Search results for "MATE"

showing 10 items of 46480 documents

Complex structural contribution of the morphotropic phase boundary in Na0.5Bi0.5TiO3 - CaTiO3 system

2019

Abstract The correlation between structure and dielectric properties of lead-free (1-x)Na0.5Bi0.5TiO3 - xCaTiO3 ((1-x)NBT - xCT) polycrystalline ceramics was investigated systematically by X-ray diffraction, combined with impedance spectroscopy for dielectric characterizations. The system shows high miscibility in the entire composition range. A morphotropic phase boundary (MPB), at 0.09 ≤ x

010302 applied physicsDiffractionPhase boundaryMaterials scienceProcess Chemistry and TechnologyThermodynamics02 engineering and technologyDielectric021001 nanoscience & nanotechnology01 natural sciencesMiscibilitySurfaces Coatings and FilmsElectronic Optical and Magnetic MaterialsDielectric spectroscopyvisual_art0103 physical sciencesMaterials ChemistryCeramics and Compositesvisual_art.visual_art_medium[CHIM]Chemical SciencesCrystalliteCeramic0210 nano-technology
researchProduct

Effect of Cu doping on Ba0.95Pb0.05TiO3 electrical properties studied by means of electrical impedance spectroscopy

2019

The ceramics of 0.95BaTiO3–0.05PbTiO3+Xwt.%CuO (X = 0.05, 0.1, 1, 3) were prepared by a solid phase reaction. The structural and morphology studies were carried out by means of X-ray diffraction te...

010302 applied physicsDiffractionPhase reactionMaterials scienceMorphology (linguistics)Analytical chemistry02 engineering and technology021001 nanoscience & nanotechnologyCondensed Matter Physics01 natural sciencesElectronic Optical and Magnetic MaterialsControl and Systems EngineeringCu dopingvisual_art0103 physical sciencesMaterials ChemistryCeramics and Compositesvisual_art.visual_art_mediumCeramicElectrical and Electronic Engineering0210 nano-technologyElectrical impedance spectroscopyIntegrated Ferroelectrics
researchProduct

Bandgap behavior and singularity of the domain-induced light scattering through the pressure-induced ferroelectric transition in relaxor ferroelectri…

2018

[EN] In this letter, we have investigated the electronic structure of A(x)Ba(1-x)Nb(2)O(6) relaxor ferroelectrics on the basis of optical absorption spectroscopy in unpoled single crystals with A = Sr and Ca under high pressure. The direct character of the fundamental transition could be established by fitting Urbach's rule to the photon energy dependence of the absorption edge yielding bandgaps of 3.44(1) eV and 3.57(1) eV for A = Sr and Ca, respectively. The light scattering by ferroelectric domains in the pre-edge spectral range has been studied as a function of composition and pressure. After confirming with x-ray diffraction the occurrence of the previously observed ferroelectric to pa…

010302 applied physicsDiffractionPhase transitionMaterials sciencePhysics and Astronomy (miscellaneous)Absorption spectroscopyCondensed matter physics02 engineering and technologyPhoton energy021001 nanoscience & nanotechnology01 natural sciencesFerroelectricityLight scatteringCRYSTALSTEMPERATURE-DEPENDENCEAbsorption edgeCALCIUM BARIUM NIOBATEFISICA APLICADA0103 physical sciencesDirect and indirect band gaps0210 nano-technologyCALCIUM BARIUM NIOBATE TEMPERATURE-DEPENDENCE CRYSTALS
researchProduct

Nonlinear optical response of bulk ZnO crystals with different content of intrinsic defects

2018

Abstract The nonlinear optical (NLO) properties of native defect-rich ZnO single crystals were studied in details within the excitation of the continuous wave (CW) and pulsed laser radiation at 532 nm (2.33 eV). Analysis of the experimental data of optical elastic scattering, Fourier transform infrared (FTIR), near infrared–visible–ultraviolet (NIR–Vis–UV) spectra recorded in reflection and absorption modes, and data of photoluminescence (PL) spectroscopy confirmed the contribution of both intrinsic defects and their clusters, being determined before by neutron diffraction and XRD analysis. It was shown that the high sensitivity of the NLO diagnostics via self-action of a laser beam is due …

010302 applied physicsElastic scatteringMaterials sciencePhotoluminescenceInfraredOrganic ChemistryNeutron diffraction02 engineering and technology021001 nanoscience & nanotechnology01 natural sciencesMolecular physicsAtomic and Molecular Physics and OpticsLight scatteringElectronic Optical and Magnetic MaterialsInorganic ChemistryWavelength0103 physical sciencesElectrical and Electronic EngineeringPhysical and Theoretical ChemistryFourier transform infrared spectroscopy0210 nano-technologySpectroscopySpectroscopyOptical Materials
researchProduct

Design and experimental validation of a magnetic device for stem cell culture.

2020

Cell culture of bone and tendon tissues requires mechanical stimulation of the cells in order to mimic their physiological state. In the present work, a device has been conceived and developed to generate a controlled magnetic field with a homogeneous gradient in the working space. The design requirement was to maximize the magnetic flux gradient, assuring a minimum magnetizing value in a 15 mm × 15 mm working area, which highly increases the normal operating range of this sort of devices. The objective is to use the machine for two types of biological tests: magnetic irradiation of biological samples and force generation on paramagnetic particles embedded in scaffolds for cell culture. The…

010302 applied physicsElectromagnetic fieldMaterials scienceStem CellsCell Culture TechniquesExperimental validationEquipment Designequipment and supplies01 natural sciencesMagnetic flux010305 fluids & plasmasMagnetic fieldMagnetic FieldsCell cultureDental pulp stem cells0103 physical sciencesMagnetic nanoparticlesIrradiationInstrumentationhuman activitiesBiomedical engineeringThe Review of scientific instruments
researchProduct

