Search results for "Hildebrand"

Pressure dependence of the demixing of polymer solutions determined by viscometry

1981

From the break-down in the viscosity of a polymer solution, associated with the entrance into the two phase region, the pressure dependence of the demixing temperatures of solutions of polystyrene (M = 600.000) in cyclohexane, cyclopentane, diethylmalonate and 1-phenyldecane was measured up to 1000 bar. The application of pressure increases the solubility of polystyrene in cyclopentane and diethylmalonate, but decreases that in 1-phenyldecane; in the case of cyclohexane, a pressure of optimum miscibility is observed at ca. 120 bar.

Structure-properties relationships of polyhedral oligomeric silsesquioxane (POSS) filled PS nanocomposites

2012

The polyhedral oligomeric silsesquioxane (POSS) additivated polystyrene (PS) based nanocomposites were pre- pared by melt processing and the structure-properties relationships of the POSS-PS systems were compared to those of the neat PS. In order to investigate the effect of these structural parameters on the final properties of the polymer nanocompos- ites, five different kinds of POSS samples were used, in particular, POSS with different inorganic cage and with different organic pendent groups. The rheological investigation suggests clearly that the POSS acts as a plasticizer and that the processability of the PS was positively modified. The affinity between the POSS samples and the PS ma…

Liquid phase exfoliation of antimonene: systematic optimization, characterization and electrocatalytic properties

2019

Antimonene, a novel group 15 two-dimensional material, is attracting great attention due to its outstanding physical and chemical properties. Despite its thermodynamic stability, the pronounced covalent character of the interlayer interactions imposes severe limitations on its exfoliation into mono- and few-layer. Here, we develop a systematic study of liquid phase exfoliation (LPE) with the aim to optimize antimonene production in terms of concentration and dimensional anisotropy, investigating the most relevant experimental factors affecting the exfoliation: pre-processing of pristine antimony, solvent selection based on Hansen solubility parameters and ultrasound conditions. Moreover, ex…

1985

Using a self-constructed light scattering apparatus, the pressure dependence of the demixing temperature of solutions of PVC 20 000, PVC 37 000 and PVC 70 000 in THE/water was determined up to 1 000 bar for different compositions of the mixed solvent. (The numbers in the codes of the PVC specimens are their approximate molecular weights.) In contrast to the thetasolvents o-xylene and phenetole, the solubility decreases with increasing pressure for all molecular weights and compositions under investigation typically by about 1 K/100 bar. The evaluation of the experimental findings demonstrates that the volume fraction of the nonsolvent in the mixed solvent, φ, is the variable that governs ph…

1985

From the break-down in the viscosity and from the increase of the intensity of the scattered light, associated with the entrance into the two-phase region, the pressure dependence of the demixing temperature of solutions of PVC 37 000, PVC 75 000 and PVC 100 000 in phenetole and PVC 75 000 in o-xylene was measured up to 1 000 bar. (The numbers in the codes of the PVC specimens are their approximate molecular weights.) The application of pressure increases the demixing temperatures of PVC in both solvents by about 1 K/100 bar. For a qualitative forecast of the pressure effects, the solubility parameter theory in combination with the corresponding states principle, and an empirical correlatio…

1985

Investigations with ca. 100 organic liquids in a temperature range from −20°C to 90°C result in a survey of the solubility behaviour of PVC. The experimental results were compared with the predictions of the solubility parameter theory: Accepting δ = 9,75 (cal/cm3)1/2 as the solubility parameter for PVC, all solvents (except ketones in which PVC is soluble independent of their solubility parameters) are located within the range of δPVC ± 0,75. Only three of the 100 liquids examined turned out to be (endothermal) theta-solvents, namely the aromatic solvents o-xylene, phenetole and dimethyl phthalate. The theta-temperatures in o-xylene and phenetole were determined viscometrically by means of…

A Promising New Method to Estimate Drug-Polymer Solubility at Room Temperature

2016

The established methods to predict drug-polymer solubility at room temperature either rely on extrapolation over a long temperature range or are limited by the availability of a liquid analogue of the polymer. To overcome these issues, this work investigated a new methodology where the drug-polymer solubility is estimated from the solubility of the drug in a solution of the polymer at room temperature using the shake-flask method. Thus, the new polymer in solution method does not rely on temperature extrapolations and only requires the polymer and a solvent, in which the polymer is soluble, that does not affect the molecular structure of the drug and polymer relative to that in the solid st…

Influence of Polymer Molecular Weight on Drug–polymer Solubility: A Comparison between Experimentally Determined Solubility in PVP and Prediction Der…

2015

ABSTRACT: In this study, the influence of polymer molecular weight on drug–polymer solubility was investigated using binary systems containing indomethacin (IMC) and polyvinylpyrrolidone (PVP) of different molecular weights. The experimental solubility in PVP, measured using a differential scanning calorimetry annealing method, was compared with the solubility calculated from the solubility of the drug in the liquid analogue N-vinylpyrrolidone (NVP). The experimental solubility of IMC in the low-molecular-weight PVP K12 was not significantly different from that in the higher molecular weight PVPs (K25, K30, and K90). The calculated solubilities derived from the solubility in NVP (0.31–0.32 …

Lattice fluid model generalized for specific interactions: An application to ternary polymer solutions

2011

Abstract The phase diagram of the Poly- l -Lactic-Acid (PLLA), dioxane and water system was derived by using the lattice fluid model generalized for specific interactions. A qualitative analysis of Hansen solubility parameters together with empirical observations were adopted to reduce the number of adjustable parameters. The as-selected model parameters were derived by fitting a set of cloud point curves; consequently, the complete phase diagram of the system was computed. The use of specific interactions between species gave out a quantitative agreement with a set of experimental data, whereas changing the polymer polydispersity the agreement is only qualitative. In principle, the present…

1977