Search results for "FILM"

Rheological properties of progesterone microemulsions: Influence of xanthan and chitosan biopolymer concentration

2008

In this preformulations study, rheological properties of microemulsions with progesterone (1%) were studied to analyze the effect of xanthan and chitosan at different concentrations (0.5–3%). Steady shear and oscillatory rheological properties were analyzed using a controlled stress rheometer. Steady shear data were satisfactorily adjusted to the Carreau model. For all preparations, shear-thinning behavior was observed. Zero shear viscosity (η0) increased with the biopolymer concentration. The results from dynamic experiments showed the behavior of all preparations with xanthan gum and those of chitosan to be characteristic of weak gels and liquid-like solutions, respectively. The correlati…

Morphology, rheology, and mechanical properties of a new nanobiocomposite

2015

Nanobiocomposites are a new class of biodegradable polymer materials with an ultrafine phase dispersion of the order of a few nanometers in a biodegradable polymer matrix that shows very interesting properties often very different from those of conventional filled polymers. In this work the morphology and the rheological and mechanical properties of a new nanobiocomposite made of a biodegradable copolyester based blend with an organomodified montmorillonite have been investigated to evaluate its possible use in several applications. SAXS diffractograms and TEM micrographs show that the in both the adopted processing conditions an hybrid intercalated/exfoliated morphology is observed. Rheolo…

Master curves of viscoelastic behavior in the plastic region of a solid polymer

1977

Stress relaxation and creep tests following strain ramps were made on Mylar, both above and below the yield stress. The ramp velocity was varied over a 40-fold range. All data exhibit nonlinear viscoelastic behavior. However, those obtained above the yield point, i.e., in the plastic region, could be reduced to single master curves for both the creep and the relaxation tests by means of a simple time shift factor. This factor is inversely proportional to the strain rate existing just prior to the test.

Rheological behavior and thermal stability of poly(phenylene sulfide)/vectra-B950 blends

1994

Blends of polyphenylene sulfide (PPS) with a commercial, wholly aromatic, liquid crystalline polymer (LCP), Vectra-B950, have been prepared by melt-blending. Their rheological behavior has been studied in order to determine if the LCP displays a processing aid ability, and under what conditions it gives rise to potentially reinforcing fibrils dispersed in the PPS matrix. The problem of the thermal stability of PPS/LCP blends, which has been considered by some authors as the main obstacle to the production of usable materials due to the evolution of gaseous substances during processing, has been discussed. © 1994 John Wiley & Sons, Inc.

Processing and characterization of blends of fluoroelastomers with semirigid liquid crystal polymers

1996

Fluoroelastomers (FEs) usually have working temperatures above 150°C and a great resistance to aggressive agents such as oils, fuels, aliphatic and aromatic solvents, steam, moderate acid, and basic environments. Liquid crystal polymers (LCPs) can be effective processing aids and reinforcing agents for elastomers. These characteristics are very attractive to lower melt viscosity and to stiffen and strengthen the final product through a simple blending. Among the LCPs, the semirigid LCPs seem the most appealing for blending with flexible thermoplastics (FTs) because their processing temperatures can be arranged to be in the same processing temperature range of FTs and because the presence of…

Derivatization of Plasma Polymerized Thin Films and Attachment of Biomolecules to Influence HUVEC-Cell Adhesion

2011

Synthesis and Characterization of Syndiotactic Polystyrene-Polyethylene Block Copolymer

2019

The direct synthesis of syndiotactic polystyrene-block-polyethylene copolymer (sPS-b-PE) with a diblock structure has been achieved. The synthetic strategy consists of the sequential stereocontrolled polymerization of styrene and ethylene in the presence of a single catalytic system: cyclopentadienyltitanium(IV) trichloride activated by modified methylaluminoxane (CpTiCl3/MMAO). The reaction conditions suitable for affording the partially living polymerization of these monomers were identified, and the resulting copolymer, purified from contaminant homopolymers, was fully characterized. Gel permeation chromatography coupled with two-dimensional NMR spectroscopy COSY, HSQC, and DOSY confirme…

Redox active polymers with phenothiazine moieties for nanoscale patterning via conductive scanning force microscopy

2011

Redox active polymers with phenothiazine moieties have been synthesized by Atomic Transfer Radical Polymerization (ATRP). These novel polymers reveal bistable behaviour upon application of a bias potential above the oxidation threshold value. Using conductive Scanning Force Microscopy, two distinguishable conductivity levels were induced on a nanoscale level. These levels were related to a high conducting “On” and a low conducting “Off” state. The “On” state is generated by the oxidation of the phenothiazine side chains to form stable phenothiazine radical cations. The formation and stability of the radical sites was examined by cyclic voltammetry, electron spin resonance and optical spectr…

Relaxation processes and glass transition of confined polymer melts: A molecular dynamics simulation of 1,4-polybutadiene between graphite walls.

2017

Molecular dynamics simulations of a chemically realistic model for 1,4-polybutadiene in a thin film geometry confined by two graphite walls are presented. Previous work on melts in the bulk has shown that the model faithfully reproduces static and dynamic properties of the real material over a wide temperature range. The present work studies how these properties change due to nano-confinement. The focus is on orientational correlations observable in nuclear magnetic resonance experiments and on the local intermediate incoherent neutron scattering function, Fs(qz, z, t), for distances z from the graphite walls in the range of a few nanometers. Temperatures from about 2Tg down to about 1.15Tg…

Mixed polymeric monolayers and Langmuir-Blodgett multilayers with functional low molecular weight guest compounds

2008

Abstract Mixed monolayers and Langmuir-Blodgett multilayers of functional low molecular weight guest compounds, especially nonlinear optical (NLO) dyes, within the matrix of an amphotropic spacer polymer have been prepared. The polymer matrix enabled the transfer of guest compounds not capable of self-organizing at the air-water interface by themselves. The structure of the LB multilayers and the transfer process were studied by small angle X-ray scattering and UV-visible spectroscopy. Good NLO coefficients were found in the mixed films.