Search results for "Flashing"

Flashing light emitting diodes (LEDs) induce proteins, polyunsaturated fatty acids and pigments in three microalgae

2020

As the periodic emission of light pulses by light emitting diodes (LEDs) is known to stimulate growth or induce high value biocompounds in microalgae, this flashing light regime was tested on growth and biochemical composition of the microalgae Nannochloropsis gaditana, Koliella antarctica and Tetraselmis chui. At low flashing light frequencies (e.g., 5 and 50 Hz, Duty cycle = 0.05), a strain-dependent growth inhibition and an accumulation of protein, polyunsaturated fatty acids, chlorophyll or carotenoids (lutein, β-carotene, violaxanthin and neoxanthin) was observed. In addition, a 4-day application of low-frequency flashing light to concentrated cultures increased productivities of eicos…

Flashing lights affect the photophysiology and expression of carotenoid and lipid synthesis genes in Nannochloropsis gaditana

2022

Nannochloropsis gaditana is a promising microalga for biotechnology. One of the strategies to stimulate its full potential in metabolite production is exposure to flashing lights. Here, we report how N. gaditana adapts to different flashing light regimes (5, 50, and 500 Hz) by changing its cellular physiology and the relative expression of genes related to critical cellular functions. We analyzed the differential mRNA abundance of genes related to photosynthesis, nitrogen assimilation and biosynthesis of chlorophyll, carotenoids, lipids, fatty acids and starch. Analysis of photosynthetic efficiency and high mRNA abundance of photoprotection genes supported the inference that excess excitati…

Eulerian-Eulerian modelling and computational fluid dynamics simulation of wire mesh demisters in MSF plants

2014

Purpose – The purpose of this study is to focus on simulation of wire mesh demisters in multistage flash desalination (MSF) plants. The simulation is made by the use of computational fluid dynamics (CFD) software. Design/methodology/approach – A steady state and two-dimensional (2D) model was developed to simulate the demister. The model employs an Eulerian-Eulerian approach to simulate the flow of water vapor and brine droplets in the demister. The computational domain included three zones, which are the vapor space above and below the demister and the demister. The demister zone was modeled as a tube bank arrange or as a porous media. Findings – Sensitivity analysis of the model showed t…

Eulerian–Lagrangian modeling and computational fluid dynamics simulation of wire mesh demisters in MSF plants

2016

Abstract This study focuses on computational fluid dynamics model (CFD) for simulation of demisters in multistage flash desalination (MSF). The Eulerian–Lagrangian model (steady-state and two-dimensional) was developed to simulate the demister. The model was used to simulate the flow of water vapor and brine droplets in the demister. The computational domain includes the following three zones: the vapor space above the demister, the vapor space below the demister, and the demister. The demister zone was modeled as tube banks. A sensitivity analysis of the model revealed that vapor velocity is the main parameter that affects demister performance. Additionally, the analysis indicated that vap…

Simulation of stability and dynamics of multistage flash desalination

2011

gPROMS software was used to study the dynamics of a multistage flash desalination brine circulation system (MSF-BR) as a function of major operating parameters. Most of the previous studies focused on MSF-BR dynamic model development however; it gave very little information on dynamic response of the system to the most significant process independent parameters. The present model was first validated against available industrial data of different plants. System dynamics were obtained upon increasing/decreasing several of the operating parameters over a range of ± 15%. Results show that increase/decrease of the cooling seawater flow rate have limited effect on the system dynamics. Increasing/…

Steady State and Dynamic Models of Multistage Flash Desalination: A Review

2010

This article focuses on a review of literature studies on steady state and dynamic modeling of the multistage flash desalination process (MSF). The review shows that both steady state and dynamic models are based on lumped parameter approach. Differences in literature models are found in the assumptions used to model the flashing stage in addition to the correlations used to determine the heat transfer coefficients, thermodynamic losses, thermodynamic and transport properties. Interestingly, literature indicates a rapid progress made in software used for coding and solution of the model equations. The review shows a limited number of literature models for the internals of the flashing stage…

Once t hrough m ultistage fl ash d esalination: gPROMS d ynamic and s teady s tate m odeling

2010

This study focuses on modeling the steady state and dynamic behavior of the multistage flash desalination process (MSF) using gPROMS. This modeling tool allows for simultaneous coding of the system dynamics and steady state performance. In addition, it allows the use of the most efficient solvers for a set of non-linear differential and algebraic equations describing the MSF process. The system model and analysis are based on actual plant data that includes 21 flashing stages and a capacity of 378 kg/s (32,000 m3/d). The simulated unit is part of a massive MSF installation in Doha, Kuwait. System's dynamic behavior is simulated by a step change in the input values of the main operating para…

Experimental investigation of the effects of efficiency promoters in a MSF lab-scale unit

2006

CFD Modelling of the Demister in the Multi Stage Flash Desalination plant

2011

Abstract Demisters are used to remove entrained brine droplets from flashed off vapor within the flashing stages of the multi stage flash desalination process (MSF). This is necessary to prevent accumulation of brine droplets on the outside surface of the condenser tubes and contamination of the desalinated water. The aim of this work is to design a new demister with lower pressure drop and unaffected separation efficiency which can be later installed in the flashing stages of the MSF plant and causes reduction in the required heat transfer area. In this work the demister performance is predicted as a function of design (wire diameter), and operating parameters (stage temperature). This obj…

Investigation of flashing phenomena in MSF chambers

2007

The MSF process has covered in the last years more than 50% of world production of desalinated water from the sea. Although this process has been used for several decades, the large energy requirements force to search for new and feasible ways to improve the overall thermal efficiency. Few studies have bee carried out in lab-scale, pilot and industrial MSF units, underlining the complexity of flashing phenomena and the importance of operating parameters settings for optimal performance. In the present work a study on fundamental phenomena occurring inside MSF chambers has been carried out, focusing on the dependence of flashing efficiency on operating parameters and the effects of flashing …