Search results for "O2"
showing 10 items of 1115 documents
Photoelectrochemical characterization of anatase-rutile mixed TiO2 nanosponges
2016
This work studies the influence of using hydrodynamic conditions during anodization on the morphology and electrochemical properties of anatase/rutile mixed TiO2 nanotubes (Reynolds number, Re = 0) and nanosponges (Re > 0). To this purpose different techniques were used, such as: microscopy techniques (Field-Emission Scanning Electron Microscope, FE-SEM, and Confocal Laser-Raman Spectroscopy), Electrochemical Impedance Spectroscopy (EIS), Mott Schottky (MS) analysis and photoelectrochemical water splitting tests. This investigation demonstrates that the morphology of TiO2 nanostructures may be greatly affected due to the hydrodynamic conditions and it can be adjusted in order to increase th…
Preparation and photoactivity of samarium loaded anatase, brookite and rutile catalysts
2011
Abstract Pure and samarium loaded anatase, brookite and rutile nanopowders were synthesized by thermohydrolysis of TiCl 4 . The samples were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), specific surface area (SSA) determination, UV–vis diffuse reflectance spectroscopy (DRS), atomic force microscopy (AFM), contact angle (CA) measurements and photoluminescence (PL) spectroscopy. The photocatalytic activity of pure and Sm-loaded TiO 2 polymorphs was investigated by employing the photodegradation of 4-nitrophenol as probe reaction in a liquid-solid system. Loading with Sm resulted in an improvement of the photoreactivity of the three TiO 2 polymorphs. The benefi…
Preparation and Characterization of Nanostructured Fe-TiO2 Thin Films Produced by Electrophoretic Deposition
2013
Fe-TiO2 thin films have been produced by a sol-electrophoretic deposition method on metallic Ti foil substrates. X-ray diffractograms and Raman spectra confirms the anatase structure of deposited and annealed Fe-TiO2 films. Obtained Fe-TiO2 thin films demonstrate photoactivity under visible light radiation due to the doping with Fe3+ ions. Open circuit potential results shows that increase of the film thickness and surface area improves the photoactivity of Fe-TiO2.
Effect of Reynolds number and lithium cation insertion on titanium anodization
2016
This work studies the influence of using hydrodynamic conditions (Reynolds number, Re = 0 to Re = 600) during Ti anodization and Li+ intercalation on anatase TiO2 nanotubes. The synthesized photocatalysts were characterized by using Field Emission Scanning Electron Microscope (FE-SEM), Raman Confocal Laser Microscopy, Electrochemical Impedance Spectroscopy (EIS), Mott-Schottky analysis (M-S), photoelectrochemical hydrogen production and resistance to photocorrosion tests. The obtained results showed that the conductivity of the NTs increases with Li+ intercalation and Re. The latter is due to the fact that the hydrodynamic conditions eliminate part of the initiation layer formed over the tu…
Effect of Reynolds number on TiO2 nanosponges doped with Li+ cations
2018
[EN] Anatase TiO2 nanosponges have been synthesized by anodization of Ti, and Li+ cations have been inserted in these nanostructures. The influence of hydrodynamic conditions (Reynolds number, Re = 0 to Re = 600) during anodization has been studied. Li-Doped TiO2 nanosponges were characterized by field emission scanning electron microscopy (FE-SEM), Raman confocal microscopy, electrochemical impedance spectroscopy (EIS) and Mott¿Schottky analysis (M¿S). The photoelectrochemical performance and resistance to photocorrosion were also measured. Li¿TiO2 nanosponges proved to be better photocatalysts for water splitting than Li¿TiO2 nanotubes. Moreover, the photoelectrochemical behavior of the L…
Symmetry and models of single-walled TiO2 nanotubes with rectangular morphology
2011
Abstract The formalism of line symmetry groups for one-periodic (1D) nanostructures with rotohelical symmetry has been applied for symmetry analysis of single-walled titania nanotubes (SW TiO2 NTs) formed by rolling up the stoichiometric two-periodic (2D) slabs of anatase structure. Either six- or twelve-layer (101) slabs have been cut from TiO2 crystal in a stable anatase phase. After structural optimization, the latter keeps the centered rectangular symmetry of initial slab slightly compressed along a direction coincided with large sides of elemental rectangles. We have considered two sets of SW TiO2 NTs with optimized six- and twelve-layer structures, which possess chiralities (−n, n) an…
Photocatalytic Selective Oxidation of 5-(Hydroxymethyl)-2-furaldehyde to 2,5-Furandicarbaldehyde in Water by Using Anatase, Rutile, and Brookite TiO2…
2013
5-(Hydroxymethyl)-2-furaldehyde (HMF) was selectively oxidized to 2,5-furandicarbaldehyde (FDC) in; aqueous medium by using home prepared (HP) anatase, rutile, and brookite TiO2 nanoparticles. HP samples were prepared via a sol-gel method by using TiCl4 as the TiO2 precursor. Commercial TiO2 catalysts were also used for, comparison. All samples were characterized by BET specific surface area, XRD, TGA, and SEM, and the reactivity results showed that HP catalysts are predominantly amorphous and give rise to selectivities toward FDC more than twice that of commercial and well crystallized catalysts.
Black carbon-doped TiO2 films: Synthesis, characterization and photocatalysis
2019
This research is funded by the European Social Fund according to the activity ‘Improvement of researchers’ qualification by implementing world-class R&D projects’ of Measure No. 09.3.3-LMT- K-712, project „Investigation of the application of TiO2 and ZnO for the visible light assisted photocatalytical disinfection of the biologically contaminated water“ (09.3.3-LMT-K-712-01-0175). The authors express gratitude for the S. Tuckute, M. Urbonavicius, G. Laukaitis and K. Bockute for their valuable input in current work. © 2019. This work is licensed under a CC BY-NC-ND 4.0 license.
Home-prepared anatase, rutile, and brookite TiO2 for selective photocatalytic oxidation of 4-methoxybenzyl alcohol in water: reactivity and ATR-FTIR …
2009
5th European Meeting on Solar Chemistry and Photocatalysis -- OCT 04-08, 2008 -- Palermo, ITALY
Study of phase composition, photocatalytic activity, and photoluminescence of TiO2 with Eu additive produced by the extraction-pyrolytic method
2021
The Institute of Solid State Physics, University of Latvia as the Center of Excellence has received funding from the H2020-WIDESPREAD-01-2016-2017-TeamingPhase2 under grant agreement No. 739508, project CAMART2. The work was also partially supported by the LZP grant 2020/2-0074. R. Burve has been supported by the project “Synthesis of nanostructured materials based on titanium dioxide and tin dioxide and investigation of their physicochemical properties” Nr. MP-2019/7, for strengthening scientific personnel capacity 2019/2020 at the Riga Technical University. Authors are grateful to Dr. K. Šmits for the microscopic measurements and SEM images.