Search results for "Fluid dynamics"
showing 10 items of 1005 documents
Isotropic-nematic interface and wetting in suspensions of colloidal platelets.
2006
We study interfacial phenomena in a colloidal dispersion of sterically stabilized gibbsite platelets, exhibiting coexisting isotropic and nematic phases separated by a sharp horizontal interface. The nematic phase wets a vertical glass wall and polarized light micrographs reveal homeotropic surface anchoring both at the free isotropic-nematic interface and at the wall. On the basis of complete wetting of the wall by the nematic phase, as found in our density functional calculations and computer simulations, we analyze the balance between Frank elasticity and surface anchoring near the contact line. Because of weak surface anchoring, the director field in the capillary rise region is uniform…
Numerical analysis of the influence of ultrasonic vibration on crystallization processes
2011
The challenge in the future fabrication of semiconductor bulk crystals is the improvement of the crystal quality with a simultaneous increase of the yield. For that, a proper control of mass transfer within the fluid phase is required. Besides the damping of violent convective fluctuations, the thickness of the diffusion boundary layer, causing morphological instability, has to be decreased. The influence of ultrasound in molten Germanium was analyzed by numerical simulations. The simulations were provided by applying commercial software packages ANSYS ® and FLUENT ® . ANSYS ® was used to model the ultrasonic wave propagation in the whole growth system consisting of melt and crystal, crucib…
Microactuators: Control of the Properties of Micrometer Sized Actuators from Liquid Crystalline Elastomers Prepared in a Microfluidic Setup (Adv. Fun…
2010
In this article new results on the preparation of monodisperse particles from a liquid crystalline elastomer in a microfluidic setup are presnted. For this, droplets from a liquid crystalline monomer are prepared in a microfluidic device and polymerized while they are flowing inside a microtube. The particles obtained by this method possess an internal orientation, which gives them actuating properties. When they are heated into the isotropic phase of the liquid crystalline material they show a reversible change in shape whereby they change their length in one direction by almost 100%. It is shown how the variation of experimental parameters during their synthesis impacts the properties of…
Labyrinthine instability of miscible magnetic fluids
2002
Abstract We consider an inhomogeneous magnetic fluid (MF), modeling a miscible MF pair, in a Hele–Shaw cell under a normal field. A linear stability analysis for the sharp straight interface (analytically) and for the diffused one (numerically) is performed. For the former case, the neutral curves and the stability diagram are found along with the critical wavelength and parameter values. Oscillatory or monotonous instabilities are shown to occur. For the diffused interface, we recognize the importance of 2D flow viscous effects along with the conventional wall friction and observe that in strong fields the dominant wavelength scales as the cell gap.
Hydraulic jumps at drop and abrupt enlargement in rectangular channel
2002
The different types of hydraulic jumps that occur in a rectangular channel at an abrupt increase in section are experimentally studied. The abrupt section increase is due to both a drop and an increase in the channel width. Experiments were carried out with three different values of the ratio L/l between the channel widths respectively downstream and upstream of the abrupt section increase. For each L/l value five values of Froude number F1, of the supercritical flow upstream of the section increase were considered, and for each of them live values of the depth y1 of the same flow. The experiments showed that, as the depth y2 of the downstream subcritical flow increases, several types of hy…
Nanodroplets on a solid plane: wetting and spreading in a Monte Carlo simulation
2002
Abstract The wetting behavior and spreading dynamics of small polymer melt droplets in the course of transition from partial to complete wetting conditions on a flat structureless solid substrate have been studied by dynamic Monte Carlo simulation. From the density profiles of the drops we determine the contact angles at varying strength of the van der Waals surface forces in the whole interval of partial wetting. The validity of Young's equation is then tested whereby the surface tension of the melt/vapor interface is derived independently from interfacial fluctuation analysis, and the surface free energy of the melt at the substrate—from the anisotropy of the local pressure at the wall. T…
Numerical Simulation as a Tool for Design Optimization of Two-Phase Swirl Flow Atomizers
2021
This study aims to analyze the hydrodynamics in two-phase swirl flow conical atomizers. The Euler-Euler model was used for the calculations. Numerical simulations were performed to provide information about the fluid velocity distribution and the atomizer’s internal flow. The numerical calculations confirmed the experimental data. This data was found based on the consistency of the spray angles obtained by both methods. Assuming the correctness of the numerical simulations performed, they can be treated as a tool for further analysis of mass and energy exchange along with the atomizer and optimizing the atomizer’s design depending on the requirements. The influence of the swirl chamber geom…
Cross-stream migration of a Brownian droplet in a polymer solution under Poiseuille flow
2018
The migration of a Brownian fluid droplet in a parallel-plate microchannel was investigated using dissipative particle dynamics computer simulations. In a Newtonian solvent, the droplet migrated toward the channel walls due to inertial effects at the studied flow conditions, in agreement with theoretical predictions and recent simulations. However, the droplet focused onto the channel centerline when polymer chains were added to the solvent. Focusing was typically enhanced for longer polymers and higher polymer concentrations with a nontrivial flow-rate dependence due to droplet and polymer deformability. Brownian motion caused the droplet position to fluctuate with a distribution that prim…
Deformation of flexible ferromagnetic filaments under a rotating magnetic field
2019
Research on magnetic particles dispersed in a fluid medium, actuated by a rotating magnetic field, is becoming increasingly active for both lab-on-chip and bio-sensing applications. In this study, we experimentally investigate the behaviour of ferromagnetic filaments in a rotating field. Filaments are synthesized by linking micron-sized ferromagnetic particles with DNA strands. The experiments were conducted under different magnetic field strengths, frequencies and filament sizes, and deformation of the filaments was registered via microscope and camera. The results obtained showed that the body deformation is larger for longer filaments and higher frequencies and lower for larger magnetic …
Osmotic compression of droplets of hard rods: a computer simulation study
2009
By means of computer simulations, we study how droplets of hard, rodlike particles optimize their shape and internal structure under the influence of the osmotic compression caused by the presence of spherical particles that act as depletion agents. At sufficiently high osmotic pressures, the rods that make up the drops spontaneously align to turn them into uniaxial nematic liquid-crystalline droplets. The nematic droplets or "tactoids" that are formed this way are not spherical but elongated, resulting from the competition between the anisotropic surface tension and the elastic deformation of the director field. In agreement with recent theoretical predictions, we find that sufficiently sm…