Search results for "Molality"
showing 10 items of 24 documents
Volumes and heat capacities of anionic-nonionic surfactant mixtures
1995
Density, heat capacity and surface tension measurements of sodium decylsulfate (NaDeS)-dodecyldimethylamine oxide (DDAO)-water mixtures were carried out as functions of the surfactants total molality mt at fixed stoichiometric mixture compositions XNaDeS. From the surface tension data, the critical micelle concentration of NaDeS-DDAO mixtures as a function of XNaDeS were obtained. From density and heat capacity data, the apparent molar volume VΦ,2 and heat capacity CΦ,2 of NaDeS-DDAO mixtures in water were calculated, respectively. At a given mole fraction, VΦ,2 and CΦ,2 monotonically increases and decreases, respectively, with increasing mt. However, anomalies were observed at XNaDeS=0.1 a…
Experimental study on the solubility of the “model”-pelite mineral assemblage albite + K-feldspar + andalusite + quartz in supercritical chloride-ric…
2001
A total of 34 solubility experiments using the “model”-pelite mineral assemblage microcline + low albite + andalusite + quartz were performed at 600°C and 0.2 GPa over a total chloride range of 0.03–2.9 molal. The concentrations of sodium, potassium, aluminum, and silica were measured and the results are compared with four different thermodynamic datasets. The K/Na ratio was approached from below and above for the thermodynamically buffered mineral assemblage microcline + low albite + andalusite + quartz. Tight brackets were obtained for experiments performed in up to 1 molal chloride concentration. From 0.03 to ∼1 molal chloride concentration, a constant K/Na ratio of 0.33 was obtained. At…
Heat capacities, volumes and solubilities of pentanol in aqueous surfactant solutions
1989
Apparent molar heat capacities and volumes of pentanol (PentOH) 0.05m in dodecyltrimethylammonium chloride (DTAC), dodecyldimethylammonium chloride (DDAC) and dodecylamine hydrochloride (DAC) micellar solutions were measured at 25°C. They were assumed to approach the standard infinite dilution values and rationalized by means of previously reported equations. The distribution constant between the aqueous and the micellar phase and heat capacity and volume of pentanol in both phases were thus derived. The results show that the presence of methyl groups on the surfactant head group does not appreciably influence the apparent molar volume and heat capacity of pentanol in micellar phase and the…
Demixing of Mixed Micelles. Thermodynamics of Sodium Perfluorooctanoate−Sodium Dodecanoate Mixtures in Water
1997
Conductivity, density, heat capacity, enthalpy of dilution, and osmotic coefficient measurements of water−sodium perfluorooctanoate (NaPFO)−sodium dodecanoate systems were carried out as functions of the surfactants' total molality (mt) at different mole fractions (XNaPFO). From conductivity data, the critical micelle concentration (cmc) and the degree of ionization (β) of the micelles were derived. The cmc's of the micelles are higher than those of the pure surfactants while β depends linearly on XNaPFO. At a given mole fraction, the apparent molar volume (VΦ) and heat capacity (CΦ) of the mixture increases and decreases monotonically with mt, respectively. From data in the premicellar reg…
Thermodynamic Studies of Sodium Dodecyl Sulfate–Sodium Dodecanoate Mixtures in Water
1996
Abstract Conductivity, density, heat capacity, enthalpy of dilution, and osmotic coefficient measurements of water–sodium dodecyl sulfate (NaDS)–sodium dodecanoate systems were carried out as functions of the surfactants total molality ( m t ) at different mole fractions ( X NaDS ). From conductivity data, the critical micelle concentration (cmc) and the degree of ionization of the micelles (β) were calculated. The cmc vs X NaDS profile deviates negatively from that predicted on the basis of the Clint approach, while the β vs X NaDS profile deviates positively from the line correlating the values for pure surfactants. At a given mole fraction, the profiles of all the investigated properties…
Solubility of NH3 and apparent pK of NH4+ in human plasma, isotonic salt solutions and water at 37 degrees C.
1998
The solubility of ammonia, alphaNH3 (mM/mmHg), was determined at 37 degrees C and low ammonia partial pressure (0.02-1 mmHg) in pure water (n =24) as 46.70+/-0.40; aqueous isotonic salt solutions (n = 7) as 46.8+/-0.81; and human plasma (n = 5) as 42.0+/-0.66. The last figure increases to 45.3+/-0.63 if expressed in molal units (mmol/kg plasma water x mmHg) instead of molarity with respect to the water content of the plasma (mean from four healthy and fasting donors: 0.908+0.005 kg H2O/kg plasma; mean density at 37 degrees C: 1.020+/-0.002 kg/l). In pure water, the solubility value is the mean of three different methods: (a) extrapolation of the salting-out effect of ammonia in aqueous NaOH…
LE IPERNATRIEMIE NELL’ANZIANO
2015
L’pernatremia è caratterizzata da un deficit di acqua corporea totale rispetto al sodio ed è definita da una concentrazione plasmatica superiore a 145 mmol/L. L’ipersodiemia nella popolazione geriatrica è un disturbo comune, associato ad una significativa morbilità e mortalità. Le persone anziane sono predisposte a sviluppare ipernatriemia a causa di modificazioni fisiologiche legate all'età: ad esempio la diminuzione della sete, una ridotta capacità di concentrazione delle urine e la diminuzione del contenuto di acqua corporea totale. I farmaci possono aumentare questa predisposizione. Nelle case di cura e di riposo, l’ipernatremia e la disidratazione sono considerate prevenibili, per cui …
The formal redox potential of the Yb(III,II) Couple at 0°C in 3.22 molal NaCl medium
2004
Following our previous investigations on aqueous solutions of hypooxidized and iperoxidized species, we managed, by lowering the temperature of the solutions to 0 degrees C, to obtain, by electrochemical methods, Yb(II) and Yb(III) mixtures, enough stable to determine by a potentiometric method the formal redox potential of the Yb(IlI, II) couple. Its value, in a large range of total Ytterbium concentration, is -1233 +/- 3 mV against the molal hydrogen electrode in the 3.22 m NaCl medium.
Reservoir characteristics of Mainz pouch studied in animal model
1993
In a canine model of the Mainz pouch, intracavitary pressure and compliance were measured during instillation of isosmotic and hyperosmotic (900 mmol/kg water) solutions of saline. Wall properties of small- and large-bowel segments of the pouch were assessed individually by sonomicrometry. Intraluminal pressures increased more steeply during filling with hyperosmotic solution, resulting in reduced distensibility of small- and large-bowel segments. Additionally, instillation of the hyperosmotic solution resulted in increased amplitudes and frequency of intracavitary pressure waves. The results indicate that this was the result of a combination of intensified bowel contractions and an increas…
Physicochemical Properties of Copper(II) Bis(2-ethylhexyl) Sulfosuccinate Reversed Micelles
1998
Abstract Measurements of some physicochemical properties (density, viscosity, conductance, UV–vis spectra, IR spectra) of the water/copper(II) bis(2-ethylhexyl) sulfosuccinate (Cu(DEHSS) 2 )/CCl 4 microemulsions, at a fixed surfactant molal concentration ([Cu (DEHSS) 2 ] = 0.05003 mol kg −1 ), as function of the molar ratio R ( R = [water]/[DEHSS − ]) have been performed at 25°C. Information on some structural and dynamical properties of the water-containing Cu(DEHSS) 2 reversed micelles and of their evolution with R are derived from the experimental results. The comparison with the same properties of water-containing sodium bis(2-ethylhexyl) sulfosuccinate reversed micelles allows to evide…