowire.
Ultrastructure of the Interlamellar Membranes of the Nacre of the Bivalve Pteria hirundo, Determined by Immunolabelling.
2015
The current model for the ultrastructure of the interlamellar membranes of molluscan nacre imply that they consist of a core of aligned chitin fibers surrounded on both sides by acidic proteins. This model was based on observations taken on previously demineralized shells, where the original structure had disappeared. Despite other earlier claims, no direct observations exist in which the different components can be unequivocally discriminated. We have applied different labeling protocols on non-demineralized nacreous shells of the bivalve Pteria. With this method, we have revealed the disposition and nature of the different fibers of the interlamellar membranes that can be observed on the …