Search results for "Optical"
showing 10 items of 7671 documents
Recovery Capabilities of Rateless Codes on Simulated Turbulent Terrestrial Free Space Optics Channel Model
2013
Free Space Optics (FSO) links are affected by several impairments: optical turbulence, scattering, absorption, and pointing. In particular, atmospheric optical turbulence generates optical power fluctuations at the receiver that can degrade communications with fading events, especially in high data rate links. Innovative solutions require an improvement of FSO link performances, together with testing models and appropriate channel codes. In this paper, we describe a high-resolution time-correlated channel model able to predict random temporal fluctuations of optical signal irradiance caused by optical turbulence. Concerning the same channel, we also report simulation results on the error mi…
Monolithic integration of GMR sensors for standard CMOS-IC current sensing
2017
Abstract In this work we report on the development of Giant Magnetoresistive (GMR) sensors for off-line current measurements in standard integrated circuits. An ASIC has been specifically designed and fabricated in the well-known AMS-0.35 μm CMOS technology, including the electronic circuitry for sensor interfacing. It implements an oscillating circuit performing a voltage-to-frequency conversion. Subsequently, a fully CMOS-compatible low temperature post-process has been applied for depositing the GMR sensing devices in a full-bridge configuration onto the buried current straps. Sensitivity and resolution of these sensors have been investigated achieving experimental results that show a de…
A new bi-faced log periodic printed antenna
2005
In this paper, a new design of a broadband planar printed antenna based on the academic log periodic antenna is presented. The antenna consists of a series of printed dipoles, distributed on both faces of the substrate. Some configurations are explored, with a different number of printed dipoles. These are designed, simulated, fabricated, and measured. The calculated and measured return losses and radiation patterns are presented. The utility of the proposed antenna associated with its frequency bandwidth is better than 80%. The measured absolute gain is 6.5 dBi, and the front-to-back ratio is around 8 dB. The presented antenna should find wide applications in wireless communication systems…
Load carrying capacity of RC compressed columns strengthened with steel angles and strips
2012
Abstract In this paper a comparison between the analytical expressions for the prediction of the load carrying capacity of strengthened reinforced concrete (RC) columns with steel angles and strips is made. Expressions examined consider: the strength contribution due to the confinement effects induced by transverse strips; the composite action due to steel angles and unconfined concrete core; the strength contribution due to the composite actions of angles and concrete core taking into account that steel angles are subjected to axial force and bending moment and concrete core is confined by transverse strips. Design rules given by recent codes for the design of the strengthened columns are …
Full-wave analysis of industrial microwave applicators: TM modes
2004
In this paper, full-wave analysis of the TE modes of an industrial cylindrical microwave applicator is presented. The dispersion characteristics and fields configurations are shown. These results are obtained by a numerical simulation based on the residue theory. The authors have obtained particular modes called loop modes, which have a complex propagation constant that describes a loop within the complex plane. © 2004 Wiley Periodicals, Inc. Microwave Opt Technol Lett 42: 46–50, 2004; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.20203
<title>Modeling of eddy current sensors</title>
2001
In this paper two models of eddy current sensor have been presented. They are base don a one- and multi-turn coil model. The results of computer simulations present a relation of eddy current density on nonferromagnetic conducting materials versus some parameters viz: a coil radius, frequency of excitation current and conductivity of material.© (2001) COPYRIGHT SPIE--The International Society for Optical Engineering. Downloading of the abstract is permitted for personal use only.
Corrections to “Multipactor Susceptibility Charts for Ridge and Multi-Ridge Waveguides” [Dec 12 3601-3607]
2014
The authors have detected an error in Section IV-A in the above paper (ibid., vol. 59, no. 12, pp. 3601-3607, Dec. 2012). The analyzed rectangular waveguide in the actual version of the article is the WR137, instead of the WR90. As a consequence, the corrections presented here have to be implemented.
Logical and pseudo-logical optical fibre networks based on two-state (binary) optical fibre sensors for industrial monitoring and control systems
2005
The possibilities of development of logical and pseudo-logical optical fibre networks for monitoring and control of equipment and industrial sites are presented. Such networks composed of simple binary attenuation and optical fibre communication lines may also be used as fast and reliable systems developing a final command signal - logical and/or pseudo-logical, depending or the architecture of network and the type of located sensors. They realise the process similar to standard electronic logical sets but use the optical signal directly on the monitored or controlled device. The analysis of serial and parallel networks was carried out in the "dark" mode detection. The examples of networks …
<title>Evolution of optical links toward full-optical transparency</title>
2003
In this paper we review issues of evolution of optical networks towards their full optical transparency and present sequence of eliminating non-transparent elements out of optical links (networks). Architectures of optical commutators with electrical and optical cores have been presented, as well as a structure of OMO (optical-millimeter wave-optical) switching fabric. An example of pure al-optical switch, made by Luxcore, utilizing dispersion compensating elements, wavelength converters and and variable optical attenuators (VOA) operating entirely in optical domain without optical-electrical-optical (OEO) conversions, was quoted. We brought up an issue of all-optical 3R signal regeneration…
Ultra-Wideband Radio Signals Distribution in FTTH Networks
2008
[EN] The use of an ultra-wideband (UWB) radio technique is proposed as a viable solution for the distribution of high-definition audio/video content in fiber-to-the-home (FTTH) networks. The approach suitability is demonstrated by the transmission of standards-based UWB signals at 1.25 Gb/s along different FTTH fiber links with 25 km up to 60 kin of standard single-mode fiber length in a laboratory experiment. Experimental results suggest that orthogonal frequency-division-multiplexed UWB signals exhibit better transmission performance in FFTH networks than impulse radio UWB signals.