Search results for "Nanomechanic"
showing 10 items of 14 documents
Squeezing of Quantum Noise of Motion in a Micromechanical Resonator
2015
A pair of conjugate observables, such as the quadrature amplitudes of harmonic motion, have fundamental fluctuations which are bound by the Heisenberg uncertainty relation. However, in a squeezed quantum state, fluctuations of a quantity can be reduced below the standard quantum limit, at the cost of increased fluctuations of the conjugate variable. Here we prepare a nearly macroscopic moving body, realized as a micromechanical resonator, in a squeezed quantum state. We obtain squeezing of one quadrature amplitude $1.1 \pm 0.4$ dB below the standard quantum limit, thus achieving a long-standing goal of obtaining motional squeezing in a macroscopic object.
Mechanical properties of sol–gel derived SiO2 nanotubes
2014
The mechanical properties of thick-walled SiO2 nanotubes (NTs) prepared by a sol–gel method while using Ag nanowires (NWs) as templates were measured by using different methods. In situ scanning electron microscopy (SEM) cantilever beam bending tests were carried out by using a nanomanipulator equipped with a force sensor in order to investigate plasticity and flexural response of NTs. Nanoindentation and three point bending tests of NTs were performed by atomic force microscopy (AFM) under ambient conditions. Half-suspended and three-point bending tests were processed in the framework of linear elasticity theory. Finite element method simulations were used to extract Young’s modulus values…
A continuum damage model for functionalized graphene membranes based on atomistic simulations
2017
A continuum model for GO membranes is developed in this study. The model is built representing the membrane as a two-dimensional, heterogeneous, two-phase continuum and the constitutive behavior of each phase (graphitic or oxidized) is built based on DFTB simulations of representative patches. A hyper-elastic continuum model is employed for the graphene areas, while a continuum damage model is more adequate for representing the behavior of oxidized regions. A finite element implementation for GO membranes subjected to degradation and failure is then implemented and, to avoid localization instabilities and spurious mesh sensitivity, a simple crack band model is adopted. The developed impleme…
Optomechanical Two-Photon Hopping
2023
The hopping mechanism plays a key role in collective phenomena emerging in many-body physics. The ability to create and control systems that display this feature is important for next generation quantum technologies. Here we study two cavities separated by a vibrating two-sided perfect mirror and show that, within currently available experimental parameters, this system displays photon-pair hopping between the two electromagnetic resonators. In particular, the two-photon hopping is not due to tunneling, but rather to higher order resonant processes. Starting from the classical problem, where the vibrating mirror perfectly separates the two sides of the cavity, we quantize the system and the…
Nanotribological, nanomechanical and interfacial characterization of atomic layer deposited TiO2 on a silicon substrate
2015
Abstract For every coating it is critical that the coatings are sufficiently durable to withstand practical applications and that the films adhere well enough to the substrate. In this paper the nanotribological, nanomechanical and interfacial properties of 15–100 nm thick atomic layer deposited (ALD) TiO 2 coatings deposited at 110–300 °C were studied using a novel combination of nanoscratch and scanning nanowear testing. Thin film wear increased linearly with increasing scanning nanowear load. The film deposited at 300 °C was up to 58±11 %-points more wear-resistant compared to the films deposited at lower temperatures due to higher hardness and crystallinity of the film. Amorphous/nanocr…
State Preparation and Tomography of a Nanomechanical Resonator with Fast Light Pulses
2018
Pulsed optomechanical measurements enable squeezing, non-classical state creation and backaction-free sensing. We demonstrate pulsed measurement of a cryogenic nanomechanical resonator with record precision close to the quantum regime. We use these to prepare thermally squeezed and purified conditional mechanical states, and to perform full state tomography. These demonstrations exploit large photon-phonon coupling in a nanophotonic cavity to reach a single-pulse imprecision of 9 times the mechanical zero-point amplitude $x_\mathrm{zpf}$. We study the effect of other mechanical modes which limit the conditional state width to 58 $x_\mathrm{zpf}$, and show how decoherence causes the state to…
Geometric-phase backaction in a mesoscopic qubit-oscillator system
2012
We illustrate a reverse Von Neumann measurement scheme in which a geometric phase induced on a quantum harmonic oscillator is measured using a microscopic qubit as a probe. We show how such a phase, generated by a cyclic evolution in the phase space of the harmonic oscillator, can be kicked back on the qubit, which plays the role of a quantum interferometer. We also extend our study to finite-temperature dissipative Markovian dynamics and discuss potential implementations in micro- and nanomechanical devices coupled to an effective two-level system. © 2012 American Physical Society.
Cross-Kerr nonlinearity in optomechanical systems
2015
We consider the response of a nanomechanical resonator interacting with an electromagnetic cavity via a radiation pressure coupling and a cross-Kerr coupling. Using a mean field approach we solve the dynamics of the system, and show the different corrections coming from the radiation pressure and the cross-Kerr effect to the usually considered linearized dynamics.
Multiscale modeling of polycrystalline materials: A boundary element approach to material degradation and fracture
2015
Abstract In this work, a two-scale approach to degradation and failure in polycrystalline materials is proposed. The formulation involves the engineering component level (macro-scale) and the material grain level (micro-scale). The macro-continuum is modeled using a three-dimensional boundary element formulation in which the presence of damage is formulated through an initial stress approach to account for the local softening in the neighborhood of points experiencing degradation at the micro-scale. The microscopic degradation is explicitly modeled by associating Representative Volume Elements (RVEs) to relevant points of the macro continuum, for representing the polycrystalline microstruct…
Nanomechanical Properties of Epoxy Composites with Carbon Fillers
2013
The key point of this study is investigation of nanomechanical properties of epoxy-based nanocomposites filled with different kinds of carbon nanofillers like exfoliated graphite, high surface-area carbon black, single-walled carbon nanotubes and multi-walled carbon nanotubes