Search results for "IPM"
showing 10 items of 1361 documents
Quantum dot-block copolymer hybrids with improved properties and their application to quantum dot light-emitting devices.
2009
To combine the optical properties of CdSe@ZnS quantum dots (QDs) with the electrical properties of semiconducting polymers, we prepared QD/polymer hybrids by grafting a block copolymer (BCP) containing thiol-anchoring moieties (poly(para-methyl triphenylamine-b-cysteamine acrylamide)) onto the surfaces of QDs through the ligand exchange procedure. The prepared QD/polymer hybrids possess improved processability such as enhanced solubility in various organic solvents as well as the film formation properties along with the improved colloidal stability derived from the grafted polymer shells. We also demonstrated light-emitting diodes based on QD/polymer hybrids, exhibiting the improved device …
Comparative evaluation of the swelling and degrees of cross-linking in three organic gel packings for SEC through some geometric parameters.
2003
Abstract The size exclusion chromatographic (SEC) behavior of five solvent/polymer systems in three organic column packings based on polystyrene/divinylbenzene (PS/DVB) copolymer, TSK-Gel H HR , μ-styragel and TSK-Gel H XL , has been compared. All the packings offer similar characteristics (pore size, particle size and efficiency) but some differences have been found when eluting the same systems. The different elution behavior observed in both polymeric gels has been analyzed in terms of their swelling and cross-linking degrees and of the fractal parameters. From the Universal Calibration plots, values of the chromatographic partition coefficient, K p , have been obtained and using some eq…
Formation and Rupture of Schottky Nanocontacts on ZnO Nanocolumns
2007
In this paper, the electrical transport and mechanical properties of Pt/ZnO Schottky nanocontacts have been studied simultaneously during the formation and rupture of the nanocontacts. By combining multidimensional conducting scanning force spectroscopy with appropriated data processing, the physical relevant parameters (the ideality factor, the Schottky barrier height, and the rupture voltage) are obtained. It has been found that the transport curves strongly depend on the loading force. For loading forces higher than a threshold value, the transport characteristics are similar to those of large-area Schottky contact, while below this threshold deviations from strictly thermionic emission …
Direct imaging of delayed magneto-dynamic modes induced by surface acoustic waves.
2017
The magnetoelastic effect—the change of magnetic properties caused by the elastic deformation of a magnetic material—has been proposed as an alternative approach to magnetic fields for the low-power control of magnetization states of nanoelements since it avoids charge currents, which entail ohmic losses. Here, we have studied the effect of dynamic strain accompanying a surface acoustic wave on magnetic nanostructures in thermal equilibrium. We have developed an experimental technique based on stroboscopic X-ray microscopy that provides a pathway to the quantitative study of strain waves and magnetization at the nanoscale. We have simultaneously imaged the evolution of both strain and magne…
Photo-switching spin pairs—synergy between LIESST effect and magnetic interaction in an iron(ii) binuclear spin-crossover compound
2001
The decrease of the magnetic response under irradiation at very low temperature was interpreted as a new evidence of synergy between magnetic interaction and spin transition in an iron(II) binuclear SC compound. Real Cabezos, Jose Antonio, Jose.A.Real@uv.es
Permanent magnetism in apoferritin-encapsulated Pd nanoparticles
2007
Pd nanoparticles have been prepared within the apoferritin cavity. X-Ray powder diffraction, transmission electronic microscopy and magnetization measurements have been used for characterizing the nanoparticles. The nanoparticles exhibit permanent magnetism at room temperature.
Structural and magnetic characterization of Pd nanoparticles encapsulated in apoferritin
2010
Pd nanoparticles exhibiting permanent magnetism at room temperature have been prepared within the apoferritin cavity. Pd nanoparticles in air and under an inert atmosphere were synthesized to study the influence of the aerobic and anaerobic conditions in the final magnetic properties. The surface of nanoparticles as well as the type of crystalline phase could determine the magnetic properties. X-ray powder diffraction, including Debye-function analysis, transmission electronic microscopy, and magnetization measurements have been used for characterizing the nanoparticles.
Dispersion of magnetic susceptibility in a suspension of flexible ferromagnetic rods
2020
Abstract The properties of suspensions of magnetosomes extracted from magnetotactic bacteria are investigated. By using dynamic light scattering and measuring the dispersion of magnetic susceptibility it is shown that sonicated samples with broken magnetosome chains have qualitatively different behavior in comparison with native samples. This is explained by the presence of flexible chains of magnetosomes in non-sonicated samples which have the qualitative features of magnetic susceptibility predicted by the model of flexible magnetic rods.
A Monte Carlo study of intersource effects in dome-type applicators loaded with LDR Cs-137 sources
2005
In this study, the dose rate distributions produced by low dose rate Cs-137 sources loaded in afterloadable dome applicators are studied using the Monte Carlo method. Dose differences between Monte Carlo results and calculations done using the superposition principle are within 1-3% in front of the applicator and between 3 and 10% near and along the longitudinal source axis. Consequently, the real doses to lateral vaginal wall, rectum and bladder are very close to the doses estimated applying the superposition principle, while the dose to the vaginal cuff has been overestimated by up to 10%.
Corrosion protection of Nd–Fe–B type permanent magnets by zinc phosphate surface conversion coatings
2001
Abstract The use of protective zinc phosphate top coatings to protect Nd–Fe–B type permanent magnets against corrosion is discussed. The progress of the phosphatisation process has been tested by simultaneous measurement of pH near surface, corrosion potential, substrate mass loss and phosphate coating mass gain. The corrosion behaviour of the magnet in phosphate solution was analyzed by the anodic polarization technique and the general resistance of the magnet to corrosion was evaluated by the Akimov drop test. It is shown that immersion of the magnet in the acidified (pH=2) phosphating solution containing Zn(II), nitrate and fluoride ions resulted in the formation of well adhered, thin an…