Search results for "MICROSCOPE"
showing 10 items of 1412 documents
Spectral Measurement of Photon Emission from Individual Gold Nanoparticles Using Scanning Tunneling Microscopy
2016
The light emission spectra of individual Au nanoparticles induced by a scanning tunneling microscope (STM) have been investigated. Two-dimensional ensembles of tunnel-coupled Au particles were prepared by thermal evaporation onto a native oxide silicon wafer in ultrahigh vacuum (10 – 9 mbar). Our STM measurements show a single peak at photon energy 1.6 eV in the tunneling mode and two peaks at 2.2 eV (connected with the Mie plasmon) and 1.45 eV (a new peak which was not discussed in literature before) in the field emission mode.
Photoemission microscopy with microspot-XPS by use of undulator radiation and a high-throughput multilayer monochromator at BESSY
1999
We present a new experiment for photoelectron microspectroscopy by use of undulator radiation, which has been set up at the beamline U2 at the Berlin electron storage ring BESSY 1. This approach employs a non-imaging simulated hemispherical electron energy analyser attached to an imaging photoemission electron microscope (FOCUS IS-PEEM) with integrated microarea selector. The photoemission microscope exhibits a lateral resolution of 25 nm (with 4.9 eV UV-excitation), while the resolution with incident synchrotron radiation in the soft X-ray range is about 100-120 nm (mainly due to chromatic aberrations). Photoemission microscopy as well as photoelectron microspectroscopy of selected areas o…
Effect of Mechanoactivation on Interfacial Interaction in Metal/Oxide Systems
2006
Properties of interfaces in solid state metal/oxide joints (Al/SiO2, Al/MgO, Al/glass, Mg/MgO, Mg/SiO2, In/glass etc.) are reported. The interfaces were formed by plastic deformation of metal on the oxide surface at room temperature. Their structure, chemical composition, and micromechanical properties were studied by the AFM, XRD, SIMS, optical microscopy, and precision microindentation techniques. A noticeable adhesion was observed for metals with high affinity for oxygen and only in the regions of the maximum shear stress. Formation of an interfacial reaction zone with an oxygen concentration gradient is detected. In this zone metals are nanostructured and noticeably hardened. The effect…
NanoESCA: imaging UPS and XPS with high energy resolution
2005
Abstract A novel imaging electron spectrometer has been used for laterally resolved ultraviolet photoelectron spectroscopy (UPS) and X-ray photoelectron spectroscopy (XPS) in the soft X-ray range. The instrument is based on a high-resolution emission microscope optics using a cathode lens and an imaging dispersive analyser. The analyser is corrected for the leading aberration term ( α 2 -term) by means of two hemispherical analysers in antisymmetric configuration with an appropriate transfer lens. Small-area spectra as well as energy-filtered images have been taken in the soft X-ray range for a meteorite sample and in the range of the d-band of a Cu polycrystal. An energy resolution of 106 …
Fast elemental mapping and magnetic imaging with high lateral resolution using a novel photoemission microscope
1998
Abstract Using tunable soft X-ray synchrotron radiation and a new-generation photoemission electron microscope with integral sample stage and microarea selector, elemental images and local XANES spectra have been measured. Given the present conditions (PM3 at BESSY), the lateral resolution was in the range of 130 nm with the potential of considerable improvement with high-brilliance sources (a base resolution of 25 nm was obtained in threshold photoemission). Measurements at the oxygen K-edge demonstrate that differences in the local chemical environment of the emitter atom are clearly revealed and can thus be used as a fingerprint technique for its chemical state and geometrical surroundin…
The luminescence of ZnO ceramics
2010
Abstract The luminescence properties of ZnO ceramics with grains 100–5000 nm sintered by different techniques from nanopowders were studied. The luminescence decay times were compared with that obtained for ZnO single crystal. The temperature dependence of non-exponential decay of defect luminescence (2.0–2.6 eV) was measured in wide time, intensity and temperature range. The luminescence decay kinetic at T ≤ 20 K shows the decay close to I(t) ∼ t−1 dependence. At temperature region 50–250 K the decay kinetics is more complicate since the TSL was observed in this temperature region. It is shown that the luminescence properties of NP and ceramics strongly depend on defect distribution on gra…
Ultrathin Organic Multilayer Films Via Salt Formation: Easy Access To Tailor-made Coatings In The Thickness Range Of 1 Nm To 500 Nm
2005
The state of the art technologies for the preparation of well defined ultrathin films in the submicron range are the Langmuir-Blodgett (LB) technique and self-assembly (SA) methods based on chemisorption [l]. Whereas the LBtechnique requires sophisticated apparatus and is generally limited to small film areas [2], the SA-methods are relatively simple [3,4], hut have not been employed for the preparation of films thicker than 8 layers ( 20nm) [4], probably due to the loss of chemical functionality. Our approach avoids these limits and extends the SA-concept by emploing salt formation as the driving force for the construction of multilayer supramolecular assemblies.
Number, Mass and Volume Distributions of Mineral Aerosol and Soils of the Sahara
1983
Abstract A direct method will be described to determine the complete mineral size distribution in aerosol (xylene-insoluble component) and soils (water-insoluble component) covering a size range from 0.01 up to 100 μm and 1000 μm radius, respectively, by using a combination of a scanning electron microscope, optical microscope and sieving. Aerosol and soil samples from the Sahara have been investigated. All mineral aerosol size distributions indicate a maximum between 0.06 and 0.08 μm radius and mineral particles have been found in the Aitken size range down to 0.02 μm radius. The concentration decrease toward larger particles is not uniform and shows considerable variations below 0.5 μm an…
Real-time manipulation of ZnO nanowires on a flat surface employed for tribological measurements: Experimental methods and modeling
2012
Elastic and tribological properties of zinc oxide nanowires (NWs) on Si wafer and highly oriented pyrolytic graphite (HOPG) are experimentally investigated and theoretically interpreted. Measurements are performed inside a scanning electron microscope (SEM) using real-time manipulation technique that enables two possible ways of data registration: “external” force registration with quartz tuning fork (QTF) based sensor and “internal” force registration utilizing in situ observed elastic deformation of NWs. Young modulus is determined by loading half-suspended NW at its free end and then employed for the following tribological experiments. Maximal static friction force is estimated when NW i…
Single Semiconductor Nanocrystals under Compressive Stress: Reversible Tuning of the Emission Energy
2017
The photoluminescence of individual CdSe/CdS/ZnS core/shell nanocrystals has been investigated under external forces. After mutual alignment of a correlative atomic force and confocal microscope, individual particles were colocalized and exposed to a series of force cycles by using the tip of the AFM cantilever as a nanoscale piston. Thus, force-dependent changes of photophysical properties could be tracked on a single particle level. Remarkably, individual nanocrystals either shifted to higher or to lower emission energies with no indications of multiple emission lines under applied force. The direction and magnitude of these reversible spectral shifts depend on the orientation of nanocrys…