Search results for "LIMIT"
showing 10 items of 2826 documents
Development and characterization of a thermal inkjet-based aerosol generator for micro-volume sample introduction in analytical atomic spectrometry
2011
A novel system for the introduction of liquid samples into analytical plasmas for atomic spectrometric analysis is presented in this manuscript for the first time. The proposed “drop-on-demand” (DOD) aerosol generator is based on the use of a modified thermal inkjet cartridge. This system employs a lab-built microcontroller, which allows accessing all parameters important for driving the dosing cartridge for the generation of pL-droplets from sample volumes in the μL range. The droplet generation frequency, thus the resulting liquid flow rate, is variable over a wide range from the generation of isolated droplets up to a theoretical flow rate of approximately 2 mL min−1, with parallel opera…
Study of passive sampling of polycyclic aromatic hydrocarbons in gas phase using Amberlite XAD resins as filling materials of semipermeable membranes
2013
Abstract In this work, a study was performed to evaluate the use of Amberlite XAD resins (XAD-2, XAD-4 and XAD-16), for the first time, as filling materials for low-density polyethylene membranes, which will be inserted as passive samplers for polycyclic aromatic hydrocarbons (PAHs) in gas phase. The use of samplers deployed for 48 h evidenced a relative capability to retain the compounds under study. A detailed study was performed to evaluate the recovery of analytes from the sampler through microwave-assisted extraction by using acetonitrile. A clean-up step using alumina-C18 cartridges was necessary before determination of the PAHs by high performance liquid chromatography with fluoresce…
Flow injection flame atomic absorption analysis of Fe and Mn in cement samples
1993
A new procedure has been developed for the determination of Fe and Mn in cements. It consists in dispersing 50 mg of the solid sample in 25 ml of 0.15 mol/l HNO3 and 0.12 mol/l HCl solution. Acid slurries are heated at 50°C for 10 min and then different volumes of the slurry are injected into a water carrier stream. This previous acid treatment leaches the elements to be determined and permits the use of acid solutions as standards. For the Mn determination, the use of a single line flow injection manifold provides a limit of detection of 0.03 mgl−1 and a dynamic range up to 6 mgl−1. For the determination of Fe, the on-line dispersion of samples, using a well stirred mixing chamber, increas…
Fast Separation and Determination of Sterols in Vegetable Oils by Ultraperformance Liquid Chromatography with Atmospheric Pressure Chemical Ionizatio…
2010
A method for the determination of sterols in vegetable oils by ultraperformance liquid chromatography (UPLC) with atmospheric pressure chemical ionization mass spectrometry detection has been developed. The separation of sterols was optimized in terms of mobile phase composition, column temperature and flow rate. The optimal conditions were achieved using an Acquity UPLC BEH C18 column (50 x 2.1 mm, 1.7 microm) with a mobile phase consistent of acetonitrile/water (0.01% acetic acid) using a linear gradient, at a flow rate of 0.8 mL min(-1) and column temperature of 10 degrees C, giving a total analysis time below 5 min. The determination was performed in selective ion recording mode. The li…
Optimization of a microwave-assisted extraction large-volume injection and gas chromatography–ion trap mass spectrometry procedure for the determinat…
2006
Abstract A sensitive and rapid method for the determination of polybrominated diphenyl ethers (PBDEs), polybrominated biphenyls (PBBs) and polychlorinated naphthalenes (PCNs) in sediment samples is proposed. The method involving microwave-assisted extraction (MAE) and large-volume injection (LVI) gas chromatography (GC)–ion trap mass spectrometry (ITMS), and the experimental conditions were optimized using the statistical design of experiments (DOE). A Plackett–Burman (P–B) design was chosen to estimate the influence of five factors, such as resonance excitation voltage (EV), isolation time (IT), excitation time (ET), ion source temperature (IST) and electron energy (EE) on the analytical r…
