Search results for "NCT"
showing 10 items of 16712 documents
Preparation, Characterisation and Dielectric Properties of YBa2Cu3O7-δ/ Insulator-Heterostructures
1996
YBa 2 Cu 3 O 7-δ /insulator/Au-heterostructures on SrTiO 3 or LaAlO 3 substrates were prepared to study the properties of the materials SrTiO 3 , BaTiO 3 and Ceo 2 . X-ray diffraction measurements in Bragg-Brentano geometry show c-axis-oriented growth for the superconductor and the insulators SrTiO 3 and CeO 2 . Typical values for the rocking curve width of the different insulating films are between 0.4° and 0.8°. The highest breakdown fields are measured for the insulator SrTiO 3 with +37.5 kV/mm and -8.8 kV/mm. The permittivity for CeO 2 is independent of applied field and only weakly temperature dependent. This is in contrast to the perovskite type insulators, where the permittivity depe…
Electron transport and the effect of current annealing in a two-point contacted hBN/graphene/hBN heterostructure device
2020
In this work, we fabricated a 2D van der Waals heterostructure device in an inert nitrogen atmosphere by means of a dry transfer technique in order to obtain a clean and largely impurity free stack of hexagonal boron nitride (hBN)-encapsulated few-layer graphene. The heterostructure was contacted from the top with gold leads on two sides, and the device’s properties including intrinsic charge carrier density, mobility, and contact resistance were studied as a function of temperature from 4 K to 270 K. We show that the contact resistance of the device mainly originates from the metal/graphene interface, which contributes a significant part to the total resistance. We demonstrate that current…
An exact method for the determination of differential leakage factors in electrical machines with non-symmetrical windings
2016
An exact and simple method for the determination of differential leakage factors in polyphase ac electrical machines with non-symmetrical windings is presented in this paper. The method relies on the properties of Gorges polygons that are used to transform an infinite series expressing the differential leakage factor into a finite sum in order to significantly simplify the calculations. Some examples are shown and discussed in order to practically demonstrate the effectiveness of the proposed method.
Resistive communications based on neuristors
2017
Memristors are passive elements that allow us to store information using a single element per bit. However, this is not the only utility of the memristor. Considering the physical chemical structure of the element used, the memristor can function at the same time as memory and as a communication unit. This paper presents a new approach to the use of the memristor and develops the concept of resistive communication.
Electronic structure and magnetic order in Cu Zn(1−)O: A study GGA and GGA + U
2019
Abstract Based on density functional theory within GGA formalism, first-principles calculations were performed in order to study the structural, electronic, and magnetic properties of Cu-doped ZnO compound with dopant concentrations x = 0.028, 0.042, 0.056, and 0.125. It was found that CuxZn(1−x)O is ferromagnetic for both the closest and farthest impurity distances, but it is more stable energetically for the closest one. For all concentrations we obtained nearly half − metallic behavior. The calculations show that two substitutional Cu atoms introduce a magnetic moment of about 2.0 μB for all dopant concentrations. The results indicate that the magnetic ground state originates from the st…
Melting temperature prediction by thermoelastic instability: An ab initio modelling, for periclase (MgO)
2021
Abstract Melting temperature (TM) is a crucial physical property of solids and plays an important role for the characterization of materials, allowing us to understand their behavior at non-ambient conditions. The present investigation aims i) to provide a physically sound basis to the estimation of TM through a “critical temperature” (TC), which signals the onset of thermodynamic instability due to a change of the isothermal bulk modulus from positive to negative at a given PC-VC-TC point, such that (∂P/∂V)VC,TC = -(∂2F/∂V2) VC,TC = 0; ii) to discuss the case of periclase (MgO), for which accurate melting temperature observations as a function of pressure are available. Using first princip…
Ab initio calculations of the electronic structure for Mn2+-doped YAlO3 crystals
2020
The electronic structure of Mn2+ ion substituted for the host Y atom in orthorhombic bulk YAlO3 crystals has been calculated by means of hybrid exchange-correlation functional HSE within density functional theory. The supercell approach has been used to simulate in Pbnm YAlO3 crystal the point defects, Mn-dopant and compensated the F+ center (oxygen vacancy with one trapped electron), to make unit cell neutral. Large 2 × 2 × 2 supercells of 160 atoms allow us to simulate substitutional point defect with concentration of about 3%. Mn2+ ions substituting for host Y form covalent Mn–O bonds, in opposite to the mostly ionic Y–O bond. The F center inserted to compensate the Mn2+ dopant in YAlO3 …
Fabrication and characterization of low cost Cu 2 O/ZnO:Al solar cells for sustainable photovoltaics with earth abundant materials
2016
Abstract The low cost electrodeposition method was used to grow Cu2O thin films and experimentally determine the optimal absorber layer thickness. Raman scattering studies indicate the presence of solely crystalline Cu2O and SEM images show that the thin films consist of grains with a pyramidal shape. The influence of the thickness of the light absorbing Cu2O layer on the basic characteristic of the heterojunction and their properties have been investigated using reflectivity, current–voltage (J–V), capacitance–voltage (C–V) and the external quantum efficiency (EQE) measurements. The depletion layer, the charge collection length of the minority carrier, and reflectivity are the main factors…
Current Spreading Length and Injection Efficiency in ZnO/GaN-Based Light-Emitting Diodes
2019
We report on carrier injection features in light-emitting diodes (LEDs) based on nonintentionally doped-ZnO/p-GaN heterostructures. These LEDs consist of a ZnO layer grown by chemical-bath deposition (CBD) onto a p-GaN template without using any seed layer. The ZnO layer (~1- $\mu \text{m}$ thickness) consists of a dense collection of partially coalesced ZnO nanorods, organized in wurtzite phase with marked vertical orientation, whose density depends on the concentration of the solution during the CBD process. Due to the limited conductivity of the p-GaN layer, the recombination in the n-region is strongly dependent on the spreading length of the holes, ${L}_{h}$ , coming from the p-contact…
Influence of surface topography on depth profiles obtained by Rutherford backscattering spectrometry
2000
A method for determining correct depth profiles from samples with rough surfaces is presented. The method combines Rutherford backscattering spectrometry with atomic force microscopy. The topographical information obtained by atomic force microscopy is used to calculate the effect of the surface roughness on the backscattering spectrum. As an example, annealed Au/ZnSe heterostructures are studied. Gold grains were observed on the surfaces of the annealed samples. The annealing also caused diffusion of gold into the ZnSe. Backscattering spectra of the samples were measured with a 2 MeV 4He+ ion beam. A scanning nuclear microprobe was used to verify the results by measuring backscattering fro…