Search results for "MINERALOGY"

Intrinsic defect related luminescence in ZrO2

2011

The studies of ZrO 2 and yttrium stabilized ZrO 2 nanocrystals luminescence as well as yttrium stabilized single crystal luminescence and induced absorption showed that the intrinsic defects are responsible for luminescence at room temperature. These defects form a quasi-continuum of states in ZrO 2 band gap and are the origin of the luminescence spectrum dependence on the excitation energy. Luminescence centers are oxygen vacancies related but not the vacancies themselves. At room temperature, in ZrO 2 , deep traps for electrons and holes exist. The oxygen vacancies are proposed to be the traps for electrons.

Influence of Ag, Cu dopants on the second and third harmonic response of ZnO films

2009

International audience; Silver- and copper-doped ZnO films were prepared by radio-frequency (RF)-magnetron sputtering on glass and quartz substrates. The influence of dopants content on the microstructural evolution and optical as well as nonlinear optical (NLO) properties were investigated. It has been found that the grain sizes were enlarged with increasing of Ag, Cu dopants amount in ZnO films. The Ag or Cu doping leads to the optical band gap narrowing. Besides, the second-order NLO response of Ag- and Cu-doped ZnO films is lower than that of undoped ZnO film. The second harmonic generation (SHG) efficiency of the ZnO:Ag film was found to be higher than that of the ZnO:Cu film at the si…

A multi-technique characterisation of cronstedtite synthetized by iron-clay interaction in a step by step cooling procedure

2013

International audience; The cooling of steel containers in radioactive-waste storage was simulated in a step-by-step experiment from 90 to 40 degrees C. Among newly formed clay minerals observed in run products, cronstedtite was identified by a number of analytical techniques (powder X-ray diffraction, transmission electron microscopy, and scanning electron microscopy). Cronstedtite has not previously been recognized to be so abundant and so well crystallized in an iron-clay interaction experiment. The supersaturation of experimental solutions with respect to cronstedtite was due to the availability of Fe and Si in solution, as a result of the dissolution of iron metal powder, quartz, and m…

Friction Factor for Gravel-Bed Channel with High Boulder Concentration

2000

This paper reports the results of an experimental investigation on flow resistance law for a gravel-bed channel having bed arrangements characterized by different values of the number of boulders. The dependence is studied of a parameter, proposed for describing the gravel-bed surfaces, on the boulder concentration and on the ratio between the median diameter of the coarser particles and the median diameter of the bed layer. Flume measurements carried out for the hydraulic condition of \Itransition\N and \Ilarge-scale\N roughness (1.5 ≤ \ih/\id\d5\d0 ≤ 6.9) show that the intercept of the semilogarithmic flow resistance law depends on the ratio and on boulder concentration. For concentration…

Cathodoluminescence and structural studies of nitrided 3D gallium structures grown by MOCVD

2009

Abstract Cathodoluminescence (CL) spectrum imaging and grazing incidence X-ray diffraction (GIXRD) are employed to investigate nitride three-dimensional (3D) gallium structures. The metallic precursors are naturally obtained on a large variety of substrates by metal-organic chemical vapor deposition (CVD) with different shape/size controlled by the growth conditions, especially the temperature. These 3D metallic structures are subsequently exposed to a nitridation process in a conventional CVD reactor to form GaN nanocrystals, as confirmed by GIXRD measurements. CL spectroscopy shows visible light emission (2.5–2.8 eV) excited from the GaN in the 3D structures.

Elastic wave propagation in bone in vivo: methodology.

1995

The purpose of this study was to investigate the usefulness of elastic wave propagation (EWP) in estimating the mechanical properties (elasticity) of human tibia. The test group was composed of 78-yr-old women assigned to high (n = 19) and low (n = 17) bone mineral density (BMD) groups as measured at the calcaneus by the 125I-photon absorption method. The EWP apparatus consisted of an impact-producing hammer with a force strain gauge and two accelerometers positioned on the bone. Results for nylon and acrylic were used to calibrate the apparatus. Polyvinyl chloride (PVC) solid rods and tubes of various diameters were used to evaluate the relationship between the elastic wave velocity and cr…

Anodic growth of passive layers on steel rebars in an alkaline medium simulating the concrete pores

2006

Electrochemical impedance spectroscopy (EIS) and cyclic voltammetry (CV) techniques have been used to study passive layers anodically grown on steel rebars in an aqueous alkaline solution simulating the electrolyte of the concrete pores. Nyquist diagrams recorded by EIS at the different stabilization potentials show a diffusional tail at low frequencies. The analysis of the impedance measurements has been made by means of an equivalent circuit with a Warburg component and within the framework of the point defect model (PDM) theory. It is observed that the calculated concentration of vacancies is a function of the potential in accordance with the theoretical prediction of the PDM.

Ultrasonic tomographic analysis for getting information on the mechanical structure of ceramic tiles

2009

Application of the slurry technique to biological materials: a survey of literature

1991

The literature on the application of the slurry technique to biological materials is reviewed. It is obvious from the various applications that the most frequently employed atomization method for slurry analysis in biological materials is electrothermal atomization using either graphite tube or platform atomizers. The slurry technique is particularly useful when certified reference materials are not available and when the standard addition method is to be avoided. The literature survey revealed that this technique compares favourably with other methods for the determination of trace metals in biological materials.

Influence of mechanical activation on the physical stability of salbutamol sulphate.

2003

Abstract In order to obtain the optimal particle size distribution for pharmaceutical powders in dry powder inhalers the particles have to be micronised. In most cases the process of micronisation is connected with a high input of energy which induces disorder and defects on the surface of the drug particles and as a result changes in the crystallinity. Consequently, changes in the physical stability of the powders may occur. To investigate changes on the physical stability of the powder, different analytical methods are used in the present investigation: laser diffraction, Differential Scanning Calorimetry (DSC), isothermal microcalorimetry and DVS-method. Air-jet-milling is one of the mos…