Comparison of gas and liquid chromatography coupled to mass spectrometry for the residue analysis of pesticides in organges
2001
Liquid chromatography-mass spectrometry (LC-MS) with atmospheric pressure chemical ionization (APCI), and gas chromatography-mass spectrometry (GC-MS) with electron impact ionization (EI), are compared for the determination of eight pesticides in oranges. Seven of the selected pesticides, chlorpyriphos, chlorpyriphos-methyl, imazalil, α and β-endosulfan, endosulfan sulphate and dicofol, are commonly determined by GC whereas one, thiabendazole, can only be directly determined by LC. Primary ions [M-H]− or [M-Cl+O]− are obtained using LC-APCI-MS in negative ionization (NI) mode. In contrast, a high degree of fragmentation is reported with GC-MS. Both techniques were applied to oranges, which …
Determination of fungicide residues in fruits and vegetables by liquid chromatography–atmospheric pressure chemical ionization mass spectrometry
2002
Abstract A liquid chromatography (LC) method for the quantitative determination of five fungicide residues (dichloran, flutriafol, o -phenylphenol, prochloraz and tolclofos methyl) in oranges, lemons, bananas, peppers, chards and onions is described. The residues were extracted by matrix solid-phase dispersion (MSPD) using C 8 . Quantitative analysis was performed by isocratic LC coupled to quadrupole mass spectrometer using atmospheric pressure chemical ionization in the negative ionization mode. The limit of quantification was 0.01 mg kg −1 for flutriafol, o -phenylphenol and dichloran, and 0.1 mg kg −1 for prochloraz and tolclofos methyl. The MSPD method is also suitable for LC–UV analys…
Multiple-stage mass spectrometric analysis of six pesticides in oranges by liquid chromatography–atmospheric pressure chemical ionization–ion trap ma…
2004
Abstract Six pesticides were determined by liquid chromatography (LC) with positive ion (PI) atmospheric pressure chemical ionization quadrupole ion-trap tandem mass spectrometry (APCI–MS–MS). Ion fragmentation was studied by MS, MS 2 and MS 3 . Fragmentation of the pesticides produced ions formed by various losses from the side-chains and through heterocyclic ring opening, but without any common fragmentation pathway. Multiple reaction monitoring (MRM) of MS, MS 2 and MS 3 was used to identify and quantify the pesticides. The samples were extracted with ethyl acetate and dried over anhydrous sodium sulfate. Comparison of the three MS modes showed that MS 3 is slightly less sensitive but mu…
Determination of carbamate residues in fruits and vegetables by matrix solid-phase dispersion and liquid chromatography-mass spectrometry.
2000
Abstract Thirteen carbamates were analysed in orange, grape, onion and tomatoes by matrix solid-phase dispersion (MSPD) followed by liquid chromatography–mass spectrometry (LC–MS). Electrospray (ES) and atmospheric pressure chemical ionisation (APCI) were compared and both gave similar results in terms of sensitivity and structural information because at 20 V fragmentor voltages the fragmentation is minimal. The efficiency of different solid-phases (C18, C8, cyano, amine and phenyl) for the MSPD was compared. Mean recoveries using C8 varied from 64 to 106% with relative standard deviations of 5–15% in the concentration range of 0.01–10 mg kg−1. Matrix constituents did not interfere signific…
Analysis of organophosphorus pesticides in honeybee by liquid chromatography-atmospheric pressure chemical ionization-mass spectrometry.
2001
Pesticides applied in extended agricultural fields may be controlled by means of bioindicators, such as honeybees, in which are the pesticides bioaccumulate. Liquid chromatography-atmospheric pressure chemical ionization-mass spectrometry (LC-APCI-MS) experiments with positive (PI) and negative (NI) ion modes were optimized for the analysis of 22 organophosphorus pesticides in honeybee samples. The extraction required 3 g of sample, which was extracted with acetone. The extract was purified with coagulating solution and reextracted with Cl(2)CH(2). Pesticides studied could be detected by both ionization modes except for parathion, parathion-methyl, and bromophos, which did not give signals …