Search results for "Gradation"
showing 10 items of 1275 documents
Effects of aging in salt spray conditions on flax and flax/basalt reinforced composites: Wettability and dynamic mechanical properties
2016
Abstract In the last years, the industrial policies are more attentive to issues concerning sustainability, recycling and environmental care. Therefore, the use of natural fibres in composite materials has spread more and more. This paper deals with flax and basalt fibres within an epoxy matrix by investigating the wettability and the dynamic mechanical properties of the resulting composites, subjected to long-term aging tests in critical environmental conditions. The first laminate was constituted by stacking ten layers of bidirectional flax fabrics. The second one was produced by replacing two external flax layers with two layers of basalt mat, for each side of the laminate. Both laminate…
Heterostructured metal oxides-ZnO nanorods films prepared by SPPS route for photodegradation applications
2019
Abstract This work presents the first preparation using the Solution Precursor Plasma Spray process of heterostructured films associating ZnO nanorods (NRs) and various metal oxides (CuO, Fe2O3 and Co3O4) by Solution Precursor Plasma Spray process. These CuO/ZnO, Fe2O3/ZnO and Co3O4/ZnO films exhibit hierarchically chocolate sticks-like, dandelion-like or chrysanthemum-like surface morphologies. These heterostructures were confirmed by SEM, XRD, EDS and Raman analyses. The bandgaps of heterostructured films are narrower than that of pure ZnO. The CuO/ZnO film exhibits the highest photocatalytic activity both under UV and visible light irradiation for the degradation of the Orange II dye due…
A comparative study of photocatalytically active nanocrystalline tetragonal T zyrcon- type and monoclinic scheelite-type bismuth vanadate
2018
The authors from Vinča Institute of Nuclear Sciences acknowledge the financial support of the Ministry of Education, Science and Technological Development of the Republic of Serbia (Project no: 172056 ). The work of K. Smits was supported by Latvian National Research Program IMIS2 (Grant no. 302/2012 ).
Hydrothermal ageing of polylactide/sisal biocomposites. Studies of water absorption behaviour and Physico-Chemical performance
2014
An accelerated hydrothermal degrading test was designed in order to analyse the synergic effect of water and temperature on PLA/sisal biocomposites with and without coupling agent. As well, the physicochemical properties of biocomposites were monitored along the hydrothermal test by means of Scanning Electron Microscopy, Size Exclusion Chromatography and Differential Scanning Calorimetry. The addition of fibre induced higher water absorption capability and promoted physical degradation, as observed in the surface topography. During the processing of biocomposites and throughout the hydrothermal ageing, a reduction of molecular weight due to chain scission was found. As a consequence, a fast…
Rheological, mechanical and morphological characterization of monopolymer blends made by virgin and photo-oxidized polypropylene
2021
In this work, monopolymer blends of virgin polypropylene and photo-oxidized polypropylene were prepare and characterized. The polypropylene samples were subjected to accelerated ageing to simulate the effects of outdoor exposure of polypropylene. After exposure, samples were pelletized and mixed with the same virgin polymer. The rheological, mechanical and morphological characterization was conducted on both the polymers and the blends. Both viscosity and mechanical properties decrease with increases in the content of recycled, photo-oxidized components and of the level of degradation of this component. In addition, the experimental data were compared with a model that takes into account bo…
The influence of the temperature of insulation oil on the results of measurements of the acoustic emission signals generated by partial discharges
2005
The subject matter of this paper refers to the improvement of the acoustic emission method (AE) used for evaluation of partial discharges (PDs) generated in paper-oil insulation systems of power appliances. The paper presents the measurement and analysis results of the AE signals generated by partial discharges of the surface type (SPDs). The AE signals were measured on the surface of a transformer tub using a broad-band contact transducer, and then they were subject to a time-frequency analysis. The measurements were taken while heating transformer oil in the range from 30 to 85°C with gradation of every 5°C. For time runs, amplitude and energy density spectra the descriptor values that ch…
Segmented Thermoelectric Oxide-Based Module for High-Temperature Waste Heat Harvesting
2015
We report a high-performance thermoelectric (TE) oxide-based module using the segmentation of half-Heusler Ti_(0.3)Zr_(0.35)Hf_(0.35)CoSb_(0.8)Sn_(0.2) and misfit-layered cobaltite Ca_3Co_4O_(9+δ) as the p-leg and 2 % Al-doped ZnO as the n-leg. The maximum output power of a 4-couple segmented module at ΔT=700 K attains a value of approximately 6.5 kW m^(−2), which is three times higher than that of the best reported non-segmented oxide module. The TE properties of individual legs, as well as the interfacial contact resistances, were characterized as a function of temperature. Numerical modeling was used to predict the efficiency and to evaluate the influence of the electrical and thermal lo…
Effectiveness of some protective and self-cleaning treatments: a challenge for the conservation of temple G stone in Selinunte
2021
Abstract The Temple G of the Archaeological Park of Selinunte (Italy), the largest in Europe, is one of the most impressive temples in the Magna Grecia. Today, it is completely destroyed due to a strong earthquake occurred in the Middle Ages. The used stone is a calcarenite coming from the ancient and renowned quarries of Cusa near the acropolis. This work comes from the today’s proposal of Temple G anastylosis. The goal of the work is to provide the results relating the protective effectiveness of three polymer formulations, appropriately selected, on stone samples taken from the “Capitello” quarry, part of “Cusa quarries”. The formulations functionality was deployed by adding TiO2 nanopar…
Photoelectrochemical removal of chlorfenvinphos by using WO3 nanorods: Influence of annealing temperature and operation pH
2019
[EN] A visible-light driven photoelectrochemical degradation process has been applied to a solution polluted with the organophosphate insecticide chlorfenvinphos. Different WO3 nanosheets/nanorods have been used as photoanodes. These nanostructured electrodes have been fabricated by anodization of tungsten and, subsequently, they have been subjected to a thermal treatment (annealing). The combined influence of annealing temperature (400¿°C and 600¿°C) and operation pH (1 and 3) on the photoelectrocatalytic behavior of these nanorods has been examined through a statistical analysis. Morphological, structural and photoelectrochemical characterizations have also been carried out. The chlorfenv…
Nano-hybrids based on quercetin and carbon nanotubes with excellent anti-oxidant activity
2016
Abstract Multi-functional nano-hybrids based on Quercetin (Q), a natural antioxidant, and functionalized Carbon Nanotubes (CNTs) have been formulated and used to prepare Ultra High Molecular Weight PolyEthylene (UHMWPE)-based nanocomposites. The study of the nanocomposites rheological behaviour shows that the immobilization of Q molecules onto CNTs outer surface leads to a beneficial effect on the state of the interface between polymer and nanoparticles. Additionally, the investigation of the thermo- and photo-oxidation processes reveals that the hybrids nanoparticles are able to exert a remarkable stabilizing action, due to strong physical interaction between Q and CNTs. In particular, the…