Search results for "Metallurgy"

Synthesis of bi- and tricyclic β-lactam libraries in aqueous medium

2007

Water as a solvent is not only inexpensive and environmentally benign, but may allow good reactivity. The present work focuses on the application of a modified Ugi reaction, i.e. the Ugi four-centre three-component reaction (U-4C-3CR), in aqueous medium to construct β-lactam libraries. All the attempted reactions could be successfully performed in water. The reaction conditions under which the precipitation process was effective were investigated; no further work-up or purification was necessary. In several cases when less water-soluble β-amino acids were used, the precipitated products were isolated easily by simple filtration. In other cases, evaporation of the solvent was appropriate for…

Immobilization of vegetable tannins on tannery chrome shavings and their use for the removal of hexavalent chromium from contaminated water

2011

Abstract Chestnut (C) and mimosa (M) tannins immobilized on chrome shavings (CS) as an adsorbent have been proposed to be an efficient and economical alternative in hexavalent chromium removal from aqueous solutions. The adsorption of hexavalent chromium onto chrome shavings-tannin (CS-T) adsorbents was performed using batch equilibrium technique at 25 ± 2 °C. The effect of pH is highly important especially in the case of high concentrations of hexavalent chromium. The maximum chromium uptake was obtained at pH 4. Two hours of contact time are enough to reach equilibrium. Sorption of chromium on CS-T was found to follow a pseudo-second order kinetic model (with correlation coefficients grea…

Positrons and electron-irradiation induced defects in the layered semiconductor InSe

1992

The positron annihilation characteristics of the layered semiconductor InSe have been investigated. No evidence for low temperature positron trapping is found in as-grown and heavily deformed InSe. The temperature dependence of the S-parameter in these sample exhibits an increase rate in good agreement with the linear expansion coefficient along the c-axis. The positron lifetime spectra of electron-irradiated 0.01% Sn-doped InSe show a long-lifetime component of 336 ps which is tentatively attributed to positrons trapped at isolated In vacancies. Isochronal annealing experiments performed on these samples show that the recovery of the positron lifetime measured at 77K is accomplished in two…

Transport of amino acids through liquid membranes supported on novel poly(vinylidenefluoride) porous flat-sheet matrix

1997

Flat-sheet membranes from poly(vinylidenefluoride) (PVDF) were prepared by the phase inversion process. LiCl was used as a modifying agent. The porosity, maximum pore size and LEPW (liquid entry pressure of water) were determined. Three types of these membranes were tested as a support for n-decanol supported liquid membranes (SLM). Transport of eight amino acids, selected to cover a wide variety of side chains, and of phenylalanine methyl ester through n-decanol SLM were studied. The ability of amino acids to permeates through these membranes depends on the type of flat-sheet PVDF used as a support. An increase in porosity and pore size of the microporous matrix resulted in an increase of …

Synthesis and characterisation of polymeric manganese and zinc 5-hydroxyisophthalates

2001

Abstract The crystallisation of 5-hydroxyisophthalic acid with divalent Mn or with Mn or Zn and either 2,2-bipyridine (2,2-bipy) or pyridine-2-(1H-pyrazol-3-yl) gave solids of composition [Mn(C8H4O5)(H2O)3]·2H2O (1), [Mn(C8H4O5)(2,2′-bipy)]·H2O (2), [Mn2(C8H4O5)2(C8H7N3)2]·H2O (3) and [Zn(C8H4O5)(2,2′-bipy)] (4). Each compound has 1D co-ordinative chains that are connected by hydrogen bonds. Compounds 2–4 contain M2C2O4 rings with pseudo-chair geometries. The Mn atoms in 2 are coupled antiferromagnetically.

Voltammetric Identification of Lead(II) and (IV) in Mediaeval Glazes in Abrasion-Modified Carbon Paste and Polymer Film Electrodes. Application to th…

2000

Direct identification of lead(II) and (IV) in glazed ceramics by cyclic voltammetry and differential pulse voltammetry is described. Characteristic cathodic and anodic profiles are obtained for microsample coatings in Paraloid B72-film electrodes immersed in NaCl and HAc/NaAc media. The electrochemical response of PbO, PbO2 and Pb3O4, and a series of test specimens of glaze is compared with that of microsamples extracted from the glaze of blue and white decorated ceramic produced in Manises (Spain) in the 15th century which have been buried in a damp place. Under abrasive conditions, striping peaks at –0.12 and –0.25 V (vs. SCE) appear for Pb(IV) centers and, at –0.55 and –0.75 V, for Pb(II…

Open Cell Al-Si Foams by a Sintering and Dissolution Process

2014

Open cell foams from AlSi12 alloy were successfully fabricated by the Sintering and Dissolution Process, using NaCl as space holder (60 %). The size of the aluminum alloy powder is less than 45 μm, while the space holder powder size is 315-500 μm, 630-800 μm and 800-1250 μm respectively. The appropriate quantities of alloy powder and salt were mixed and cold pressed at 250 MPa. The sintering process was done at 500 °C and 545 °C, in vacuum (10-5 torr) for 10, 20 and 30 minutes respectively. The space holder was eliminated by holding the sintered samples in running hot water (70 °C). After the salt was dissolved, the samples were dried and the mass loss was analyzed. Keywords: Aluminum foam…

Homocoupling of terminal alkynes on calcite (10.4)

2018

Abstract On-surface synthesis has been identified as highly versatile strategy to prepare molecular structures on surfaces with single-atom precision. Inspired by the classical Glaser coupling, homocoupling of terminal alkynes has attracted great attention for on-surface synthesis. This coupling is known for providing a rigid and linear linkage, which is highly interesting for the synthesis of molecular wires. For molecular wire formation, non-conductive substrates are needed for electronic decoupling. So far, however, coupling of terminal alkynes has not been performed on a bulk insulator surface. Here, we present an atomic force microscopy study, indicating that 4,4″-diethynyl-[1,1′:4′,1″…

The folding of individual conjugated polymer chains during annealing.

2011

Determination of degree of crystallinity of drawn polymers by means of density measurements

1969

The well known procedure of determining the degree of crystallinity by means of measuring the density presupposes the knowledge of both the densities ρc and ρa of the crystalline and of the noncrystalline regions. By combination of small-angle and wide-angle x-ray scattering and of density measurements it can be shown that this method is not justified in the case of drawn polyethylene if the values of ρc and ρa known from isotropic material are used. Both ρc and ρa depend considerably on annealing and drawing conditions. In addition the effective density ρc* of the more densely packed phase in a two-phase structure is much lower than the value ρc calculated from the positions of the x-ray r…