Search results for "IRRADIATION"
showing 10 items of 1012 documents
Escherichia coli inactivation by neutral solar heterogeneous photo-Fenton (HPF) over hybrid iron/montmorillonite/alginate beads
2015
Abstract Hybrid alginate montmorillonite iron enriched beads (Fe-MABs) were synthesized using ion gelation method and used as catalyst in Escherichia coli inactivation in neutral solar photo-Fenton conditions. A kinetic analysis showed that the E. coli inactivation by Fe-MABs followed a pseudo first-order kinetics model. Complete disinfection was achieved in 1 h of irradiation by using Fe-MABs in the presence of 10 ppm of H 2 O 2 . Preliminary studies on recyclability showed possible beads reused up to four times. Overall, Fe-MABs represent an environmental friendly material able to achieve bactericidal performance measured by E. coli inactivation under photooxidative conditions.
Application of the ESR spectroscopy to estimate the original dose in irradiated chicken bone
2007
Abstract The paper discusses the results of an investigation aimed to use the ESR spectroscopy as a quantitative procedure to estimate the original dose in irradiated chicken. The time stability of the ESR signal was at first carried out, to obtain a correction factor to be applied to the dose estimated with the added dose method. Our results show that this procedure gives an estimation of the original dose within ±25%.
Gas chromatographic/mass spectrometric and microbiological analyses on irradiated chiken
2007
Ionizing radiation is widely used as treatment technique for food preservation. It involves among others reduction of microbial contamination, disinfestations, sprout inhibition and extension of shelf life of food. However, the commercialization of irradiated food requires the availability of reliable methods to identify irradiated foodstuffs. In this paper, we present results on the application to irradiated chicken of this method, based on the detection, in muscle and skin samples, of the peaks of ions 98 Da and 112 Da, in a ratio approximately 4:1, typical of radiation induced 2-dodecylcyclobutanones (2-DCB). Aim of the work was also to study the time stability of the measured parameters…
Time Evolution of two distant SQUID rings irradiated with entangled electromagnetic field
2006
Two distant mesoscopic SQUID rings are irradiated with two mode microwaves produced by the same source. The time evolution of the system is studied. The two microwave modes are correlated. It is shown that the currents tunnelling through the Josephson junctions in the distant rings, are also correlated.
Reversible switching of the Au(111) work function by near infrared irradiation with a bistable SAM based on a radical donor–acceptor dyad
2019
We describe the modification of the work function (WF) of Au(111) upon deposition of self-assembled monolayers (SAMs) with two donor–acceptor (D–A) systems, one based on a ferrocene-polychlorotriphenylmethyl radical (Fc–PTM) dyad and another on its non-radical dyad analogue. Kelvin Probe Force Microscopy (KPFM) has been used to measure the changes in the Contact Potential Difference (CPD) between the tip and the SAM under application of a cycling sweep of direct current (DC) voltage bias. These measurements showed that both SAMs exhibit a hysteretic behaviour in their WF changes. Interestingly, the hysteresis loop of the radical SAM is notably reduced when irradiated with NIR light, which w…
Entwicklung der Hornhautdicke während der UV-Vernetzungstherapie unter Anwendung verschiedener Kompositionen von Riboflavin-Augentropfen
2011
Background During the UVA-cross-linking treatment in keratoconus patients, the UVA rays are partially absorbed in the stroma of the riboflavin-loaded cornea. This effect protects the corneal endothelium from UVA irradiation damage. The intensity of UVA light reaching the endothelium is inversely correlated with corneal thickness. The common composition of riboflavin eye drops may lead to a marked reduction in corneal thickness increasing the risk of endothelial damage. Patients and methods In a retrospective analysis of 23 UVA-cross-linking procedures on 23 patients we collected data about the pre-, intra- and postoperative corneal thickness (measured with ultrasound). Among these patients …
Polymerization reactions and modifications of polymers by ionizing radiation
2020
International audience; Ionizing radiation has become the most effective way to modify natural and synthetic polymers through crosslinking, degradation, and graft polymerization. This review will include an in-depth analysis of radiation chemistry mechanisms and the kinetics of the radiation-induced C-centered free radical, anion, and cation polymerization, and grafting. It also presents sections on radiation modifications of synthetic and natural polymers. For decades, low linear energy transfer (LLET) ionizing radiation, such as gamma rays, X-rays, and up to 10 MeV electron beams, has been the primary tool to produce many products through polymerization reactions. Photons and electrons in…
Ionic liquids and microwave irradiation as synergistic combination for polar Diels–Alder reactions using properly substituted heterocycles as dienoph…
2012
For the DA reactions between nitropyrrole derivatives and isoprene, the combination of microwave irradiation and protic ionic liquid, has a notable synergistic effect. DFT calculations suggest that a supplementary energy ranking in the IR region of 1700-1400 cm-1 can favour the structural changes in the reactants to reach the TS. Fil: Mancini, Pedro Maximo Emilio. Universidad Nacional del Litoral. Facultad de Ingeniería Química. Departamento de Química; Argentina Fil: Ormachea, Carla. Universidad Nacional del Litoral. Facultad de Ingeniería Química. Departamento de Química; Argentina. Consejo Nacional de Investigaciones Científicas y Técnicas. Centro Científico Tecnológico Conicet - Santa F…
La1-xSrxCo1-yFeyO3-delta perovskites: Preparation, characterization and solar photocatalytic activity
2015
Abstract LaCoO3 perovskites substituted by Sr at the A site and/or by Fe at the B site have been prepared by the citrate method. Characterizations by several techniques, such as specific surface area (BET method), XRD, TPR, SEM, UV–vis in DRS mode, XPS and TGA analyses, have been performed. The so prepared La1−xSrxCo1−yFeyO3−δ perovskites are semiconductor materials showing band gap energy values from 1.9 to 3.2 eV. They displayed solar photocatalytic activity for the 2-propanol degradation in gas–solid regime. The photocatalytic results suggest that the perovskites containing Fe are less active and the activity decreases by increasing the Fe content, however the presence of iron avoids the…
Photocatalytic Degradation of 4-Nitrophenol in Aqueous Suspension by Using Polycrystalline TiO2 Impregnated with Lanthanide Double-Decker Phthalocyan…
2007
The photocatalytic activity of polycrystalline TiO2 samples impregnated with rare-earth-metal diphthalocyanines was investigated. The 4-nitrophenol (4-NP) photocatalytic degradation in aqueous suspension was used as a probe reaction. Commercial anatase TiO2 was impregnated with home-prepared double-decker phthalocyanine complexes of the lanthanide metals, such as Ce, Pr, Nd, Sm, Ho, and Gd. In particular, the impregnation with Ho, Sm, and Nd complexes, acting as sensitizers, proved beneficial for the photoactivity of the studied systems. Significant improvements of the TiO2-based catalytic system appeared possible in terms of lower impregnation loading, enhanced photoreactivity under solar …