Search results for "IRRADIANCE"

A procedure to calculate the I–V characteristics of thin-film photovoltaic modules using an explicit rational form

2015

Abstract Accurate models of the electrical behaviour of photovoltaic modules are effective tools for system design. One or two diode equivalent circuits have been widely used even though some mathematical difficulties were found dealing with implicit equations. In this paper, a new model based on a simple rational function, which does not contain any implicit exponential form, is presented. The model was conceived in order to be used with thin-film photovoltaic modules, whose current–voltage curves are characterised by very smooth shapes. The parameters of the model are evaluated by means of the derivatives of the issued characteristics in the short circuit and open circuit points at standa…

A procedure to evaluate the seven parameters of the two-diode model for photovoltaic modules

2019

Abstract The paper presents an analytical procedure to calculate the seven parameters of the two-diode model of photovoltaic (PV) panels for any value of the solar irradiance and cell temperature. Six parameters (the photocurrent, the diode reverse saturation currents, the quality factor of the first diode and the series and shunt resistances), are evaluated by solving the equations related to the properties of the main points of the current-voltage (I-V) characteristics. The further information, necessary to calculate the entire set of seven truly independent parameters, is based on two conditions that have to be simultaneously satisfied: 1) the exclusion of negative values of the model pa…

An accurate one-diode model suited to represent the current-voltage characteristics of crystalline and thin-film photovoltaic modules

2020

Abstract In this paper a new one-diode model, conceived in order to be used to represent the current-voltage curves of both crystalline and thin-film photovoltaic modules, is presented. The model parameters are calculated from the information contained in the datasheets issued by manufactures by means of simple iterative procedures that do not require the assumption of simplifying hypotheses. Some innovative relations describing the dependence of the parameters from the solar irradiance and cell temperature are adopted in order to permit the model to reliably simulate the electrical behaviour of photovoltaic devices operating in real conditions. The ability of the model to calculate the cur…

Development of a test station for accurate in situ I-V curve measurements of photovoltaic modules in Southern Norway

2011

The development of an outdoor test station for accurate in situ I-V curve measurements of photovoltaic (PV) modules is described. The modules are installed in an open-rack configuration at the University of Agder in Southern Norway. Seven new and three aged PV modules of different type and make are being tested, including mono-and multicrystalline silicon from differing manufacturing routes, triple-junction amorphous silicon, and CIS. Data acquisition is controlled with a multichannel electronic load system and LabVIEW software, recording high-resolution I-V curves at one-minute intervals. Between I-V curve sweeps, each module is operated at the maximum power point. Characteristic electrica…

Artificial Neural Networks to Predict the Power Output of a PV Panel

2014

The paper illustrates an adaptive approach based on different topologies of artificial neural networks (ANNs) for the power energy output forecasting of photovoltaic (PV) modules. The analysis of the PV module’s power output needed detailed local climate data, which was collected by a dedicated weather monitoring system. The Department of Energy, Information Engineering, and Mathematical Models of the University of Palermo (Italy) has built up a weather monitoring system that worked together with a data acquisition system. The power output forecast is obtained using three different types of ANNs: a one hidden layer Multilayer perceptron (MLP), a recursive neural network (RNN), and a gamma m…

Estimation of atmospheric water vapour content from direct measurements of radiance in the thermal infrared region

2012

Atmospheric water vapour content is a required parameter in thermal infrared (TIR) to carry out processes such as atmospheric correction or retrieving atmospheric factors (downwelling or upwelling irradiance, transmittance of the atmosphere and so on). This study proposes an alternative method to the ones already in use to measure water vapour content from direct measurements of downwelling atmospheric radiance in the TIR range. It was possible to estimate a linear relationship between atmospheric water vapour and downwelling atmospheric radiance using a simulated study, based on data from a radiosounding database. A subsequent validation concludes that it is possible to obtain water vapour…

Analysis of the aerosol radiative forcing over a Mediterranean urban coastal site

2014

Abstract The aerosol radiative forcing for the period 2003–2011 has been analyzed in Burjassot, Spain, an urban coastal site on the western Mediterranean, using measurements of global solar irradiance and aerosol properties, as well as simulated data. The aerosol radiative forcing was calculated at 5 minute intervals, and then integrated over 24 h to obtain daily mean values for 200 complete days under cloud-free skies. The monthly mean values of the aerosol radiative forcing showed a clear variation during the year, associated to the annual variability of the aerosol optical depth at 500 nm, ranging from − 6 to − 29 Wm− 2 at the surface, and from − 1.5 to − 3.9 Wm− 2 at the top of the atmo…

The Flux Density of Radiation Energy Originating from the Circumsolar Sky Measured at Groundbased Stations

1983

The aim of this project was the measurement of the radiant energy flux provided by the diffuse radiation of the ring shaped area of the sky around the unmasked sun disk. More than 200 measurements of the irradiance of this circumsolar cloudy or cloudfree sky up to an angular radius of 10° had been taken at Mainz (FRG), Deuselbach (FRG) and Adrano (Sicily). The measurements show that the irradiance of the circumsolar sky radiation may reach an amount of more then 30 % of the direct solar irradiance at the observation site. This means, optical systems combining the direct solar radiation and the circumsolar radiation may compensate — at least partly — the extinction losses of the direct solar…

Effective cloud optical depth and enhancement effects for broken liquid water clouds in Valencia (Spain)

2017

Partly cloudy skies with liquid water clouds have been analysed, founding that it is essential to distinguish data if the Sun is obstructed or not by clouds. Both cases can be separated considering simultaneously the Cloud Modification Factor (CMF) and the clearness index (kt). For partly cloudy skies and the Sun obstructed the effective cloud optical depth (τ) has been obtained by the minimization method for overcast skies. This method was previously developed by the authors but, in this case, taking into account partial cloud cover. This study has been conducted for the years 2011–2015 with the multiple scattering model SBDART and irradiance measurements for the UV Erythemal Radiation (UV…

2017

Abstract. Microphysical and radiation measurements were collected with the novel AIRcraft TOwed Sensor Shuttle (AIRTOSS) – Learjet tandem platform. The platform is a combination of an instrumented Learjet 35A research aircraft and an aerodynamic bird, which is detached from and retracted back to the aircraft during flight via a steel wire with a length of 4000 m. Both platforms are equipped with radiative, cloud microphysical, trace gas, and meteorological instruments. The purpose of the development of this tandem set-up is to study the inhomogeneity of cirrus as well as other stratiform clouds. Sophisticated numerical flow simulations were conducted in order to optimally integrate an axial…