Search results for "MINERALOGY"
showing 10 items of 1516 documents
COMPARING PARTICLE SIZE DISTRIBUTION ANALYSIS BY SEDIMENTATION AND LASER DIFFRACTION METHOD
2009
In this paper a brief review of the laser diffraction method is firstly carried out. Then, for 30 soil samples having a different texture classification sampled in Sicilian basin, a comparison between the two techniques is developed. The analysis demonstrated that the sand content measured by Sieve-Hydrometer method can be assumed equal to the one determinated by laser diffraction technique while an overestimation of the clay fraction measured by Sieve-Hydrometer method respect to laser diffraction technique was obtained. Finally a set of equations useful to refer LD measurements to SH method was proposed.
Comparison between grain-size analyses using laser diffraction and sedimentation methods
2010
A comparison between laser diffraction method (LDM) and the sieve-hydrometer method (SHM) was carried out for 228 soil samples representing a different texture classification sampled in a Sicilian basin. The analysis demonstrated that the sand content measured by SHM can be assumed equal to that determined by LDM technique, while the clay fraction measured by LDM was lower than that measured by the SHM. A set of equations to transform LDM results to SHM results was proposed. The influence of the LDM measurements of clay on the estimated percentage of silt + very fine sand particles (particle diameter ranging from 0.002 mm to 0.1 mm), which is useful for estimating soil erodibility, was also…
Structural characterization of TiNxOy/TiO2 single crystalline and nanometric multilayers grown by LP-MOCVD on (110)TiO2
2001
TiO2/TiNxOy superlattices were grown by Low Pressure-Metal-Organic Vapor Phase Epitaxy (LP-MOVPE) technique at deposition temperatures ranking from 650 to 750°C. The growth was performed on top of TiO2(110) rutile substrates. Intense peaks observed in the X-rays rocking curves and θ-2θ diffraction patterns show the presence of crystalline epilayers. The TiNxOy layers were grown in a (200) cubic structure on the (110) quadratic TiO2 epilayer structure. Transmission electron microscopy confirmed the XRD results and showed the formation of periodic and well structured epilayers.
An XRD, TEM and Raman study of experimentally annealed natural monazite
2002
The healing of radiation damage in natural monazite has been experimentally studied in annealing experiments using XRD, TEM, Raman microprobe and cathodoluminescence analysis. The starting material was a chemically homogeneous monazite from a Brazilian pegmatite with a concordant U–Pb age of 474 ± 1 Ma and a U–Th/He age of 479 Ma. The monazite shows nm-scale defects induced by radioactive decay. The Xray pattern of the unheated starting material revealed two distinct monazite ''phases'' A and B with slightly different lattice parameters. Monazite A shows sharp reflections of high amplitudes and slightly expanded lattice parameters (1% in volume) compared to a standard monazite. Phase B exhi…
An experimental methodology to study polymer crystallization under processing conditions. The influence of high cooling rates
2002
Abstract A new experimental route for investigating polymer crystallization under very high cooling rates (up to 2000°C/s) is described. A complete and exhaustive description of the apparatus employed for preparing thin quenched samples (100– 200 μm thick) is reported, the cooling mechanism and the temperature distribution across sample thickness is also analysed, showing that the final structure is determined only by the thermal history imposed by the fast quench apparatus. Details concerning the characterization techniques used to probe the final structure are reported, including density measurements and wide angle X-ray diffraction patterns. Experimental results concerning isotactic poly…
Pressure-induced phase transformations in mineral chalcocite, Cu2S, under hydrostatic conditions
2014
Abstract High-pressure room-temperature angle-dispersive powder X-ray diffraction measurements on Cu2S chalcocite were performed up to 30 GPa using a diamond-anvil cell, He as pressure transmitting medium and synchrotron radiation. Two first-order phase transitions were found at 3.2 and 7.4 GPa. The indexation of the powder diffraction patterns suggests three different monoclinic cells for the low-pressure chalcocite and the two high-pressure phases. Subtle changes in the X-ray diffraction patterns suggest a third pressure-induced transition above 26 GPa. Structural parameters and compressibility are discussed and compared to those reported in a previous study on Cu2S nanowires.
Synthesis and structural study of sodium titanium phosphate-sodium tin phosphate solid solutions. II. Thermal expansion
1993
Abstract The structure of NaTi 2 (PO 4 ) 3 shows the space group R3c, whereas that of NaSn 2 (PO 4 ) 3 presents the space group R3 at room temperature and it undergoes a second order phase transition at 575°C from this structure to another with the space group R3c. Evolution of the structure of NaTi 2 (PO 4 ) 3 NaSn 2 (PO 4 ) 3 solid solutions with temperature has been studied and temperature phase transition established for the compositions studied. Lattice thermal expansion of NaTi 2−x Sn x (PO 4 ) 3 solid solutions with x = 1, 1.2, 1.5 has been determined from x-ray diffraction data at temperatures ranging from 26 to 1000°C. DSC and dilatometric measurements have been also carried out o…
On the existence of a pyrochlore-type phase in the system Bi2O3–TiO2
1995
The existence of a bismuth titanate in the range between Bi 2 Ti 4 O 11 (Bi 2 O 3 . 4 TiO 2 ) and Bi 4 Ti 3 O 12 (2 Bi 2 O 3 . 3 TiO 2 ) has been investigated by X-ray diffraction of samples prepared by solid state reactions. For reaction temperatures above 1100 °C and a starting composition Bi 2 O 3 . 2 TiO 2 there appeared additional lines which could be attributed to a cubic face-centred cell with a = 10.354 A. A multiphase Rietveld analysis based on X-ray powder diffraction data confirmed the structural model of a pyrochlore for this compound. There is evidence that this phase belongs to the group of defect pyrochlores with a Bi 3+ -deficiency resulting in a composition of Bi 1.833 Ti 2…
X-ray diffraction line broadening on vibrating dry-milled Two Crows sepiolite
2006
A reference sample of sepiolite and products of its comminution by vibrating dry-milling have been studied using X-ray diffraction (XRD) line-broadening analysis, complementary field emission scanning electron microscopy (FESEM) images and surface area measurements. The apparent crystallite sizes determined via XRD are in agreement with observations on FESEM images. The sepiolite aggregates consist of lath-shaped agglutinations of prisms and pinacoids elongated along [001], each lath including several crystallites in that direction. The surface area magnitudes are in the range of previous experimental measurements of other sepiolites. The results obtained show the effectiveness of vibro-mil…
Elastic Properties of Barium Zirconate Titanate Ceramics
2011
In the paper the influence of zirconium admixture on the structure and material constants of polycrystalline ferroelectric materials BaZrxTi1-xO3 (BZT) was examined. The barium zirconate titanate samples were prepared by a conventional solid state reaction method. A single phase with perovskite structure of the samples, was identified by an X-Ray diffraction technique at room temperature. The performed EDS study revealed that the samples were perfectly sintered and the material was chemically homogeneous. The dependence of shear modulus G on sample composition is similar to the respective dependence of Young's modulus E, whereas the Poisson's ratio ν decreases with the increase in zirconium…