Search results for "INTERFACE"

Low intrinsic carrier density LSMO/Alq3/AlOx/Co organic spintronic devices

2018

The understanding of spin injection and transport in organic spintronic devices is still incomplete, with some experiments showing magnetoresistance and others not detecting it. We have investigated the transport properties of a large number of tris-(8-hydroxyquinoline)aluminum-based organic spintronic devices with an electrical resistance greater than 5 MΩ that did not show magnetoresistance. Their transport properties could be described satisfactorily by known models for organic semiconductors. At high voltages (>2 V), the results followed the model of space charge limited current with a Poole-Frenkel mobility. At low voltages (∼0.1 V), that are those at which t…

Pickering Emulsions of Fluorinated TiO2: A New Route for Intensification of Photocatalytic Degradation of Nitrobenzene

2020

International audience; Fluorination of the TiO2 surface has been often reported as a tool to increase the photocatalytic efficiency due to the beneficial effects in terms of production of oxidizing radicals. Moreover, it is shown that the unique amphiphilic properties of the fluorinated TiO2 (TiO2-F) surface allow one to use this material as a stabilizer for the formulation of Pickering emulsions of poorly soluble pollutants such as nitrobenzene (NB) in water. The emulsions have been characterized in terms of size of the droplets, type of emulsion, possibility of phase inversion, contact angle measurements, and optical microscopy. The emulsified system presents micrometer-sized droplets of…

Colloidal nanoparticle sorting and ordering on anodic alumina patterned surfaces using templated capillary force assembly

2017

Abstract A new, robust technique of size-selective nanoparticle ordering on porous anodized aluminum oxide (PAAO) templates is presented. Simultaneous particle sorting and array formation is achieved for the first time using a polydisperse suspension of irregularly shaped diamond nanocrystals. The array parameters can be tuned through a balance of evaporation driven particle flux, capillary, electrostatic, and adhesion forces, which are influenced by the asperities of the surface during the capillary and convective assembly dip-coating process. The resulting structures are dense (lower limit approximately 50 nm center separation), isolated (non-touching) nanoparticle arrays with a size dist…

Polyelectrolyte Brushes Grafted at the Air/Water Interface

1997

A new approach for the study of grafted polyelectrolytes is investigated:  monolayers at the air/water interface of block copolymers consisting of a liquid hydrophobic and a polyelectrolyte block. ...

Forces between colloidal particles in aqueous solutions containing monovalent and multivalent ions

2017

The present article provides an overview of the recent progress in the direct force measurements between individual pairs of colloidal particles in aqueous salt solutions. Results obtained by two different techniques are being highlighted, namely with the atomic force microscope (AFM) and optical tweezers. One finds that the classical theory of Derjaguin, Landau, Verwey, and Overbeek (DLVO) represents an accurate description of the force profiles even in the presence of multivalent ions, typically down to distances of few nanometers. However, the corresponding Hamaker constants and diffuse layer potentials must be extracted from the force profiles. At low salt concentrations, double layer f…

Adhesive joining of Aluminum AA6082: the effect of resin and surface treatment

2009

Abstract In this work the effects of both the substrate surface condition and the adhesive properties on single-lap aluminium joint resistance were analysed. The aluminium sheets were mechanically treated with two abrasive surfaces evaluating the induced roughness; four different resins were used in adhesion tests. Moreover, wettability tests were performed in order to evaluate the effect of the above-mentioned parameters on the substrate/adhesive interaction. A design of experiments was defined in order to quantify the effect of the considered factors and their correlation.

Oscillatory interaction between two like‐charged nanoparticles induced by polyelectrolyte brush–solvent interface

2016

Scattering perspectives on nanostructural inhomogeneity in polymer network gels

2017

Abstract Scattering methods based on spatial and temporal contrast fluctuations in polymer-network gels, which originate from polymer-segmental density fluctuations, reveal rich insight into different types and levels of nanostructural inhomogeneity in these soft materials. Complementary contrasting as provided by light, neutron, and X-ray scattering allows such information to be obtained on nano- to micrometer length scales. On top of that, complementary use of static and dynamic scattering methods allows the interplay and effect of these inhomogeneities to be unraveled. This article interrelates a multitude of studies on the application of scattering techniques for analytical assessment o…

PAA-PAMPS Copolymers as an Efficient Tool to Control CaCO3 Scale Formation

2013

Scale formation, the deposition of certain minerals such as CaCO3, MgCO3, and CaSO4 center dot 2H(2)O in industrial facilities and household devices, leads to reduced efficiency or severe damage. Therefore, incrustation is a major problem in everyday life. In recent years, double hydrophilic block copolymers (DHBCs) have been the focus of interest in academia with regard to their antiscaling potential. In this work, we synthesized well-defined blocklike PAA-PAMPS copolymers consisting of acrylic acid (AA) and 2-acrylamido-2-methyl-propane sulfonate (AMPS) units in a one-step reaction by RAFT polymerization. The derived copolymers had dispersities of 1.3 and below. The copolymers have then b…

Calcium Sulfate Nanoparticles with Unusual Dispersibility in Organic Solvents for Transparent Film Processing

2018

Calcium sulfate is one of the most important construction materials. Today it is employed as high-performance compound in medical applications and cement mixtures. We report a synthesis for calcium sulfate nanoparticles with outstanding dispersibility properties in organic solvents without further functionalization. The nanoparticles (amorphous with small γ-anhydrite crystallites, 5–50 nm particle size) form long-term stable dispersions in acetone without any sign of precipitation. 1H NMR spectroscopic techniques and Fourier-transform infrared spectroscopy (FTIR) reveal absorbed 2-propanol on the particle surfaces that induce the unusual dispersibility. Adding water to the nanoparticle disp…