Search results for "Ferrite"
showing 10 items of 98 documents
Microstructural Characterization of Thermo-Mechanical Treated TRIP Steels
2007
The increasing demand for the reduction of automobiles CO2 emissions for environmental preservation leads the automotive industries towards the mechanical components weight reduction. Sheet steels with multiphase microstructures exhibit favourable combinations of strength and ductility. The so called TRIP steels have a metastable microstructure that consists of a continuous ferrite matrix containing a dispersion of hard second phases martensite and bainite. These steels also contain retained austenite, at room temperature, that represents the source of the TRansformation Induced Plasticity effect. When the material is subjected to deformation step, the retained austenite transforms itself i…
Influence of friction on the local mechanical and electrochemical behaviour of duplex stainless steels.
2006
International audience; The electrochemical behaviour of ferritic and austenitic phases in duplex stainless steel (UNS S32304) and the modifications induced by straining during sliding were studied by potentiodynamic polarisation curves determined at the microscale in a 1MNaCl (pH 3) solution, using an electrochemical microcell. The mechanical properties and stress state of each phase were determined by microhardness and X-ray microdiffraction measurements, before and after straining. The results show that sliding generates elastic straining of the ferrite and plastic deformation of the austenite. The electrochemical behaviour of these phases is dramatically altered, inducing a reduction of…
Understanding sigma-phase precipitation in a stabilized austenitic stainless steel (316Nb) through complementary CALPHAD-based and experimental inves…
2014
Abstract Sigma-phase precipitation in a 316Nb “stabilized” austenitic stainless steel was studied through complementary CALPHAD-based and dedicated experimental investigations. Thermokinetic calculations performed using Thermo-Calc (with the DICTRA module) and MatCalc software showed that the sigma phase (σ) precipitated directly at γ-austenite grain boundaries (GB) via a common solid-state reaction when carbon and nitrogen contents fell below a critical threshold. Residual δ ferrite was found to be more susceptible to σ-phase precipitation; this type of precipitation occurred via two mechanisms that depended on the concentration profiles of δ-ferrite stabilizing elements induced by previou…
Study of the mechanical effects on passivity breakdown by local probe techniques
2006
This paper aims at demonstrating that a relationship exists between surface stress and pitting corrosion. The surface stress field generated by polishing was first calculated using a thermo-mechanical model and a finite element code. Pitting corrosion tests performed at the microscale along the austenite/ferrite interface using the electrochemical microcell technique were then analyzed considering the microstructure and the residual surface stress field. Mechano-chemical criteria are proposed leading to an enhancement of pitting corrosion of duplex steels.
Valorisation of industrial iron oxide waste to produce magnetic barium hexaferrite
2016
Barium M-type hexagonal ferrite (BaM, BaFe12O19) is an immensely important magnetic material, which we have successfully made from the simple valorisation of Fe-rich industrial waste from steel wire drawing, with addition of BaCO3 and heating in air to 1000 degrees C. The optimum ratio of Fe. Ba (producing 86 wt% BaM) was found to be 11: 1 (non-stoichiometric), and secondary phases of alpha-Fe2O3 (non-magnetic) and ZnFe2O4 (poorly antiferromagnetic) were always present. This material consisted of small submicron platelets. A hard magnetic ferrite was produced with Ms=48.6 A m(2) kg(-1) and H-c=211.5 kA m(-1). The highest density was achieved by sintering samples with Fe: Ba ratios of 11: 1 …
Surface composition analysis during the oxidation of ferrites: A necessity
1998
The cationic composition of a titanium ferrite (Fe 2.5 Ti 0.5 O 4 ) has been followed by XPS during its oxidation in cation deficient phases (without crystallographic transformation) in order to reveal a dynamic segregation phenomenon. Indeed, during this oxidation, an important modification of the chemical composition of the first layers of the material has been revealed: below 350 °C, the titanium ferrites surface becomes richer in iron and poorer in titanium. But, if the reaction is extended above 400 °C, some titanium can move to the surface. This phenomenon has been interpreted on the basis of the differences of mobility of the different ions which are present in the material. Finally,…
Assessment of the Current for a Non-Linear Power Inductor Including Temperature in DC-DC Converters
2023
A method for estimating the current flowing through a non-linear power inductor operating in a DC/DC converter is proposed. The knowledge of such current, that cannot be calculated in closed form as for the linear inductor, is crucial for the design of the converter. The proposed method is based on a third-order polynomial model of the inductor, already developed by the authors; it is exploited to solve the differential equation of the inductor and to implement a flux model in a circuit simulator. The method allows the estimation of the current up to saturation, intended as the point at which the differential inductance is reduced to half of its maximum value. The current profile depends al…
The study of correlation between microstructure of ferrites and their complex permeability spectra
2013
Theoretical model for complex permeability of polycrystalline ferrite (based on effects arising from realities of typical microstructure of sample) is correlated with experimental data. In the case of NiZn-ferrites there is observed a close agreement with the model and the data; for samples of MnZn-ferrites this agreement is only for small-sized cores; for bigger ones the dimensional effects (dimensional resonance) appear and the model cease to be valid.
Dynamic segregation during ferrite oxidation revealed by XPS
2002
Dynamic segregation phenomena were revealed by XPS during the oxidation of some ferrites (Fe 2.5 Ti 0.5 O 4 , Fe 2.5 Ni 0.5 O 4 , Fe 2 CrO 4 and FeCr 2 O 4 ). This kind of phenomenon induces, at a low temperature (below room temperature), drastic changes in the cationic composition of the most external layers. Dynamic segregation is a function of the cationic composition, the oxidation capability and the morphology of these ferrites. Although dynamic segregation seems to be a quite frequent phenomenon that often can be observed during ferrite oxidation, there are materials in existence where it does not appear, such as molybdenum ferrite.
STRUCTURE AND MAGNETIC PROPERTIES OF COBALT FERRITE PARTICLES PRODUCED BY METHOD OF PYROLYTIC SYNTHESIS
2008
ABSTRACT Magnetic fine particles of cobalt ferrite have been prepared by method of pyrolytic synthesis. X-ray diffraction confirmed the formation of single-phase cobalt ferrite nanoparticles in the range 6–50 nm. The size of the particles varies depending on matrix dispersity and mass content in the organic precursors. A large coercivity observed to be small for smaller single-domain particles due to superparamagnetic behavior.