Search results for "Minimization"

Experimental study on efficiency enhancement in Interior Permanent Magnet Synchronous machines

2015

This paper presents an experimental study on the efficiency variation occurring in an IPMSM (Interior Permanent Magnet Synchronous Motor) with respect to the direct axis current component and for several working conditions. Such investigation is the starting point for the arrangement of a speed control drive system equipped with a real-time power losses minimization algorithm. More in detail, a test bench is set up to carry out the measurements needed for the final power loss identification. The experimental investigation is developed by performing tests at different speed, magnetization and load conditions. From the obtained results, it can be stated that the IPMSM efficiency can be maximi…

Optimum Performance of Permanent Magnet Synchronous Generators Coupled to Wind Turbines

2007

In this paper a control algorithm for the efficiency improvement of permanent magnet synchronous generators (PMSG) is presented. The proposed algorithm reduces the losses of the generator without affecting its performances. In details, after a description of a dynamic model of the PMSG, which has been purposely modified in order to take into account the iron losses, the basic equations and the constraints to obtain the loss minimization are presented and discussed. Some simulations of a specific PMSG employing the proposed algorithm are performed. The results of these simulations show that enhancement of the efficiency up to 3% can be reached in comparison to a PMSG using a traditional cont…

Efficiency Maximization of Permanent Magnet Synchronous Generators Coupled to Wind Turbines

2007

In this paper a control algorithm for the efficiency improvement of permanent magnet synchronous generators (PMSG), the relative simulations and their results are presented. The proposed algorithm reduces the losses of the generator without affecting its performances. In details, after a description of a dynamic model of the PMSG, which has been modified in order to take into account the iron losses, the basic methodologies to obtain the loss minimization are presented and discussed. Many simulations of a specific PMSG employing the proposed algorithm were carried out and are presented. The results of these simulations show that enhancement of the efficiency up to 3% and more can be reached…

Simultaneous zonation and calibration of pipe network parameters

2003

A procedure for simultaneously zoning and calibrating pipe network parameters is proposed and applied to the determination of pipe resistance coefficients. The methodology is aimed at grouping the parameters of all the pipes into a small number of zone parameters, constrained to keep the difference between the computed and the measured water heads below a given tolerance. It is shown that, in the case of nonlooped networks, the methodology leads to a linear minimization problem where the objective function is a measure of the heterogeneity of the estimated parameters. In the case of looped networks an iterative procedure, where the linear problem is coupled with a nonlinear problem having a…

Insights on mechanisms of excess sludge minimization in an oxic-settling-anaerobic process under different operating conditions and plant configurati…

2022

In the present research, insights about the mechanisms of excess sludge minimization occurring in an oxic-settling-anaerobic (OSA) were provided. The investigation involved two systems operating in parallel. In particular, a conventional activated sludge (CAS) system as control and a system implementing the OSA process both having a pre-denitrification scheme were considered. Five periods (P1-P5) were studied, during which several operating conditions and configurations were tested. Specifically, the hydraulic retention time (HRT) in the anaerobic reactor of the OSA system (P1 8 h, P2-P3 12 h, P4 8 h, P5 12 h) and the return sludge from the anaerobic to the anoxic (scheme A) (P1-P2) or aero…

Comparison between ozonation and the OSA process: analysis of excess sludge reduction and biomass activity in two different pilot plants

2012

The excess biomass produced during biological treatment of municipal wastewater represents a major issue worldwide, as its disposal implies environmental, economic and social impacts. Therefore, there has been a growing interest in developing technologies to reduce sludge production. The main proposed strategies can be categorized according to the place inside the wastewater treatment plant (WWTP) where the reduction takes place. In particular, sludge minimization can be achieved in the wastewater line as well as in the sludge line. This paper presents the results of two pilot scale systems, to evaluate their feasibility for sludge reduction and to understand their effect on biomass activit…

Advanced energetics of a Multiple-Effects-Evaporation (MEE) desalination plant. Part II: Potential of the cost formation process and prospects for en…

2010

This paper represents the 2nd part of a paper in two parts. In part I a 2nd Principle analysis of a Multiple- Effects-Evaporation (MEE) process has been proposed. In this Part II perspectives for process improvement will be investigated, along two distinct research lines: the thermoeconomics-aided optimization of a new system and the increase of thermal efficiency for existing systems by a pinch-based plant retrofit. As concerns the first research line, a detailed productive structure for the plant stage (i.e. effect) examined in Part I is presented; the cost formation structure is then used to improve a simplified optimization process, revealing capable to properly reflect the interactions…

A worrisome failure of the CC2 coupled-cluster method when applied to ozone

2010

Abstract The approximate coupled-cluster singles and doubles model CC2 is widely used for calculations of excited states in large molecules. We demonstrate a surprising failure of the CC2 geometry optimization of ozone, whereby the CC2 method predicts a barrierless, exothermic, and symmetric dissociation to three oxygen atoms. This is particularly astonishing since both second-order Moller–Plesset perturbation theory and coupled-cluster singles and doubles give reasonable equilibrium structures. We find that [ [ H , T 1 ] , T 1 ] leads to an unbalanced treatment of T 1 and T 2 in the CC2 equations. Results presented here suggest that considerable caution should be exercised when applying th…

Complexity of probabilistic versus deterministic automata

2005

Efficiency Control for Permanent Magnet Synchronous Generators

2006

In this paper a control algorithm for the efficiency improvement of permanent magnet synchronous generators (PMSG) is presented. The proposed algorithm reduces the losses of the generator without affecting its performances. In details, after a description of a dynamic model of the PMSG, which has been purposely modified in order to take into account the iron losses, the basic equations and the constraints to obtain the loss minimization are presented and discussed. Some simulations of a specific PMSG employing the proposed algorithm are performed. The results of these simulations show that enhancement of the efficiency up to 3 % can be reached in comparison to a PMSG using a traditional con…