Modelling of expected B, C, N and O Lyman-α line intensities emitted from W7-X plasmas and measured by means of the W7-X light impurity monitor system

2021

AbstractThe “C/O Monitor” for Wendelstein 7-X (W7-X) is a dedicated light impurity XUV spectrometer intended to measure Lyman-α transitions of hydrogen-like ions of four low-Z impurities—boron (4.9 nm), carbon (3.4 nm), nitrogen (2.5 nm) and oxygen (1.9 nm). Since the discussed diagnostic will deliver continuous information about the line intensities, it is crucial to understand the origin of the obtained signals with respect to the experimental plasma conditions (electron temperature and density). This, however, might be difficult because of the broad acceptance angle of the spectrometer and irregular shape of the plasma edge or SOL where the radiation is expected to mostly come from, depe…

010302 applied physicsElectron densityMaterials scienceSpectrometerGeneral Physics and AstronomyPlasma01 natural sciences010305 fluids & plasmasIonRadiant fluxImpurityExtreme ultraviolet0103 physical sciencesElectron temperatureAtomic physics
researchProduct

Inhomogeneous electron distribution in InN nanowires: Influence on the optical properties

2012

In this work, we study theoretically and experimentally the influence of the surface electron accumulation on the optical properties of InN nanowires. For this purpose, the photoluminescence and photoluminescence excitation spectra have been measured for a set of self-assembled InN NWs grown under different conditions. The photoluminescence excitation experimental lineshapes have been reproduced by a self-consistent calculation of the absorption in a cylindrical InN nanowires. With the self-consistent model we can explore how the optical absorption depends on nanowires radius and doping concentration. Our model solves the Schrodinger equation for a cylindrical nanowire of infinite length, a…

010302 applied physicsElectron densityPhotoluminescenceMaterials scienceCondensed matter physicsNanowirePhysics::Optics02 engineering and technologyElectronCondensed Matter::Mesoscopic Systems and Quantum Hall Effect021001 nanoscience & nanotechnologyCondensed Matter Physics01 natural sciencesCondensed Matter::Materials ScienceAbsorption edge0103 physical sciencesPhotoluminescence excitation0210 nano-technologyAbsorption (electromagnetic radiation)Surface statesphysica status solidi c
researchProduct

Electron transport and the effect of current annealing in a two-point contacted hBN/graphene/hBN heterostructure device

2020

In this work, we fabricated a 2D van der Waals heterostructure device in an inert nitrogen atmosphere by means of a dry transfer technique in order to obtain a clean and largely impurity free stack of hexagonal boron nitride (hBN)-encapsulated few-layer graphene. The heterostructure was contacted from the top with gold leads on two sides, and the device’s properties including intrinsic charge carrier density, mobility, and contact resistance were studied as a function of temperature from 4 K to 270 K. We show that the contact resistance of the device mainly originates from the metal/graphene interface, which contributes a significant part to the total resistance. We demonstrate that current…

010302 applied physicsElectron mobilityMaterials scienceGraphenebusiness.industryAnnealing (metallurgy)Contact resistanceGeneral Physics and AstronomyHeterojunction02 engineering and technology021001 nanoscience & nanotechnology01 natural scienceslaw.inventionsymbols.namesakeImpuritylaw0103 physical sciencessymbolsOptoelectronicsDry transfervan der Waals force0210 nano-technologybusinessJournal of Applied Physics
researchProduct

Photo-electrical and transport properties of hydrothermal ZnO

2016

We performed the studies of optical, photoelectric, and transport properties of a hydrothermal bulk n-type ZnO crystal by using the contactless optical techniques: photoluminescence, light-induced transient grating, and differential reflectivity. Optical studies revealed bound exciton and defect-related transitions between the donor states (at ∼60 meV and ∼240 meV below the conduction band) and the deep acceptor states (at 0.52 eV above the valence band). The acceptor state was ascribed to VZn, and its thermal activation energy of 0.43 eV was determined. A low value of carrier diffusion coefficient (∼0.1 cm2/s) at low excitations and temperatures up to 800 K was attributed to impact the rec…

010302 applied physicsElectron mobilityPhotoluminescenceChemistryBand gapExcitonWide-bandgap semiconductorGeneral Physics and Astronomy02 engineering and technologyCarrier lifetime021001 nanoscience & nanotechnology01 natural sciencesAcceptorMolecular physicsCrystalCondensed Matter::Materials Science0103 physical sciencesAtomic physics0210 nano-technologyJournal of Applied Physics
researchProduct

An exact method for the determination of differential leakage factors in electrical machines with non-symmetrical windings

2016

An exact and simple method for the determination of differential leakage factors in polyphase ac electrical machines with non-symmetrical windings is presented in this paper. The method relies on the properties of Gorges polygons that are used to transform an infinite series expressing the differential leakage factor into a finite sum in order to significantly simplify the calculations. Some examples are shown and discussed in order to practically demonstrate the effectiveness of the proposed method.

010302 applied physicsElectronic Optical and Magnetic Material020208 electrical & electronic engineering02 engineering and technologySettore ING-IND/32 - Convertitori Macchine E Azionamenti ElettriciTopology01 natural sciencesElectronic mailElectronic Optical and Magnetic MaterialsDifferential leakage factorHarmonic analysiswindingDistribution functionmoment of inertiaElectromagnetic coil0103 physical sciences0202 electrical engineering electronic engineering information engineeringPolyphase systemGraphical modelnon-symmetrical windingElectrical and Electronic EngineeringGörges polygonLeakage (electronics)Mathematics
researchProduct