Search results for "Modulus"
showing 10 items of 491 documents
Ultrasonication as a Method of Investigation of the Mechanical Properties of Doped Hafnium Barium Titanate
2012
The purpose of this study was to fabricate dense ceramic specimens from the system of BaTiO3-BaHfO3 and then to perform mechanical tests. The effect of Hf content on a microstructure and mechanical properties of the BaTiO3-BaHfO3 solid solution was investigated at room temperature. To determine the elastic constants (the Young′s modulus E, the shear modulus G, bulk modulus K and the Poisson′s ratio v) of BaHfxTi1-xO3 a method of measurement of the longitudinal (VL ) and transverse (VT ) ultrasonic wave velocities for this type of material was developed.
Empirical molecular dynamics study of structural, elastic and thermodynamic properties of zinc-blende-like SiGe compound
2004
Abstract A three-body potential coupled with a molecular-dynamics method is used to calculate structural and thermodynamic properties of the hypothetical IV–IV compound SiGe in zinc-blende phase. A good agreement between the calculated and theoretical values of the lattice constant, the bulk modulus and its derivative, and the cohesive energy is obtained. We also compute the elastic constants, Debye temperature, lattice thermal expansion, and the specific heat. We investigate also, the structural properties of SiGe when rock-salt phase appears.
Lattice dynamics of wurtzite and rocksalt AlN under high pressure: Effect of compression on the crystal anisotropy of wurtzite-type semiconductors
2008
Raman spectra of aluminum nitride (AlN) under pressure have been measured up to $25\phantom{\rule{0.3em}{0ex}}\mathrm{GPa}$, i.e., beyond the onset of the wurtzite-to-rocksalt phase transition around $20\phantom{\rule{0.3em}{0ex}}\mathrm{GPa}$. The experimental pressure coefficients for all the Raman-active modes of the wurtzite phase are reported and compared to those obtained from ab initio lattice dynamical calculations, as well as to previous experimental and theoretical results. The pressure coefficients of all the Raman-active modes in wurtzite-type semiconductors (AlN, GaN, InN, ZnO, and BeO), as well as the relatively low bulk modulus and phase transition pressure in wurtzite AlN, a…
Effect of two novel bio-based rejuvenators on the performance of 50% RAP mixes - a statistical study on the complex modulus of asphalt binders and as…
2019
An experimental study was conducted to evaluate the effectiveness of two bio-additives as rejuvenators on the properties of asphalt mixtures containing 50% RAP and their binder constituents containing 37% RAP binder. Before mixing, the rejuvenators were blended with fresh bitumen and the extracted and recovered RAP bitumen, and changes in the rheological properties of the binders were assessed using performance grading (PG) criteria. The results showed that both rejuvenators could improve the low-temperature performance of the aged RAP binder and restore its low-temperature properties. Master curves for the unaged, RTFO-aged, and PAV aged blends were constructed using both the Christensen-A…
Full-scale validation of bio-recycled asphalt mixtures for road pavements
2019
Abstract Recycling of asphalt has become a well-established practice in many countries, however the road pavement industry remains a bulk consumer of extracted raw materials. Novel solutions that find root in circular economy concepts and life-cycle approaches are needed in order to enable optimisation of infrastructure resource efficiency, starting from the design stage and spanning the whole value chain in the construction sector. Itis within this framework that the present study presents a full-scale validation of asphalt mixtures specifically designed to ensure durability of flexible road pavements and at the same time enabling the reuse of reclaimed asphalt pavement (RAP) through the i…
Hyaluronic Acid–Silica Nanohybrid Gels
2013
Excessive water sorption and low mechanical properties are a severe drawback in some biomedical applications of hyaluronic acid (HA). A way to improve these properties is here explored through the novel concept of nanohybrid hydrogels consisting of a HA matrix including different amounts of silica-derived species. This inorganic filler phase controls the mechanical and swelling properties of HA cross-linked matrices. Below a 2 wt % of silica in the systems, nanoparticle aggregates of tens of nanometers and silica oligomers are distributed more or less homogeneously throughout the organic matrix, without percolating. This morphology of the silica phase is accompanied by an increased swelling…
Structural Behavior of Natural Silicate–Carbonate Spurrite Mineral, Ca5(SiO4)2(CO3), under High-Pressure, High-Temperature Conditions
2017
We report on high-pressure and high-temperature angle-dispersive synchrotron X-ray diffraction and high-pressure Raman data up to 27 GPa and 700 K for natural silicate carbonate Ca5(SiO4)2(CO3) spurrite mineral. No phase transition was found in the studied P–T range. The room-temperature bulk modulus of spurrite using Ne as the pressure-transmitting medium is B0 = 77(1) GPa with a first-pressure derivative of B0′ = 5.9(2). The structure compression is highly anisotropic, the b axis being approximately 30% more compressible than the a and c axes. The volumetric thermal expansivity value around 8 GPa was estimated to be 4.1(3) × 10–5 K–1. A comparison with intimately related minerals CaCO3 ca…
Amorphous polyphosphate/amorphous calcium carbonate implant material with enhanced bone healing efficacy in a critical-size defect in rats
2016
In this study the effect of amorphous calcium carbonate (ACC) microparticles and amorphous calcium polyphosphate (polyP) microparticles (termed aCa-polyP-MP) on bone mineral forming cells/tissue was investigated in vitro and in vivo. The ACC particles (termed ACC-P10-MP) were prepared in the presence of Na-polyP. Only the combinations of polyP and ACC microparticles enhanced the proliferation rate of human mesenchymal stem cells (MSCs). Gene expression studies revealed that ACC causes an upregulation of the expression of the cell membrane-associated carbonic anhydrase IX (CA IX; formation of ACC), while the transcript level of the alkaline phosphatase (ALP; liberation of orthophosphate from…
In vitro evaluation of biomimetic chitosan-calcium phosphate scaffolds with potential application in bone tissue engineering.
2013
This work reports on the physicochemical properties and in vitro cytotoxicity assessment of chitosan–calcium phosphate (Cs–CP) scaffolds for bone tissue engineering, which were synthesized by a novel biomimetic co-precipitation method. X-ray diffraction (XRD) along with scanning electron microscopy (SEM) analysis confirmed the porous morphology of the scaffolds and the amorphous nature of the inorganic phase with different crystallite sizes and the formation of various forms of calcium phosphate. Compressive mechanical testing revealed that the Young’s modulus of the biomaterials is in the range of human trabecular bone. In vitro tests were performed on the biomaterials for up to 14 days to…
Effects of temperature and pressure on microcantilever resonance response.
2003
Abstract The variation in resonance response of microcantilevers was investigated as a function of pressure (10 −2 –10 6 Pa) and temperature (290–390 K) in atmospheres of helium (He) and dry nitrogen (N 2 ). Our results for a silicon cantilever under vacuum show that the frequency varies in direct proportion to the temperature. The linear response is explained by the decrease in Young's modulus with increasing the temperature. However, when the cantilever is bimaterial, the response is nonlinear due to differential thermal expansion. Resonance response as a function of pressure shows three different regions, which correspond to molecular flow regime, transition regime, and viscous regime. …